Leggett & Platt Air Dream User manual

Inflating and Deflating
Instructions
Your Air Dream™ comes equipped with a U.L.
approved electric inflation pump. This pump
plugs into a standard 110v household outlet.
Position your sleep sofa so that accessing an
electrical outlet is convenient.
To inflate mattress:
1. Remove valve cap by simply turning cap counter clockwise.
2. After Cap is removed insert pump motor and turn clockwise until pump is
engaged. Allow pump to inflate for 25 seconds. Remove pump and replace
valve cap. (A motor pitch change occurs when mattress is full).
3. Replace valve cap after inflation and seal valve by turning clockwise.
Patent Pending
To deflate mattress:
Completely deflate.
1. Open deflation valve by lifting valve latch
(Allow mattress to deflate before folding mechanism.)
2. Swing valve to closed position (do not lock) air trapped in mattress by locking valve
could cause damage. Do not lock valve while mattress is folded
DO NOT CLOSE DEFLATION VALVE
WHEN CLOSING THE SLEEPER MECHANISM.

Replacement Valve
Instructions
1. Open deflation valve by lifting up on valve tab.
2. Remove old valve by lifting the black plastic on the outer edge of the valve
toward the center. The valve will then lift off. Now you are ready to install
the replacement valve.
3. To install your new valve, first open the replacement. Once open, seat the
hinge area on to the hinge support, then squeeze the vinyl towards the
center of the mattress opening. Simply feed the vinyl through the opening
of the new valve. Once this has been accomplished make sure there are
no bulges in the vinyl. Use your thumb to make sure that it is smooth.
Next, lock your replacement shut and you are back in business.
Patent Pending
lp_3m_8-03