LEXINGTON 621-870 User manual

04/11/08
Page 1 of 2
ASSEMBLY INSTRUCTIONS
621-870 ROUND DINING TABLE
BASE
TOP
Part Qty
516" x 2" Bolt 4
Lock Washer
Flat Washer 4
4
Wrench
1
TOP
BRIDGEPLATE
BASE
BRIDGEPLATE
1. Set Top upside-down on a non-marring surface. Place
Base onto Top so that holes in Base Bridgeplate align
with holes in Top Bridgeplate.
2. Use provided Wrench to attach bridgeplates together
with (4) Flat Washers, (4) Lock Washers, and (4)
5/16” x 2” Bolts. Tighten securely.
3. Return assembled table to its upright position.
For additional consumer assistance please contact your
Lexington dealer or call our Consumer Services Department at
1-336-474-5300, Monday-Friday, 8-5 EST
Leaf Installation:
1. Pull out all leaf supports.
2. Lay (1) leaf panel on supports. Center leaf so
that both supports are same distance from each
end of leaf.
3. Each leaf has a number stamped on the bottom
on the ends. The numbers should be matched as
the leaves are assembled to ensure a correct fit.
Find the leaf that has a number corresponding to
the number on one end of the first leaf you just
installed and place it beside the first leaf so the
numbers match.
4. Connect (2) leaves together by sliding hole on
end of one leaf onto tenon on end of other leaf.
Make sure table lock, underneath where leaves
connect, is locked.
5. Continue installing the remaining leaves until all
are in place.

04/11/08
Page 2 of 2
LEAF PANEL = 5 PCS
TOP
BASE
LEAF TENON