laerdal EXTRI KELLY Manual

EXTRI KELLY
Directions for Use

101-10001 Laerdal
2

Table of Contents
LaerdalRecommends 4
ItemsIncluded 5
Skill Taught 5
Head 5
ChestPlate 5
BellyPlate 5
Waist, Elbow, Knee & Ankle Joints 5
Arms 6
Legs 6
Care and Maintenance 7
Replacement Parts 8
101-10001 Laerdal
3

Extri Kelly (101-10001) is a full-body, lifelike manikin which
realistically simulates a patient. It is specifically designed for
training professionals in the practice of extrication.
As a result of quality manufacturing and the ease of
replacing individual parts, this trainer should provide many
sessions of training when reasonable care and maintenance
is practiced.
Laerdal Recommends:
When assembled, talcum powder should be used in joints
to assist articulation.
Instructor Notes:
101-10001 Laerdal
4

Item Included:
(1) Extri Kelly Manikin
(1) Laerdal Global Warranty Booklet
(1) Directions for Use
Skill Taught:
•Extrication
Head: Head is connected to torso by a long bolt at base of
neck, secured with a wing nut. Remove chest plate from
torso and unscrew wing nut. Head will slip out of torso.
Chest Plate: Chest plate fits into torso by a ledge on plate
and corresponding groove on torso cavity. Remove plate
by applying pressure to center of plate and working your
fingers under edge of plate and lifting out. To insert,
position plate over cavity and work edges into groove on
torso cavity.
Belly Plate: Belly plate fits into lower torso by a ledge on
plate and corresponding groove on abdominal cavity.
Remove plate by applying pressure to center of plate and
working your fingers under edge of plate and lifting out. To
insert, position plate over cavity and work edges into
groove on abdominal cavity.
Laerdal Recommends
When assembled, talcum powder should be used in
joints to assist articulation.
Waist, Elbow, Knee and Ankle Joints:
A bolt and lock nut connect these joints.
To remove: Laerdal Recommends
When assembled, talcum
powder should be used in
joints to assist articulation.
1. Unscrew lock nut.
2. Pull bolt out of joint.
The segments will now
easily disconnect.
101-10001 Laerdal
5

Arms: Arms are attached Laerdal Recommends
Attachment hardware is
located in envelope in box.
using a 4 ½ inches long bolt, three
washers, a spring and a wing nut.
To attach:
1. Remove chest plate from
manikin to locate hole in shoulder.
2. Remove deltoid injection pad from arm by squeezing
skin in center of pad while pulling
3. Slide washer over bolt.
4. Insert bolt through hole in arm and then through
hole in the manikin’s shoulder.
5. Slide one washer, a spring, a second washer and a
wing nut over bolt.
6. Use screwdriver to hold bolt steady while tightening
wing nut. (See Fig. 1)
To remove arms, reverse procedure.
Fig. 1
Legs: Legs are attached using a 6 inches long bolt, a
spring, a large washer, a small washer and a wing nut.
To attach:
1. Remove belly plate from manikin to locate hole in
hip.
2. Remove thigh injection pad from leg by squeezing
skin in center of pad while pulling.
3. Slide spring and small washer over bolt.
4. Insert bolt through hole in pelvis.
5. Slide large washer and wing nut over bolt.
6. Use a screwdriver to drive bolt into wing nut. (Fig. 2)
7.
101-10001 Laerdal
6

To remove legs, reverse procedure.
Fig. 2
Care and Maintenance:
1. Clean with mild soap and water; do not submerse
manikin or parts in cleaning fluids or water.
2. Use only on clean surface. Avoid felt tipped markers, ink
pens, acetone, iodine or other staining products and
avoid placing the manikin on newsprint or inked lines of
any kind.
3. To ensure longevity, each manikin and module should be
cleaned after each training session and a general
inspection should be conducted regularly.
4. Modules and all other parts should be drained and air-
dried thoroughly before storage and disinfected when
needed. After use of injection pads (use water only),
accumulated water should be squeezed out. Do not
store wet foam pads in the skin. To prevent mildew
or mold, pads can be soaked in a mild solution of
disinfectant and water or bleach and water. Squeeze
excess solution from pads, allow them to dry, then store
or reinsert in manikin.
5. Articulating parts will benefit from a light application of
talcum powder prior to training sessions.
6. Store properly between teaching sessions.
101-10001 Laerdal
7

Replacement Parts
Product Number: Description:
380460 Genitalia, Blank-Adult
Male
380471 Plug, Belly plate-Adult
380475 Pin, Pelvis
380600 Leg Assembly, Left
Adult
380650 Leg Assembly, Right
Adult
380800 Arm Assembly, Left
Plain Adult
380801 Hand, Left Adult Male
381401 Arm, Upper Right
Adult Male
381402 Pad Assembly, Deltoid
Injection Adult
101-10150 Belly plate, Plain
Hospital Adult
101-10250 Torso, Hospital Half
Cut Adult
101-10350 Pelvis, Hospital
W/Bridge Adult
101-10450 Hardware Set, Extri
Kelly Arms/Legs/Tools
300-00150 Pad Assembly, Thigh
Injection Adult
300-00250 Pad Assembly, Ventral
Gluteal Injection Adult
Male
300-00350 Pad Assembly, Gluteal
Injection Adult Male
300-02350 Forearm, Right Adult
Male
300-02450 Pad, Forearm Right
Non-Injection Adult Male
300-02550 Hand, Right Adult Male
300-02650 Arm, Upper Left Adult
Male
300-02750 Forearm, Left Adult
Male
300-02850 Pad, Forearm Left
Non-Injection Adult Male
300-02950 Thigh, Right Adult
101-10001 Laerdal
8

300-03050 Leg, Lower Right Adult
300-03150 Foot, Right Adult
300-03250 Thigh, Left Adult
300-03350 Leg, Lower Left Adult
300-03450 Foot, Left Adult
300-04850 Gown, Hospital-Back
Tie
300-05150 Right Arm Assembly
PlainAdult
300-10250 Chest plate, Hospital
Plain Adult Male
301-10150 Head Assembly, Hard
AdultMale
Please contact Customer Service Representatives for more
information on Replacement Parts in other skin tones.
101-10001 Laerdal
9

©Laerdal Medical, Gatesville TX. All rights reserved
1001604 rev C