LEXINGTON 911-133C User manual

Revised 07/30/14
ASSEMBLY INSTRUCTIONS
911-133C/134C/135C Upholstered Bed
HARDWARE LIST
PART DESCRIPTION QTY
A
Threaded Rod
8
B8
C
Nut
8
D
Wrench
1
E
Screw
8
Square Flat Washer
F
Center Support Leg
4
Headboard (1)
Footboard (1)
Side Rail (2)
Slat (4)
How to Attach Side Rails to Headboard/Footboard
* All needed hardware is located in a hardware bag which should be taped to inside of side rail.
** NOTE: SIDE RAILS ARE IN PAIRS. When assembling, make sure that the left sticker (“L”) on the side
rail matches the corresponding “L” sticker on the footboard. Do the same for the “R” sticker on the right side
rail and the “R” sticker on the footboard.
1. Insert threaded rod (A) into metal dowel in post thru open hole. Twist clockwise until tight.
2. With both threaded rods in place, and side rail positioned with T-slots to inside, slide side rail over threaded
rods.
3. Add flat washer (B) and hex nut (C) with barrel end towards washer to threaded rod (A).
4. Tighten nut with wrench (D) until tight. Repeat process for other three corners.

Revised 07/30/14
How to Attach Slats to Side Rails
1. Insert bolted end of support leg (F) into bottom of slat. There is a T-nut in the center of the board. Rotate
clockwise until tight.
2. Adjust leveler so that support leg and leveler sit ½” above floor.
3. Place a slat 3” to 5” inward from each end of wood cleats. Place two slats between two end slats so that there
is an equal amount of space between all four slats.
4. Secure slats with wood screws (E) provided. Note that top side of slat has larger hole.
For additional consumer assistance please contact your Lexington dealer or call our
Consumer Services Department at 1-336-474-5300, Monday-Friday, 8-5 Eastern