Labona V-LITE User manual

control of the inaccessible blind
CONTROL AND MAINTENANCE
MANUAL:
BLINDS FOR SKYLIGHTS
1. CONTROL
control of the accessible blind

solutions without chemical ingredients at a temperature of up to 30°C.
Do not use aggressive detergents, such as organic solvents, cleaning sand, cleaning pastes, developing steams and
strong alkali cleaning detergents.
NOTIFICATION:
Ensure careful cleaning of shading lamellas and textiles to prevent jamming or other damage.
Fabric with a steaming layer must not be cleaned with water – the layer can be damaged. When cleaning windows,
set the product into a position to prevent damage and any interference while cleaning. Protect the product against dirtying
during reconstruction and painting.
DESCRIPTION OF THE CONTROL USING THE KNOB:
The blind is lifted by drawing the lower bar of the blind. The blind is lowered by pressure on the lower bar and is lifted in an
upward direction. The lamellas are tilted using the knob – by turning to the left and the right.
The blind is controlled in difficult to access places using the bar where the end with the adapter is inserted into the hole in
the bar (lifting and lowering) or in the button (tilting of lamella).
Description of the control by using the slider:
The blind is lifted by drawing the lower bar of the blind. The blind is lowered by pressure on the lower bar and is lifted in an
upward direction. Tilt the lamellas using the slider located in the side leading bar of the blind by moving in the upward and
downward directions.
The blind is controlled in diff cult to access places using the bar where the end with the adapter is inserted into the hole in
the bar (lifting and lowering) or in the button (tilting of lamella).
2. MAINTENANCE
Manual setting
The product does not require any extraordinary maintenance or lubrication of control mechanisms.
In the case of dirtying (dust), regularly use a fi ne brush or a slightly adjusted manual vacuum cleaner.
During general cleaning, regularly wipe the surface with a cloth or a wet soft textile or sponge. Only use soap

In the case of a defect or mechanical damage to the product, prevent any further use.
NOTES:

If the product is not functional, contact the seller or the fIrm which assembled the product.

The display of the product may slightly differ from the actual version. The producer reserves the right to make changes.

After the termination of the service life, do not dispose of in communal waste. Materials used can be separated and
handed over in accordance with the valid regulations on waste and environmental protection.
Information on waste collection points can be obtained from the local administration office.
NOTIFICATION:
3. SAFETY INSTRUCTIONS
Important note
Pursuant to the EN 13 120 standard, we hereby call your attention to possible hazards
posed by the use of pull cords and chains!
Safety instructions / strangulation hazard:
 Young children have been strangled by loops in pull-cords, chains and tapes, and cords that operate the product.
 To avoid strangulation and entanglement, keep cords out of the reach of young children. Cords may become wrapped
around a child’s neck.
 Move beds, cots and furniture away from window covering cords.
Install the enclosed safety components to make sure cords do not twist and create a loop.

Do not use force when handling the product if any obstacle prevents its motion.

Do not attach any items to the product (particularly on the lamellas, control cords, nylon and draw bars).

Prevent mechanical stress and damage to the product.

For products controlled by cords, keep cords out of the reach of children to prevent entangling and jamming.

Handle the product carefully, especially during cleaning.