LeapFrog TOUCH & LEARN WORLD MAP User manual

Instruction Manual
This manual contains important information. Please save it for future reference.
91-004138-001 UK
TM
TM

2
TM
INTRODUCTION
Thank you for purchasing the Touch & Learn World Map™! Learn
about the world’s countries, natural wonders, landmarks, animals and
more with this colourful and interactive world map.
Explore Button World Racer Button
Animal Quest Button
Landmark Expedition Button
Off/Low/High
Volume Switch

3
INCLUDED IN THE PACKAGE
• Touch & Learn World Map™
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties, cords and packaging screws
are not part of this toy, and should be discarded for your child’s
safety.
NOTE
Please save this Instruction Manual as it contains important
information.
Rotate the packaging locks 90 degrees
anticlockwise
Pull out the packaging locks and discard.
Unlock the Packaging Locks

4
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver or a coin to loosen the screw and then open
the battery cover.
3. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries (if removable) from the toy
before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
NOTE
This product is in Try-Me mode in the packaging. After opening
the package, slide the Off/Low/High Volume Switch to the
Off position, then slide the Off/Low/High Volume Switch to
the On position. If the unit powers down while playing, please
install a new set of batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products
and batteries, or on their respective packaging,
indicates they must not be disposed of in domestic
waste as they contain substances that can be
damaging to the environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or
lead (Pb) set out in the Batteries and Accumulators
Regulation.
The solid bar indicates that the product was placed
on the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
LeapFrog®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points
near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

7
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On, slide the Off/Low/
High Volume Switch to the Low or
High position. To turn the unit Off,
slide the Off/Low/High Volume Switch
to the Off position.
2. Interactive Touch Points
There are 200 interactive touch points
throughout the map. Find the words
and images with white borders, then
touch them to explore. Hear names
and fun facts about continents, oceans,
countries, animals, natural wonders,
landmarks and more. Touch the compass
rose and legend to learn about map elements.
3. Explore Button
While in this mode, press any of the
interactive touch points on the map to
explore different parts of the world.
4. World Racer Button
In this game mode, players listen for the
name of a country, then press the correct
country name touch point on the map.
Players have 60 seconds to locate as
many correct answers as they can.
TM
TM
TM
TM

8
5. Animal Quest Button
In this game mode, players listen to a
fun fact about an animal, then press
the correct animal touch point on
the map. Players are asked to find 5
different animals per game.
6. Landmark Expedition Button
In this game mode, players listen
to a fun fact about a landmark or
natural wonder, then press the correct
landmark or natural wonder touch
point on the map. Players are asked to
find 5 different landmarks or natural
wonders per game.
7. Automatic Shut-Off
To preserve battery life, the Touch & Learn World Map™
will automatically go into sleep mode after approximately
80 seconds without input. To turn the unit on again, press
any button.
NOTE
The Touch & Learn World Map™ can be used on a table,
on the floor or on the wall. For best results, however, we
recommend hanging the map on the wall. Leaning on the
map while it’s on the floor or table may trigger touch point
responses accidentally.
Mount the map to the wall using the keyhole hanger on the
back of the product. Do not place nails or tacks through the
map itself.
WARNING
Do not fold or bend map; this could damage the electronic
components in the map and prevent it from working properly.
TM
TM

9
Environmental Phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power Off and back On, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Please turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the
batteries.
4. Turn the unit back On. The unit should now be ready to use
again.
5. If the unit still does not work, install a new set of batteries.

10
CONSUMER SERVICES
Creating and developing LeapFrog®products is
accompanied by a responsibility that we at LeapFrog®take
very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products.
However, errors sometimes can occur. It is important for you
to know that we stand behind our products and encourage
you to call our Consumer Services Department with any
problems and/or suggestions that you might have. A service
representative will be happy to help you.
UK Customers:
Phone: [phone] (from UK) or [phone] (outside UK)
Website: www.leapfrog.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.leapfrog.com.au
NZ Customers:
Phone: [phone]
Website: support.leapfrog.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at leapfrog.com/
warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –
CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer
guarantees apply to goods and services supplied by VTech
Electronics (Australia) Pty Limited. Please refer to
leapfrog.com/en-au/legal/warranty for further information.

LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2022 LeapFrog Enterprises, Inc.
All rights reserved.
IM-615703-003
Version:0
Visit our website for more
information about our products,
downloads, resources and more.
leapfrog.com