KYMCO Xciting 500i Installation guide

TECHNICAL TRAINING MATERIALS
TECHNICAL TRAINING MATERIALS
Xciting
Xciting Series Series

P.1/51
Specification Xciting 500i

P.2/51
KEIHIN SYSTEM

P.3/51
XCITING 300i/500i FI PARTS LOCATION
CPS O2 sensor
ROLL Sensor
ECU---300i
※500i ECU is located under the front cover

P.4/51
ISC
IGNITION COIL INJECTOR TPS
FUEL PUMP AISV WTS MAP SENSOR

P.5/51
SELF-DIAGNOSTIC PROCEDURE
XCITING Check Engine Lamp
(CELP)
Turn the ignition switch
“ON” without start the
engine , The CELP lamp
will light for two second
then off. It shows the lamp
work normal.
PEOPLE S Check Engine Lamp
(CELP)

P.6/51
SELF-DIAGNOSIS CELP FAILURE CODES

P.7/51
DTC LIST FOR KEIHIN

P.8/51

P.9/51
FAILURE CODES CLEARED
1. Turn the key to the ON position and wait for ten seconds.
2. Fully open the throttle and wait for ten seconds.
3. Release the throttle.
4. The indicator will blink twice (0.5 second) quickly.
NOTE: The self-diagnosis could not be reset if there’s still trouble in Fi system.
Throttle
closed
KEY ON 10 s 10 s 5 s
Indicator blinks twice continuously
Throttle
closed
Throttle
opened fully