KW Cages Show-N-Go User manual

Show- -Go
Drawing is representative of most models. Some variations between models may occur.
WARNING
Wire panels and sheetmetal parts may have sharp edges,
especially when handled as loose components. Use caution
when handling or performing cage assembly and maintenance.
Always wear gloves and safety eye-protection to help reduce
the chance of personal injury.
SKU (L x W x H) Comps.
8096 33” X 20” X 12” 6
Size

Show- -Go
Qty Description
1 Main Panel Sub Assembly
24 Door Guards
1 Partitions
1 Flooring
Layout and count all parts as shown in the assembly diagram. Notify Customer Service
immediately if any parts are missing or damage has occured during shipment.
Part List
Qty Description
1 Transport Tray
2 Pack of Cage Clips
4 Hardware (screw & nut)

Unfold main panel sub assembly
(A) so that each side panel meet
at the corners.
1Attach front, back and side pan-
els using cage clips (F) every
two inches.
2
3
Cage clip pliers are recommended for assembly.
Snap door guards (B) around
edges of door opening. Re-
peat steps for all size doors.
45
Insert pre-assembled partitions into
cage and secure using clips at every
slot.
Pre-assemble partitions (C)
using the included hardware (G).
Secure together using a screw-
driver and wrench.
Note: Bent tabs should face to
the right when viewing from the
hemmed side of large partition.

7
© 2019 Kagewerks, Inc.Form No. 909 - Rev. 5/19
Attach flooring (D) to cage, two inch up from
the bottom of side panels using cage clips
every two inches.
6
8Using spring hook, attach cage to secure the
tray during transport.
Position cage so that it sits inside tray (E) once ass-
sembly is completed.