Laird HDDA5W Series Instruction manual

HDDA5W-XX-XXX
4900-5875 MHz
29
<1.8:1
6°
6°
> 30
> 32
Dual Linear
100W per port
50 Ohms
See drawing
+5 / -30°
9.0 Kg
2x N-type Female
Polyurethane, gray
Fiberglass, gray
Tilt Mounng Kit for 50.0 mm
[2.0”] to 115.0 mm
[4.5”] Dia Mast
-40°C to +85°C
DC grounded
IP67
Compliant
Model
Frequency (MHz)
Gain (dBi)
VSWR
Beamwidth E Plane (Typ)
Beamwidth H Plane (Typ)
Port Isolaon (dB)
Front-to-Back Rao (dB)
Polarizaon
Maximum Input Power
@25°C
Input Impedance
Mechanical Size
Mechanical Tilt
Antenna Weight
Antenna Connector
Finish
Radome (oponal)
Pole Mounng Hardware
Temperature
Lightning Protecon
Ingress Protecon (feed)
RoHS Compliant
SPECIFICATIONS
HDDA5W-XX-XXX
4900-5875 MHz
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Please read all instrucons carefully before aempng
to install this product.
SAFETY
The antennas and all associated equipment should be installed in
accordance with all applicable local and naonal electrical code
guidelines to ensure safe operaon.
165-00278_AA
Americas: +1.847 839.6925
[e-mail]
Europe: +44.1628.858941
[e-mail]
Asia:
[e-mail]
Middle East and Africa: +44.1628.858941
IAS-MEA[email protected]
www.lairdtech.com
INSTALLATION
1. Assemble your new antenna on the ground at the installaon
site. Keep separate assembly instrucons that come with it. Large
CB and Ameteur beams may have to be nally assembled on the
lower or mast.
2. On the ground, clamp the antenna to mast and connect the
coaxial cable to the antenna.
3. Refer to manual 931525 included with the dish antenna for
proper mast installaon and safety precauons.
4. Install selected mounng bracket.
5. If you are going to use guy wire installaon instead of a
mounng bracket:
a. Install guy anchor bolts
b. Esmate length of guy wire and out
c. Aach a mast using guy ring

HDDA5W-XX-XXX
4900-5875 MHz
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
INSTALLATION Con’t
6. Carefully take antenna and mast assembly to mounng
bracket and insert. Tighten camp bolts. In case of guyed
installaon, it will be necessary to have at least a second person
to hold the mast upright while the guy wires are aached and
ghtened to the anchor bolts.
7. Install self-adhering ‘‘DANGER’’ label packaged in antenna
hardware kit at eye level on your mast.
8. Install ground rod to drain o stac electricity build-up and
connect ground wire to mast and ground rod. Use special
ground rods, not a spare piece of pipe.
165-00278_AA