Lamona LAM1005 User manual

sealing strip

11

Remove hob and apply adhesive seal inside and up to the marked line
* Note
Please cut hole accurately
Applying Sealing Strip
Place the hob into the aperture
Mark the perimeter of the hob with a pencil
_15

1_
User manual LAM1005
Elbow Installation
The pipework shall be Àtted in such a way that it
cannot come into contact with a moveable part of
the housing unit (e.g a drawer) and does not pass
through any space where it may become crushed or
kinked or damaged in any way.
To prevent any potential damage to the hob please
carry out installation carefully.
Tighten the joints with suitable spanner,
remembering to twist the pipes into position.
Attach hob Àttingsto the mains gas supply using a
rigid copper pipe or Áexible steel pipe.
IMPORTANT: Carry out a Ànal check for leaks on the
pipe connections using a soapy solution. NEVER
USE A FLAME. Also make sure that the pipework
cannot come into contact with a moving part of the
cabinet (e.g a drawer) and that is not situated where
it could be damaged.
WARNING: If gas can be smelt in the vicinity of this
appliance turn off the gas supply to the appliance
and call the engineer directly.
Do not search for a leak with a naked Áame.
Installation above a kitchen unit
with door & drawer
The panel installed below the hob must be easy to
remove and let an easy access in case a technical
assistance intervention is necessary.
30mm
Min 10mm
60mm
30mm
Min 10mm
60mm
Worktop
10mm
oven or partition
Hob
5mm

_ 17
table on P.20.
For some models a conic link is furnished
erehwseirtnuocehtninoitallatsniehtrof
this type of this link is obligatory: in the image
below it is pointed out how to recognise the
different links (CY= cylindrical, CO= conic). In
every case the cylindrical part of the link has to
be connected to the hob.
When connecting the hob to the gas supply via
use semi-rigid hoses please ensure that the
maximum distance covered by the hose does
not exceed two metres.
Cylindrical
Conical

18_

registered GAS SAFE installer who will comply
with all relevant gas, IEC and local regulations.
_ 19
Your hob is

20_
General
Gas Power 7kW
G 20/20 mbar (methane) 666 I / h
G 30/28-30 mbar (LPG) 509 g/h
Installation Class 3
Voltage/ Frequency V / Hz 220-240 V / 50Hz
Electrical Input Power 15W
Electric Ignition Yes
Product Dimension 585 x 510mm
Electrical Flex Size / Type 0.75mm2 3 Core H05V2V2
Gas Type G20
Gas Pressure 20 mbar
P (Kw) Ømm
Max (kW) Min (kW)
A1.00 0. 0.
SR 1.75 0. 
R2.50  1.
Gas type G30 / G3
Pressure Gas / LPG 28-30/37
P (Kw) Ømm
Max (kW) Min (kW)
A1.00 0. 0.50
SR 1.75 0. 0.65
R2.50  0.80