Landice 90 Series User manual

Part Number: 73210-8
L7/L8 Treadmill
90Series Owner’s Manual

Important Safety Instructions
2
Important Safety Instructions
Read all instructions before using the treadmill.
DANGER To reduce the risk of electric shock: always
unplug the treadmill from the electrical outlet
immediately after using and before cleaning.
WARNING To reduce the risk of burns, fire, electric shock or
injury to persons:
• An appliance should never be left unattended when
plugged in. Unplug from outlet when not in use, and
before putting on or taking off parts.
• Close supervision is necessary when the treadmill is
used by or near children or persons with disabilities.
• Use the treadmill only for its intended use as described
in this manual. Do not use attachments not
recommended by Landice.
• Never operate treadmill if it has a damaged cord or
plug, if it is not working properly, or if it has been
damaged. Call your dealer or certified service provider
immediately for examination and repair.
• Keep the power cord away from heated surfaces. Be
sure the cord has plenty of slack and cannot be
pinched under the treadmill when it elevates and de-
elevates.
• Never operate the treadmill with the motor cover air
openings blocked. Keep the air openings free of lint,
hair, dust, or debris.
• Do not drop or insert objects into any opening on the
treadmill. Be sure no objects are near or beneath the
treadbelt when you are using the treadmill.
• Do not use treadmill outdoors.
• Do not operate treadmill where aerosol (spray)
products are being used or where oxygen is being
administered.
• To disconnect, press STOP twice, pull the safety
lanyard out, then remove plug from outlet.

Important Safety Instructions
3
WARNING Failure to observe the following warning
statements can result in serious injury!
• Do not use this product without first consulting your
doctor if you suffer from any illness, condition, or
disability that affects your ability to run, walk or
exercise.
• Do not use this product without supervision present if
you are suffering from any illness, condition, or
disability which affects your ability to run, walk or
exercise. Failure to do so can result in serious injury
should you fall while the treadbelt is moving.
• Failure to leave ample clearance around the treadmill
could cause you to be trapped between the treadmill
and a wall if you fall, resulting in burns or other serious
injury from the moving treadbelt. Allow a minimum
clearance of 18 inches (46 cm) on each side of the
treadmill. Allow a minimum clearance of 6 feet (183
cm) at the rear of the treadmill.
• Never stand on the treadbelt when starting the
treadmill. A sudden start could cause you to lose your
balance. Always begin by placing your feet on the side
traction strips, straddling the treadbelt, before turning
the treadmill on.
• Always wear the safety lanyard clip securely on your
clothing while exercising. Failure to do so can result in
severe injuries should you accidentally fall while
exercising.
• Test the emergency stop safety lanyard regularly by
pulling on the cord and ensuring that the treadbelt
comes to a complete stop when key is pulled.
• Familiarize yourself with this manual. Be sure you
understand operation of the treadmill before use.
• Always follow basic safety precautions when using an
electrical appliance.

Grounding Instructions
4
Grounding Instructions
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electric current to
reduce the risk of electric shock. The treadmill is equipped with a cord
having an equipment grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and
ordinances.
• 120–Volt Treadmills
Treadmills marked 120 VAC are intended for use with a grounding plug
in a nominal 120-volt circuit. Ensure the treadmill power cord is
connected to an outlet having the same configuration as the plug. No
adapter should be used with 120 VAC treadmills.
• 200 – 250-Volt Treadmills
Treadmills marked 200-250 VAC are intended for use on a circuit
having a nominal rating greater than 120V and are factory-equipped
with a specific power cord and plug to permit connection to a proper
electrical circuit. Ensure the treadmill power cord is connected to an
outlet having the same configuration as the plug. No adapter should be
used with 200 – 250 VAC treadmills.
If the treadmill must be configured for use on a different type of
electrical circuit, qualified service personnel should make the proper
connection.
WARNING Connect treadmill to a properly grounded,
dedicated electrical outlet only. See the
following Grounding Instructions.
WARNING This product contains chemicals known to the
state of California to cause cancer and birth
defects or other reproductive harm.
DANGER Improper connection of the grounding connector
can result in a risk of electric shock. Check with a
qualified electrician/service technician if you are
in doubt as to whether the treadmill is properly
grounded. Do not modify the plug provided with
the treadmill–if it will not fit the outlet, have a
proper outlet installed by a qualified electrician.

Treadmill Quick Start Guide
5
Treadmill Quick Start Guide
Before you Start the Treadmill: Safety
Using the Control Panel
This manual covers Landice treadmills with Pro Sport, Cardio, or
Landice Achieve control panels. Quick start instructions for each
control panel are included. For detailed instructions, read the chapter
specific to your control panel:
• See “Pro Sports Treadmill Operation” on page 43
• See “Cardio Treadmill Operation” on page 53
• See “Landice Achieve Treadmill Operation” on page 69
WARNING The treadmill will not operate unless the yellow
emergency stop Safety Lanyard Block is pushed
in. During operation, pulling the safety lanyard
pulls the Safety Lanyard Block out, stopping the
treadmill. To help prevent injury, always clip the
Safety Lanyard Clip to your clothing while using
the treadmill, to stop the treadmill if you slip or fall
during your workout.
Lower Control Panel
Safety Lanyard Clip
Stop Button

Treadmill Quick Start Guide
6
Pro Sports Treadmill Console
See page 43 for complete instructions.
Cardio Treadmill Console
See page 53 for complete instructions.

Treadmill Quick Start Guide
7
Landice Achieve Treadmill Console
See page 69 for complete instructions.
.
A quick start guide for using the treadmill console controls is provided
in the following table. Except where noted, the controls are the same
for all 3 consoles.
Treadmill Controls: Quick Start Guide
To Start the Treadmill: Press START to power up treadmill. All displays
light and the treadbelt begins to move at 0.5 mph (0.8 km/hr in metric mode).
To Turn Off the Treadmill: Press STOP once to stop the treadbelt and put
the unit in pause mode. Press STOP twice to power down the treadmill. The
treadmill will shut off and all current statistical information will be cleared.
To Restart the Treadmill: Press START to power up the treadmill from
pause mode. All displays light and the treadbelt begins to move at 0.5 mph
(0.8 km/hr in metric mode). If you are in a program it will restart at the
paused speed.
To Change Treadbelt Speed:
Press and hold SPEED (+) to increase speed. Pressing for more than 2
seconds increases speed faster. Release (+) key when desired speed is
shown on SPEED display.
Press and hold SPEED (–) key to slow speed. Pressing for more than 2
seconds reduces speed more quickly. Release (–) key when desired speed
is shown on the SPEED display.

Treadmill Quick Start Guide
8
To Change Treadbelt Incline:
Press and hold INCLINE (+) key to increase incline. Pressing for more than
2 seconds raises incline faster. Release key when desired incline is shown
on INCLINE display.
Press and hold INCLINE (–) key to lower incline. Pressing for more than 2
seconds lowers incline faster. Release key when desired incline is shown on
INCLINE display.
Left and Right Arrows:
The left and right arrows move between the motivational screens.
EXPRESS KEYS
(Pro Sports, Cardio, and Landice Achieve Treadmills):
Using the EXPRESS keys causes rapid changes in speed and incline.
Press EXPRESS (1) INCLINE to see the incline shortcut screen, which lets
you rapidly change incline level.
Press EXPRESS (2) SPEED to view the speed shortcut screen, which lets
you rapidly change to a different speed.
Treadmill Controls: Quick Start Guide (Continued)

Treadmill Quick Start Guide
9
Switching English/Metric Display Units
The treadmill display shows English units (mph for speed, lb for
weight) by default. To change to metric units (kilometers per hour for
speed and kilograms for weight):
• Ensure the treadmill is plugged in and powered off.
• Pro Sports and Cardio: press and hold 3, 9 and START
simultaneously while the treadmill is off, then release all. Use
the + or - keys to move up and down the list and select Toggle
Units. Then press the START button to select setting. Press
STOP to save and exit.
• Landice Achieve: press START then hold 3 and 9
simultaneously during the boot-up screen, then release all.
Use the + or - keys to move up and down the list and select
Toggle Units. Then press START to select the setting.
Press STOP to save and exit.
Repeat the same steps to return the display to English units if desired.
Setting a Numeric Passcode “Lockout Mode”
The treadmills have a feature called “Lockout Mode.” This feature must
be enabled to allow the end-user to select a four-digit passcode to gain
access to the treadmill and prevent unauthorized persons from
operating the treadmill. Please follow the steps below for your control
panel to activate the passcode.
Pro Sports and Cardio: Enabling Lockout Mode
1. While the treadmill is off press 3,9 and START at the same time.
2. Use the "–" to scroll down to Toggle Lockout Mode
3. Press START to turn the lockout feature on or off.
4. Press ENTER to enable and set up a PIN code.
5. Enter a 4-digit PIN using the keypad.
6. Confirm your PIN by re-entering the number using the keypad. Treadmill
will then turn off.
*If you forget your pin code, please use master pin 9010.

Treadmill Quick Start Guide
10
Landice Achieve: Enabling Lockout Mode
1. Press START but don’t stand on the treadbelt!
2. Then press 3 and 9at the same time during the boot-up screen.
3. 3. Use the "–" to scroll down to Toggle Lockout Mode.
4. 4. Press START to turn the lockout feature on or off.
5. 5. Press ENTER to enable and set up a PIN code.
6. 6. Enter a 4-digit PIN* using the keypad.
7. 7. Confirm your PIN by re-entering the number using the keypad. Tread-
mill will then turn off.
*If you forget your PIN code, please use master pin 9010.