LEXINGTON 621-870 User manual

ASSEMBLY INSTRUCTIONS
621-870 ROUND DINING TABLE
BASE
TOP
Part Qty
516" x 2" Bolt 4
Lock Washer
Flat Washer 4
4
Wrench 1
TOP
BRIDGEPLATE
BASE
BRIDGEPLATE
1. Set Top upside-down on a non-marring surface. Place Base onto Top so that holes in Base Bridgeplate
align with holes in Top Bridgeplate.
2. Use provided Wrench to attach bridgeplates together with (4) Flat Washers, (4) Lock Washers, and (4)
5/16” x 2” Bolts. Tighten securely.
3. Return assembled table to its upright position.
For additional consumer assistance please contact your Lexington dealer or call our Consumer Services Department
at 1-336-474-5300, Monday-Friday, 8-5 Eastern

Leaf Installation:
1. Pull out all leaf supports.
2. Lay (1) leaf panel on supports. Center leaf so that both supports are same distance from each end of
leaf.
3. Each leaf has a number stamped on the bottom on the ends. The numbers should be matched as the
leaves are assembled to ensure a correct fit. Find the leaf that has a number corresponding to the
number on one end of the first leaf you just installed and place it beside the first leaf so the numbers
match.
4. Connect (2) leaves together by sliding hole on end of one leaf onto tenon on end of other leaf. Make
sure table lock, underneath where leaves connect, is locked.
5. Continue installing the remaining leaves until all are in place.
LEAF PANEL = 5 PCS
TOP
BASE
LEAF TENON