Leggett & Platt INST-A-MATIC User manual

SIDE RAIL
Figure 1
style frames.)
& no-headboard
ARM END CAP
(For headboard-only
CROSS
(For 6-legged
frames only.)
SUPPORT
Figure 3
SIDE RAIL
CROSS
SPRING CLIP
SIDE RAIL
CROSS ARM
SIDE RAIL
CENTER
SUPPORT
CROSS ARM
CENTER LEG
CENTER LEG
(For 5-legged
frames only.)
Notch
ROUND LEG
PLASTIC INSERT
EXTENSION
Figure 4
GLIDE
GLIDE BASE
GLIDE
EXTENSION
BASE
Notch
Figure 5
GLIDE
LEG
ASSEMBLY INSTRUCTIONS
INST-A-MATIC
Figure 2
bolt be cut after attachment. See Figure 7.
WARNING: When attaching this frame to a headboard
with narrow posts, it is recommended that any excess Figure 7
OFF
CUT
Figure 6
ROLLER
DATE
DO NOT SCALE DRAWING SHEET 1 OF 1
99300859
DWG. NO.
11-8-05
Step 1
Assemble CROSS ARMS to SIDE RAILS as shown in Figure 1.
Step 2 For headboard-only and no-headboard style frames:
Slide END CAPS onto SIDE RAILS. Warning: End caps must be placed over ends of
side rails to avoid serious injury.
Step 3 For 6-legged frames:
Make sure CENTER LEG is positioned toward the middle of the bed as shown in Figure 2
and slide CENTER SUPPORT in place.
Step 4 For 5-legged frames:
Align one end of the CROSS SUPPORT with the slot in the center of one of the SIDE
RAILS. Make sure that the SPRING CLIP snaps in place. Swing other end of CROSS
SUPPORT until SPRING CLIP locks in place as detailed in Figure 3.
Step 5 For frames with round center legs:
Tap PLASTIC INSERT into ROUND LEG. Snap GLIDE BASE onto GLIDE EXTENSION.
Tap glide assembly into PLASTIC INSERT. See Figure 4.
Step 6 For frames with glides:
Snap GLIDE BASE onto GLIDE EXTENSION. Install glide assembly as shown in Figure
5, making sure that the LEG fits into the notch on top of glide.
Step 7 For frames with rollers:
Install rollers as shown in Figure 6. Locking rollers, if provided should be placed on the
corners at the foot of the bed.

Figure 1
GL10 ASSEMBLY INSTRUCTIONS
For Inst-A-Matic Bedframes:
For standard bedframes:
Insert stem of GLIDE EXTENSION into leg of
bedframe and place BASE onto GLIDE EXTENSION
as shown in Figure 1.
Make sure that the notch of the GLIDE EXTENSION
is turned so that the leg of the bedframe is properly
inserted as detailed in Figure 2.
Tap PLASTIC INSERT into leg of bedframe.
Insert stem of GLIDE EXTENSION into
PLASTIC INSERT and place BASE onto
GLIDE EXTENSION. See Figure 3.
GLIDE
EXTENSION
BASE
Step 1:
Step 2:
Step 1:
Figure 2
Notch
Figure 3
PLASTIC
INSERT
GLIDE
EXTENSION
BASE
DATE
DO NOT SCALE DRAWING SHEET 1 OF 1
99300690
DWG. NO.
8-7-02