LeapFrog On-the-Go Story Pal Assembly Instructions

Parent’s Guide
This guide contains important information. Please keep it for future reference.
91-003934-009 UK

2
INTRODUCTION
Thank you for purchasing the On-the-Go Story Pal™ device!
Get ready to enter a magical world of storytelling, music
and learning!
Back Button
Micro USB
(cable not
included)
Microphone
Speaker
Off
On/Off/Mode
Selector Dial
Stories and
Poems
Songs
LED Screen
Play/Pause
Button
Headphone Jack
(headphones not
included)
Recorded Story
Star Button
Next Button Volume Control
Sleepy Time Lullabies
Battery Door
Hand Strap

3
INCLUDED IN THIS PACKAGE
• On-the-Go Story Pal™ device
• Parent’s guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy and should be discarded for your child’s safety.
NOTE:
Please keep this parent’s guide as it contains
important information.
This toy is only to be connected to equipment bearing either the
following symbols: or .
Unlock the Packaging Locks
Rotate the packaging locks 90
degrees anticlockwise.
Pull out the packaging locks
and discard.

4
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use a screwdriver
to loosen the screw.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 3 new ‘AA’ (AM-3/LR6)
batteries following the diagram
inside the battery box. For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

5
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or
lead (Pb) set out in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed
on the market after 13th August, 2005.
Help protect the environment by disposing of your
product or batteries responsibly.
LeapFrog®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points
near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.
Note: Maximum output voltage ≤150mV.

6
ACTIVATE NORMAL PLAY MODE
This product is in Try-Me mode in the packaging. To activate
normal play mode, please complete the following steps:
1. Rotate the On/Off/Mode Selector Dial
to the Off position.
2. Rotate the On/Off/Mode Selector Dial to
the Stories position to activate normal
play mode.
PRODUCT FEATURES
1. On/Off/Mode Selector Dial
Rotate the On/O/Mode Selector Dial
to choose a category. Categories include:
Stories and Poems; Songs; Sleepy Time
Lullabies and Recorded Story.
Rotate the On/O/Mode Selector Dial
to the O position to turn the toy off.
2. Play/Pause Button
Press to pause the story, song or poem.
Press again to play.

7
3. Back Button
Press to select the previous story, song
or poem.
4. Next Button
Press to select the next story, song
or poem.
5. Star Button
In the Recorded Story mode, follow the
audio instructions and press the Star
Button to begin recording.
In other modes, quickly press the Star
Button to hear your playlist. To save a
story/music to the playlist, press and
hold the Star Button until it beeps.
6. Volume Control
Turn the dial up or down to adjust the
volume level.
7. USB Port
To download additional stories, follow
the instructions in the Downloadable
Content section later in this guide.

8
8. Set Timer
Press and hold the Play/Pause Button for 5 seconds, then
follow the audio instructions to set the timer.
9. Automatic Shut-Off
To preserve battery life, the On-the-Go Story Pal™ will
automatically shut off after approximately 60 seconds if a
story or song is not playing. The unit can be turned on by
pressing any button.
ACTIVITIES
Listen to a Story, Poem or Song
Rotate the On/O/Mode Selector Dial to choose a category.
After selecting a category, press the Next Button to toggle
through the story options. Stories will play automatically after
their titles are announced.
Stories & Poems
1. The Three Little Pigs
2. Cinderella
3. Little Red Riding Hood
4. Peter Pan
5. The Tale of Peter Rabbit
6. The Gingerbread Man
7. Goldilocks and the Three Bears
8. The Three Billy Goats Gruff
9. Robin Hood and the Golden Arrow
10. The Boy Who Cried Wolf
11. The Ugly Duckling
12. Chicken Little
13. The Elves and the Shoe Maker
14. The Emperor’s New Clothes
15. Jacob & the Wise Man

9
Songs
1. Counting 1 to 10
2. All The Colours Of The Rainbow
3. The Days of the Week
4. London Bridge is Falling Down
5. Old MacDonald Had a Farm
Sleepy Time Lullabies
1. Hush Little Baby
2. Frère Jacques
3. Brahm’s Lullaby
4. Ocean Waves - Music of the Sea
5. Rainfall in Forest
6. Animals Round the World Go to Sleep at Night
7. It’s Bedtime Solar System
8. Humpty Dumpty
9. Ocean Dreams
10. Moonlight Music Meditation
Recorded Story
The toy is capable of recording five stories. Maximum recording
time is 10 minutes per story.
Timer
Use the arrows to choose how many stories, songs, lullabies to
play before your device goes to sleep.
Playlist
Choose your top five stories, songs, poems or lullabies to listen
to in your playlist.
To Add an Item to Your Playlist
1. Use the On/Off/Mode Selector Dial to choose a category.
2. Use the Next/Back Buttons to navigate to a story or song.
3. Press and hold the Star Button for three seconds to add
the item to your playlist.
4. Audio will confirm when the item has been added.

10
To Delete an Item From Your Playlist
1. Use the On/Off/Mode Selector Dial to choose a category.
2. Use the Next/Back Buttons to navigate to a story or song
in your playlist.
3. Press and hold the Star Button for three seconds to delete
the item from your playlist.
4. Audio will confirm when the item has been deleted.
To Listen to Your Playlist
1. Quickly press the Star Button to enter your playlist.
2. Your playlist will automatically begin playing after a
few seconds, or use the arrow buttons to navigate to a
particular story in your playlist.
Note: To preserve battery life, you may want to limit the amount
of stories in your playlist to three or less.
Downloadable Content
Download additional stories, songs and poems using your
computer and add them to your On-the-Go Story Pal™ device.
1. Power Up and Connect
Locate the On/O/Mode Selector Dial on the back of your
On-the-Go Story Pal™ device and rotate it to the Stories
category. Then, connect the device to your computer using
a micro USB cable (micro USB cable not included).
2. Set Up
Install the LeapFrog®Connect application for the On-the-Go
Story Pal™ device onto your PC or Mac computer
from leapfrog.com/connect
3. Download
Follow the on-screen instructions to install additional
content.
4. Play and Learn!
Eject the On-the-Go Story Pal™ device and your child is
ready to play!
Warning: Do not power off the device or disconnect the
micro USB cable while the device is being updated.