LevelOne FCS-5061 User manual

FCS-5061
Day/Night 5-Megapixel PoE Plus
Outdoor
Network Camera
User
Manual
Ver1.0

Table of Contents
1. Overview......................................................................................................................................5
1.1 Features......................................................................................................................5
1.2 PackageContents .......................................................................................................6
1.3 Dimensions..................................................................................................................7
1.4 Connectors..................................................................................................................8
2. Camera Cabling.........................................................................................................................10
2.1 Connect Power..........................................................................................................10
2.2 Connect Ethernet Cable ............................................................................................11
2.3 Connect Alarm I/O.....................................................................................................11
3. Installation .................................................................................................................................12
3.1 Ceiling/Wall Mounting ................................................................................................12
4. System Requirements................................................................................................................13
5. Accessing Camera.....................................................................................................................14
5.1 Using Recording Software.........................................................................................18
5.2 Installing DC Viewer Software Online.........................................................................19
6. Configuration & Operation .........................................................................................................21
6.1 Browser-basedViewer Introduction............................................................................21
6.2 Home Page................................................................................................................23
6.3 System Related Settings............................................................................................25
6.3.1 Host Name and System Time Setting .......................................................................26
6.3.2 Security ....................................................................................................................27
6.3.2.1 User...........................................................................................................................28
6.3.2.2 HTTPS.......................................................................................................................30
6.3.2.3 IP Filter......................................................................................................................32
6.3.2.4 IEEE 802.1X..............................................................................................................33
6.3.3 Network....................................................................................................................35
6.3.3.1 Basic .........................................................................................................................36
6.3.3.2 QoS...........................................................................................................................39
6.3.3.3 SNMP........................................................................................................................41
6.3.3.4 UPnP.........................................................................................................................43
6.3.4 DDNS.......................................................................................................................45
6.3.5 Mail...........................................................................................................................46
6.3.6 FTP ..........................................................................................................................47
6.3.7 HTTP........................................................................................................................48
5.3.8 Application................................................................................................................49

6.3.9 Motion Detection.......................................................................................................50
6.3.10 Network Failure Detection..........................................................................................56
6.3.11 Tampering .................................................................................................................58
6.3.12 Storage Management (Local Recording) ...................................................................61
6.3.13 Recording (Local Recording).....................................................................................63
6.3.14 File Location (Snapshots and Web Recording)..........................................................64
6.3.15 View Information........................................................................................................65
6.3.15.1 Log File......................................................................................................................66
6.3.15.2 User Information.......................................................................................................67
6.3.15.3 Parameters................................................................................................................68
6.3.16 Factory Default..........................................................................................................69
6.3.17 Software Version.......................................................................................................70
6.3.18 Software Upgrade......................................................................................................71
6.3.19 Maintenance..............................................................................................................73
6.4 Streaming..................................................................................................................75
6.4.1 Video Resolution and Rotate Type............................................................................76
6.4.2 Video Compression ..................................................................................................78
6.4.3 Video ROI.................................................................................................................79
6.4.4 Video OCX Protocol..................................................................................................81
6.4.5 Video Frame Rate.....................................................................................................82
6.4.6 Video Mask ...............................................................................................................83
6.4.7 Audio (Audio Mode and Bit Rate Settings)................................................................84
6.5 Camera Settings.......................................................................................................86
6.5.1 Exposure Setting ......................................................................................................87
6.5.2 White Balance
Setting ...............................................................................................88
6.5.3 Brightness
Setting .....................................................................................................89
6.5.4 Backlight...................................................................................................................90
6.5.5 Digital Zoom .............................................................................................................90
6.5.6 IR Function...............................................................................................................90
6.5.7 WDR Function..........................................................................................................91
6.5.8 Noise Reduction.......................................................................................................91
6.5.9 TV System Setup......................................................................................................92
6.6 Logout ......................................................................................................................92
Appendix A: Technical Specifications................................................................................................93
Appendix B: Internet Security Settings..............................................................................................95
Appendix C: DC Viewer Download Procedure ..................................................................................98
Appendix D: Install UPnP Components...........................................................................................100

Default ID /
Password
Login ID Password
root

1. Overview
Levelone FCS-5061 Day/Night 5-Megapixel PoE Plus Outdoor Camera is
designed for flexible surveillance installation under the most demanding weather
conditions. This camera is installation ready with an IP66-rated weather proof and
vandal proof outdoor enclosure, built-in heater and IR LEDs for -40°C to 50°C
harsh environments 24 hours surveillance. No need to install this camera near a
power source, power and data are received through a single Ethernet cable using
Power over Ethernet (PoE) technology.
With built-in 3DNR (3-Dimension Noise Reduction) and WDR (Wide Dynamic
Range) technology, the camera is able to filter the intense backlight surrounding a
subject and remove noises from video signal. The result is that an extremely clear
and exquisite picture quality can be produced even under any challenging lighting
conditions.
1.1 Features
Progressive Scan CMOS Sensor
Quad Streams support
Dual Streams, Full HD 1080P real-time + D1 real-time
Quad Streams Compression: H.264 Baseline / Main / High Profile + MJPEG
Multi-language support
Tampering Alarm
Wide Dynamic Range
Motion Detection
Privacy Masks
3D Noise Reduction
Vertical View Mode (Image rotation by 90 derees)
Smart IR Mode
Network Failure Detection
Day / Night (ICR)
IR LED Module (working distance up to 25m)
Micro SD support
Weatherproof (IP66 International)
Sunshield
Integrated Mounting Bracket with Cable Management
ONVIF Support

1.2 Package Contents
Please check the package contains the following items listed below.
FCS-5061
POI-3002 (PoE Plus Injector)
Camera Sunshield
Camera Bracket
Desiccant Pack
Power Terminal Block
Alarm Terminal Block
M4 Inner Hex Wrench
Plastic Screw Anchors x 5
M4 Self Tapping Screws x 5
Quick Installation Guide
CD Manual/Utility

1.3 Dimensions
The IP Camera's dimensions are shown below

1.4 Connectors
The Camera is equipped with an all-in-one cable for quick wiring. Definition
for each connector are as follows.
All-in-one Cable
Cable
Pin No.
Definition
Remarks
Network (with POE)
-
RJ-45 connector with LED
Power
1
-
AC 24V-1
Power connection
2
GND
GND
3
+
AC 24V-2
Alarm
1
ALM_DI－
Input－
Alarm connection
2
ALM_DI＋
Input＋
3
ALM_DO－
Output－
4
ALM_DO＋
Output＋
Audio I/O
Pink
Line In/ Mic In
Two-way audio transmission
Green
Line Out
BNC
-
Analog video output

Micro SD Card Slot/ Reset Button
Follow the steps below to reach the Micro SD Card Slot, Reboot Button and Factory Default
Button on the IP Camera:
Step 1:
Unscrew two screws on the Sun
Shield to remove it.
NOTE: Please note that the
Sun Shield is optional.
Step 2:
Unscrew the screw on the Camera Housing and
remove the Front Housing.
NOTE: Before installing, please refer to Desiccant User Guide in the
package to place the Desiccant in the Camera to prevent moisture from
condensing on IP Camera’s Glass Cover.

10
2. Camera Cabling
Please follow the instructions below to complete Camera connection
2.1 Connect Power
To power up the IP Camera, please plug the AC 24V cable into the Camera’s
power terminal block. Alternatively, connect the Ethernet cable to the camera’s
PoE port and plug the other end of the cable into a PoE switch.
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in use
in the network.

11
2.2 Connect Ethernet Cable
Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters. Connect
one end of the Ethernet cable to the RJ-45 connector of the Camera, and the
other end of the cable to the network switch or PC.
NOTE: In some cases, you may need use an Ethernet crossover cable when
connecting the IP Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are
unlit, please check LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
2.3 Connect Alarm I/O
The camera equips one alarm input and one relay output for alarm application.
Please refer to the label on the alarm terminal block and connect the alarm wiring
accordingly.

12
3. Installation
Please read the instructions provided in this chapter thoroughly before installing
the Camera.
3.1 Ceiling/Wall Mounting
The IR Bullet IP Camera can be installed directly on a wall or ceiling with the
integrated 2-axis adjustable Bracket Mount. Please note that the wall or ceiling
must have enough strength to support the IP Camera.
Follow the steps below to install the IP Camera:
Step 1:
Unpack the IR Bullet IP Camera package and take out the IP Camera.
Step 2:
Connect the power/Ethernet/alarm/audio wires from ceiling or wall to the
correspondingconnectors of the camera’s All-in-one Cable.
Step 3:
Fix the IP Camera’s Bracket on the
ceiling/wall with three supplied self
tapping screws
Step 4:
Use the supplied Inner Hex Wrench and
cross screwdriver to loosen the hex
bolt/screw on the side of the Bracket
Mount and the Camera Housing to
adjust the position of the IP Camera.

13
4. System Requirements
To perform the IP Camera via web browser, please ensure your PC is in good
network connection, and meet system requirements as described below.
Items System Requirement
Personal Computer
1. Intel○
R Pentium○ R M, 2.16 GHz or
Intel○
R CoreTM2 Duo, 2.0 GHz
2. 2 GB RAM or more
Operating System Windows VISTA / Windows XP / Windows 7
Web Browser Microsoft Internet Explorer 6.0 or later
Firefox
Chrome
Safari
Network Card 10Base-T (10 Mbps) or 100Base-TX (100 Mbps) operation
Viewer ActiveX control plug-in for Microsoft IE

14
5. Accessing Camera
For initial access to the IP Camera, users can search the camera through the
installer program: DeviceSearch.exe, which can be found in “DeviceSearch”
folder in the supplied CD.
Device Search Software Setup
Step 1:
Double click on the program Device Search.exe (see the icon below); its window
will appear as shown below. Then click the “Device Search”
button.
Step 2:
The security alert window will pop up. Click “Unblock” to continue.

15
Device Search
Step 3:
Click “Device Search” again, and all the finding IP devices will be listed in the
page, as shown in the figure below. The IP Camera’s default IP address is:
192.168.0.250.
Step 4:
Double click or right click and select “Browse” to access the camera directly via
web browser.
Step 5:
Then the prompt window of request for entering default username and password
(as shown below) will appear for login to the IP Camera.

16
The default login ID and password for the Administrator are:
Login ID Password
root
NOTE: ID and password are case sensitive.
NOTE: It is strongly advised that administrator’s password be altered
for the securityconcerns.
Additionally, users can change the IP Camera’s network property, either DHCP or Static
IP directly in the device finding list. Refer to the following section for changing the IP
Camera’s network property.
Example of Changing IP Camera’s Network Property
Users can directly change an IP Camera’s network property, ex. from static IP to DHCP,
in the finding device list. The way to change the IP Camera’s network property is specified
below:
Step 1:
In the finding device list, click on the IP Camera that you would like to change its network
property. On the selected item, right click and select “Network Setup.” Meanwhile, record
the IP Camera’s MAC address, for future identification.

17
Step 2:
The “Network Setup” page will come out. Select “DHCP,” and press “Apply”
button down the page.
Step 3:
Click “OK” on the Note of setting change. Wait for one minute to re-search the
IP Camera.
Step 4:
Click the “Device Search” button to re-search all the devices. Then select the IP
Camera with the correct MAC address. Double click on the IP Camera, and the login
window will come out.
Step 5: Enter User name and Password to access the IP Camera.

18
5.1 Using Recording Software
The product software CD also contains recording software-IP CamSecure, allowing
simultaneous monitoring and video recording for multiple Network Cameras. Please
install the recording software; then launch the program to add the Network Camera
to the Channel list. For detailed information about how to use IP CamSecure, please
refer to the user’s manual of the software or download it at http://global.level1.com.

19
5.2 Installing DC Viewer Software Online
For the initial access to the IP Camera, a client program, DC Viewer, will be
automatically installed to your PC when connecting to the IP Camera.
If the Web browser doesn’t allow DC Viewer installation, please check the Internet
security settings or ActiveX controls and plug-ins settings (see Appendix B: Internet
Security Settings ) to continue the process.
The Information Bar (just below the URL bar) may come out and ask for permission
to install the ActiveX Control for displaying video in browser (see the figure below).
Right click on the Information Bar and select “Install ActiveX Control…” to allow the
installation.
Then the security warning window will pop up. Click “Install” to carry on software
installation.
Click “Finish” to close the DC Viewer window when download is finished. For the
detailed software download procedure, please refer to Appendix C: DC Viewer
Download Procedure.

20
Once login to the IP Camera, users will see the Home page as shown below: