KwikBoost M8 User manual

Position the Battery and press firmly until you hear the dual
lock fastener click.
1
The hole at the bottom of your charging station has 2 cords
coming out of it; a normal power cord and a DC OUT cord.
The DC OUT cord will provide power to the charging station
if charged properly.
4
Once you set up your battery pack, do not change the
voltage or any settings. The default voltage is 9 volts,
any other voltage is unsafe.
5
The Battery can be charged via the DC IN port and
connected to a normal wall outlet.
3
Assembly: Assembly Continued:
On the top of the battery, you will find 4 ports: 2 USB and 2
DC ports. DC IN is the port used for charging the battery. DC
OUT is the port used for powering the charging station.
2
M8 Battery
Kwik Start Guide
IMPORTANT: Make sure to plug the correct cable into the
correct cable into the correct port.
IMPORTANT: Phone/tablet charging only.
Not compatible with laptops.
Need more info?

After removing contents from box, attach baseplate to upright
using 3/8”-16 machine screws.
• When installing base plate, place the upright pole on a countertop
or elevated surface, then attach base.
1
Plug the power jack into the bottom of the technology box.
4
Now that the charger is assembled, it can be plugged in.
The power cable will plug into any standard wall outlet or
power strip.
5
Secure the charging unit to the mounting bracket with
#10 screws.
3
Hardware:
Assembly:
Installation Tips:
Suggested Tools:
Assembly Continued:
3/8”-16 Machine Screw
Qty. 2
#10 Screw
Qty. 2
2 Slide the charging unit down into the aluminum mounting bracket.
Phillips Screwdriver
2x
2x
NOTE: Make sure the square cutouts line up..
M8 Floor Stand
Kwik Start Guide
Need more info?
IMPORTANT: Phone/tablet charging only.
Not compatible with laptops.

Unplug power supply source to floorstand or wallmount station.
- Instructions may vary from wall mount to floorstand versions
1
Once removed place onto a flat surface remove the Phillips
head screws from the tech box. Set the screws down in a
safe place to prevent loss.
4
Remove old charging cables by unplugging them from the
USB ports on the circuit board, then sliding them through
the small slots in the billboard. Next, plug in your new
charging cables. Finally, reassemble the charging station in
reverse order of disassembly.
5
Unplug power jack from charging station. Unscrew
the security screws from the back of the floor stand.
2
Hardware:
Assembly:
Installation Tips:
Suggested Tools:
Slide the charging unit up from the metal mounting bracket
that is attached to the floor stand accessory.
3
Phillips Screwdriver
Replacement charging cables
TIP: Set the screws down in a safe spot to ensure
they're not lost.
Floorstand
M8 Station
Tech Box
M8 Cable Replacement
Kwik Start Guide
Need more info?
IMPORTANT: Phone/tablet charging only.
Not compatible with laptops.