LEGRAND Arteor Series User manual

N 292375/02
5722 63 / 5727 63
Arteor
TM
®
U230V~ 50/60Hz
P0,35W
16A 250V AC µ cos ϕ= 1
+
-- 10°C … +70°C
0°C … +40°C temporary,
7°C … 40°C
∆ K±2K
1,5…4mm2 1,5…2,5mm2
20m
IP 30
Safety notes
This product should preferably be installed by a qualified electrician. Non-compliance may result in a fire hazard or electric shocks.
Before installation, read the operating instructions and observe the product-specific requirements for the installation location. Use only original
spare parts for repair and maintenance. All Legrand products may be opened and repaired only by specially trained Legrand personnel. Unauthorised opening and repair
by other persons will invalidate all claims for liability, replacement or warranty services.
!
GB IE
SA
•The load has to be connected to the same phase as the thermostat (L).
!
0,35
16
4…1,5 2,5…1,5 6
Operating principle, Type 1-B. EN 60 730-1
Degree of contamination: 2
Rated impulse voltage: 4 kV
•
N L
230V~
50/60 Hz
ϑ
N
L
ϑ
+50
+25
+30
+7
°C Off
Max.
Min.
Max. 25°C…50°C
Min. 7°C…30°C
!
CN
•
CN
SA
0

40mm min.
1
2
3
1
0
1
5
1
9
2
1
2
5
3
0
3
5
4
0
•Automatic temperature control conforming to
thermostat setting is active.
•OFF
On
Off
On
Off
•The relay is switched off if the sensor is defective or not connected and an external temperature limit is set. (LED On/Off flashes)
•The external sensor is used to limit the temperature within the fl oor.
If a minimum-limit is chosen, the thermostat switches the relay on as
soon as the temperature drops below the limit.
With a maximum-limit the relay is switched off, if the measured external
temperature is higher than the limit.
Off = Factory setting. No limit chosen.
•The relay is complety switched off.
No autofreeze protection active.
•
•
•
•
+50
+25
+30
+7
°C Off
Max.
Min.
40
•
•
•