LeapFrog ABC Phonics Word Builder 6111 Assembly Instructions

91-003842-000 US
Parent’s Guide
This guide contains important information. Please keep it for future reference.

2
INTRODUCTION
Thank you for purchasing the ABC Phonics Word BuilderTM!
Learn letters and their sounds and blend those sounds into words with
this fun and interactive device. Play six learning games to explore 250+
words, letter sounds and spelling. Use the three activity cards to practice
vowel letters and consonant letters.
Power Button
Letter Select
Button
Activity Mode
Buttons
Sound Slider
Star Button
Contrast Button Volume Button
Handle
Activity Cards

3
INCLUDED IN THIS PACKAGE
• ABC Phonics Word BuilderTM
• 3 Double-sided Activity Cards
• Parent’s guide
WARNING
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties and packaging screws are not
part of this toy and should be discarded for your child’s safety.
NOTE
Please keep this parent’s guide as it contains important
information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous
les produits d’emballage tels que rubans adhésifs, feuilles de
plastique, attaches, étiquettes et vis d’emballage. Ils ne font
pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte
des informations importantes.
Rotate the packaging locks 90 degrees
counterclockwise.
Pull out the packaging locks and discard.
Unlock the Packaging Locks

4
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned Off.
2. Locate the battery cover located on the back of the unit and
use a screwdriver or coin to loosen the screw and open the
battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box.
5. Replace the battery cover and tighten the screw to secure.

5
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity ( + and - ).
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
MISE EN GARDE
• Utiliser des piles alcalines neuves pour des performances
maximales.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mélanger différents types de piles ou d’accumulateurs,
ne pas mélanger des piles ou des accumulateurs neufs avec
des usagés.
• Ne pas utiliser des piles ou des accumulateurs endommagés.
• Mettre en place les piles ou les accumulateurs en respectant
les polarités + et –.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur
en court-circuit (en reliant directement le + et le –).
• Enlever les piles ou les accumulateurs usagés du jouet.
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Ne les jeter ni au feu ni dans la nature.
• Ne pas tenter de recharger des piles non rechargeables.
• Enlever les accumulateurs du jouet pour les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.

6
PRODUCT FEATURES
1. Power Button
Press the Power Button to turn the toy on
and put the toy to sleep.
2. Sound Slider
Move the Sound Slider left or right to
interact with the objects on the screen.
3. Star Button
Press the Star Button to select letters and
interact with the objects on the screen.
4. Contrast Button
Press the Contrast Button to access the
contrast adjustment screen. Then,
• Move the Sound Slider left or right to
adjust the contrast setting.
• Press the Star Button to confirm the
contrast setting and exit the screen.

7
5. Volume Button
Press the Volume Button to access the
volume adjustment screen. Then,
• Move the Sound Slider left or right to
adjust the volume setting.
• Press the Star Button to confirm the
volume setting and exit the screen.
6. Letter Select Button
Press the Letter Select Button to access
the letter select screen. Then,
• Move the Sound Slider left or right to
scroll through the alphabet.
• Press the Star Button to select a
letter and play different activities
associated with that letter.
7. Activity Mode Buttons
Press any of the Activity Mode Buttons
to play one of six different learning
activities.
• Letters & Sounds
• Flash Cards
• Sound Blender
• Word Guess
• Letter Bounce
• Spot the Difference

8
8. Handle
The Handle can be used to carry the
device and to store the three Activity
Cards.
• To store the Activity Cards, detach
the Handle from the back of the
device.
• Slide the Handle through the loops
on the Activity Cards.
• Reattach the Handle to the back of the device.
9. Activity Cards
The three double-sided Activity Cards
can be inserted into the device to
instantly access specific learning
activities.
• Aa – Vowel letter A curriculum
• Ee – Vowel letter E curriculum
• Ii – Vowel letter I curriculum
• Oo – Vowel letter O curriculum
• Uu – Vowel letter U curriculum
• XYZ – Consonant letters curriculum
Remove the Activity Card from the device to access the
Power Button, the Letter Select Button, and the six Activity
Mode Buttons.
10. Automatic Shut-Off
To preserve battery life, ABC Phonics Word BuilderTM will
automatically shut off after approximately 45 seconds to
one minute without input. To turn the unit on again, press
the Power Button, insert an Activity Card into the device,
or remove an Activity Card from the device.

9
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions,
please follow these steps:
1. Press the Power Button to put the toy to sleep.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit back On.The unit should now be ready to use
again.
5. If the unit still does not work, install a new set of batteries.
NOTE
If the unit powers down or the low battery image appears,
please install a new set of batteries.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from direct
heat sources.
3. Remove the batteries if the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to moisture or water.

10
Impact de l’environnement
Une défaillance de fonctionnement de l’appareil peut
survenir s’il est sujet à des interférences avec les fréquences
radioélectriques. Le fonctionnement normal de l’appareil devrait
reprendre avec l’arrêt des interférences. Si ce n’est pas le cas, il
peut s’avérer nécessaire d’éteindre et rallumer l’appareil ou de
retirer et réinstaller les piles. Dans l’éventualité peu probable
d’une décharge électrostatique, un mauvais fonctionnement
et une perte de mémoire de l’appareil peuvent se produire.
L’utilisateur doit alors retirer et réinstaller les piles pour
réinitialiser l’appareil.
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-701-5327 in the U.S. or email support@
leapfrog.com. Creating and developing LeapFrog®products
is accompanied by a responsibility that we take very
seriously. We make every effort to ensure the accuracy of the
information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know
that we stand behind our products and encourage you to
contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.
Environmental phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power OFF and back ON, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.

11
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
NOTE
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help

12
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: LeapFrog®
Model: 6111
Product Name: ABC Phonics Word BuilderTM
Responsible Party: LeapFrog Enterprises, Inc.
Address: 6401 Hollis Street, Suite 100
Emeryville, CA 94608
Website: leapfrog.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE
RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)

91-003842-000 US
Visit our website for more
information about our products,
downloads, resources and more.
leapfrog.com
Read our complete warranty policy online at
leapfrog.com/warranty.
LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2020 LeapFrog Enterprises, Inc.
All rights reserved.
Printed in China.