
6
INSTRUCTIONS FOR USE
We recommend standing the appliance on a heatproof board or baking tray, to catch any
juices which may come out during cooking.
1. Plug into the socket and switch on. The POWER light
will illuminate when plugged in to show the Churro
Maker is switched on and heating up.
After a few minutes, the READY light will come on
and illuminate, to show the hotplates have heated up to
temperature and the appliance is ready to use.
Always ensure the READY light has come on, otherwise
your food may stick and not cook through properly.
The Churro Maker has one temperature setting. The READY light may go off for a
while as the appliance has lost heat whilst the batter has been added or the temperate
has changed. This is normal and will come back on once the appliance is back up to
temperature.
2. Lift the lid carefully by the lid handle and spray both the hotplates with a little spray
oil. You can also brush the hotplates with oil before or after switching on the
Churro Maker. If brushing oil onto the heated hotplates, use a heat resistant silicone
basting or pastry brush.Take care, the hotplates are hot and oil may spit.
3. Pipe your batter onto the lower hotplate in the four channels. The batter should be
level with the top of the raised parts.
4. Gently close the lid, ensuring the safety catch is in place. Do not slam the lid down as
it may cause the mixture to run off the hotplates.
5. Once your food is cooked to your preference, carefully remove the churros with a
heat resistant nylon or silicone cooking utensil.
6. Switch off and unplug the Churro Maker, allow it to cool completely before
cleaning and storing.
7. Cooking times will vary depending on the foods you are cooking, lift the lid and cook
for a couple more minutes if needed.
USING YOUR CHURRO MAKER
FOR THE FIRST TIME
• Unpack the Churro Maker, remove all the packaging materials.
• Wipe the hotplates with a damp soapy cloth, then wipe with a clean damp cloth and
dry thoroughly.
• When you switch on the Churro Maker for the rst time there may be a slight burning
smell. This is normal for a new product and will disappear after a few uses.
Ready
light
Power
light