Lathem DWA Series Operating manual

Lathem Time Tech Tips
Tip SetDWA.pdf Page1 of 1
Tip: Setting the Time DWA Series
The following setting instructions refer to the display of the DWA, DWA18-1 and 4000DWA Series.
"Old Style" Keypad
EDAY
0SAT 7ON
SUN
18OFF
MON
29HD
TUE
3AMCLR
WED
4PM
MEM
CLR
THU
5WKCLK
FRI
6CKT*
"New Style" Keypad
SET
TIME SET DAY PGM SIGNALS
12/24 HR
DISPLAY SIGNAL OFF SIGNAL LENGTH
RESTART CLEAR SIGNAL NEXT SIGNAL
SUN MON TUE
WED THU FRI
SAT REV FWD
MANUAL
SIGNAL TEST BATT RUN
To set the time on an "Old Style" keypad:
!If you have a 4000DWA Series, wait until you here the clock "click", make
a sample registration and note the time
!Set the Time of Day by pressing
1. Current Day of Week
2. WK
3. AM or PM
4. Hour and Minutes (set the minutes one-minute ahead of the clock
time)
5. Wait until the clock "clicks" and press CLK
Example: To set the time to Monday, 9:30AM press:
MON
2WKAM930CLK
Note: A colon in the upper left area of display indicates PM
To set the time on a "New Style" keypad:
!If you have a 4000DWA Series, wait until you here the clock "click", make
a sample registration and note the time
!Set the Day of Week by pressing
1. SET DAY
2. Current Day of Week
3. RUN
!Set the Time of Day by pressing
1. SET TIME
2. Press FWD or REV to set the display one-minute ahead of the clock
time
3. Wait until the clock "clicks" and press RUN
Example: To set the Day of Week to Monday press:
SET
DAY MON RUN
Example: To set the Time of Day to 9:30AM press:
SET
TIME FWD RUN
Note: A colon in the upper left area of display indicates PM