LAVAZZA FLAVIA BARISTA User manual

ENG

ENG

ENG

ENG

HOT TANK CONTROL
Disabled (Tank Empty)
PRIME HOT WATER SYSTEM
Exit Menus
<Back
<Next
Disable>
Prime>
ESP HOTBLOCK CONTROL
Disable (Block Empty)
WATER HEATING
Exit Menus
<Back
<Next
Disable>
Prime>
ENG

ENG

ENG

Hot water
Espresso
Coffee
Large
Regular
Small
(press & hold)
Back
ENG
8a
5
8a
9a
5
7
8b 8b
4 4

ENG

Back
Next Zero
Interim
000345
Back
Next Start
Operator Password:
Set New Password
ENG

AUDITING YOUR BREWER
19
CONFIGURING ENERGY SAVING MODE
In order to conserve energy the brewer can be configured to switch to standby mode after a
specified time of inactivity. To configure the energy saving mode:
1. Enter Operator menu (push and hold bottom left and right buttons) (Ref. A, page 6).
2. Enter password (default password: press top right button 4 times) (Ref. B, page 6).
3. Press back / next to display the ‘standby timeout (mins)’ screen.
Edit>
Edit>
Standby Timeout
(Mins): 240
4. Set time period for brewer to enter standby in minutes by pressing Edit +/-.
5. Press Exit menus.
If brewer is inactive for the specified time it will enter standby mode. In this mode the heaters and
lights will be switched off and the display will be turned off. Pressing any button will re-active the
brewer.
DRAINING YOUR BREWER
Notice
Make sure brewer is turned off.
Draining is recommended before moving the brewer.
1. Remove filter pack drip tray and bin.
2. Remove bung. CAUTION – WATER MAY BE HOT.
3. Allow all water to drain out.
4. Replace bung fully.
5. Clip drain tube back into place.
<Back
Next
WATER HEATING
Exit Menus
TROUBLESHOOTING
20
The sophisticated design of your FLAVIA® brewer makes it very unlikely that anything will go
wrong. However, if faults do develop, you can resolve many of them yourself.
PROBLEM REASON SOLUTION
ENG

TROUBLESHOOTING TROUBLESHOOTING
ENG