LeapFrog TOUCH & LEARN WORLD MAP User manual

Instruction Manual
This manual contains important information. Please save it for future reference.
91-004138-000 US
TM

2
INTRODUCTION
Thank you for purchasing the Touch & Learn World Map™! Learn
about the world’s countries, natural wonders, landmarks, animals and
more with this colorful and interactive world map.
Explore Button World Racer Button
Animal Quest Button
Landmark Expedition Button
Off/Low/High
Volume Selector

3
INCLUDED IN THE PACKAGE
• Touch & Learn World Map™
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy, and should be discarded for your child’s
safety.
NOTE
Please save this Instruction Manual as it contains important
information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes, cordons et vis d’emballage. Ils
ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il
comporte des informations importantes.
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
Unlock the Packaging Locks

4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw and then open the battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from the toy
before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
NOTE
This product is in Try-Me mode in the packaging. After opening
the package, slide the Off/Low/High Volume Selector to the
Off position, then slide the Off/Low/High Volume Selector to
the On position. If the unit powers down while playing, please
install a new set of batteries.

6
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On, slide the Off/Low/
High Volume Selector to the Low or
High position. To turn the unit
Off, slide the Off/Low/High Volume
Selector to the Off position.
2. Interactive Touch Points
There are 200 interactive touch points
throughout the map. Find the words
and images with white borders, then
touch them to explore. Hear names
and fun facts about continents, oceans,
countries, animals, natural wonders,
landmarks and more. Touch the compass
rose and legend to learn about map elements.
3. Explore Button
While in this mode, press any of the
interactive touch points on the map to
explore different parts of the world.
4. World Racer Button
In this game mode, players listen for the
name of a country, then press the correct
country name touch point on the map.
Players have 60 seconds to locate as
many correct answers as they can.

7
5. Animal Quest Button
In this game mode, players listen to a
fun fact about an animal, then press
the correct animal touch point on
the map. Players are asked to find 5
different animals per game.
6. Landmark Expedition Button
In this game mode, players listen
to a fun fact about a landmark or
natural wonder, then press the correct
landmark or natural wonder touch
point on the map. Players are asked to
find 5 different landmarks or natural
wonders per game.
7. Automatic Shut-Off
To preserve battery life, the Touch & Learn World Map™
will automatically go into sleep mode after approximately
80 seconds without input. To turn the unit on again, press
any button.
NOTE
The Touch & Learn World Map™ can be used on a table,
on the floor or on the wall. For best results, however, we
recommend hanging the map on the wall. Leaning on the
map while it’s on the floor or table may trigger touch point
responses accidentally.
Mount the map to the wall using the keyhole hanger on the
back of the product. Do not place nails or tacks through the
map itself.
WARNING
Do not fold or bend map; this could damage the electronic
components in the map and prevent it from working properly.

8
Environmental Phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power Off and back On, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the
batteries.
4. Turn the unit back On. The unit should now be ready to use
again.
5. If the unit still does not work, install a new set of batteries.

9
Impact de l’environnement
Une défaillance de fonctionnement de l’appareil peut
survenir s’il est sujet à des interférences avec les fréquences
radioélectriques. Le fonctionnement normal de l’appareil devrait
reprendre avec l’arrêt des interférences. Si ce n’est pas le cas, il
peut s’avérer nécessaire d’éteindre et rallumer l’appareil ou de
retirer et réinstaller les piles. Dans l’éventualité peu probable
d’une décharge électrostatique, un mauvais fonctionnement
et une perte de mémoire de l’appareil peuvent se produire.
L’utilisateur doit alors retirer et réinstaller les piles pour
réinitialiser l’appareil.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-701-5327 in the U.S. and Canada, or email
[e-mail]. Creating and developing LeapFrog
products is accompanied by a responsibility that we take
very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products.
However, errors sometimes can occur. It is important for you
to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you
might have. A service representative will be happy to help you.

10
NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.

11
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: LeapFrog®
Model: 6157
Product Name: Touch & Learn World Map™
Responsible Party: LeapFrog Enterprises, Inc.
Address: 2200 Powell Street, Suite 500
Emeryville, CA 94608
Website: leapfrog.com

Visit our website for more
information about our products,
downloads, resources and more.
leapfrog.com
leapfrog.ca
Read our complete warranty policy online at
leapfrog.com/legal
LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2022 LeapFrog Enterprises, Inc.
All rights reserved.
IM-615700-000
Version:0