LG SEAT MIB ENTRY RADIO User manual

SEAT MIB ENTRY RADIO
OPERATION MANUAL
2012.10

PRECAUTION
It is essential to follow the precautions below when using the system, both in the interest of safety and
to prevent material damage.
You must always comply with the laws of the country in which you are travelling.
Precautions when operating the system
–Operate the controls (on the dash or near the steering wheel) and read the information on the screen
only when road conditions allow.
–Set the volume to a reasonable level so that outside noise can be heard.
Precautions concerning the equipment
–Do not attempt to dismantle or modify the system, as there is a risk of damage to equipment and fire.
–Contact a representative of the manufacturer in the event of malfunction and for all operations
involving disassembly.
–Do not insert foreign bodies into the player.
Precautions when using the phone
–There are laws which govern the use of phones in vehicles. They do not necessarily authorise the use
of hands-free phone systems under all driving conditions: drivers must be in control of their vehicles at
all times;
–Using a phone whilst driving is a significant distraction and risk factor during all stages of use (dialling,
communicating, searching for a number in the handset memory, etc.).

FCC Warning
1. Any changes or modifications not expressly approved by the grantee of this device could void the user's
authority to operate the equipment.
2. To comply with FCC RF exposure compliance requirements, a separation distance of at least 20cm must
be maintained between the antenna of this device and all persons. This device must not be co-located or
operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

GENERAL DISCRIPTION
Introduction
Your vehicle’s multimedia system performs the following functions:
–FM/AM/RDS Radio,
–CD(MP3) Playback,
–USB, SD(SDHC) Playback,
–Auxiliary audio source output
Radio Function
The multimedia system can be used to listen to FM (frequency modulation), and AM (amplitude
modulation) radio stations.
The RDS system makes it possible to display the name of some stations and also for information
messages sent by FM stations to be heard automatically :
–traffic bulletins
–news bulletins
–emergency messages.
Audio Function
You can listen to your personal stereo directly through your vehicle’s speakers.
There are several ways of connecting your personal stereo, depending on the type of device you
have and the vehicle :
–CD (CD-DA, MP3) / USB 2.1 / SD (SDHC)
–3.5 mm Jack socket
–Bluetooth® connection.
For more information on compatible devices, contact your approved manufacturer’s dealer or visit
the manufacturer’s website.

GENERAL DISCRIPTION
Hands-free Phone Function
The hands-free Bluetooth® phone system makes the following functions possible without having to
handle your phone :
–send/receive/suspend a call
–transfer the list of contacts from the phone memory
–access the call logs for calls which have come through the system
–dial emergency numbers.
Telephone Compatibility
Some phones are not compatible with the hands-free system, and do not enable you to use all of
the available functions or do not provide the best possible sound quality.
For more information on compatible telephones, contact your approved manufacturer’s dealer or
visit the manufacturer’s website.

KEY FUNCTION
Mute Sound Eject CD
Insert CD
Insert SD
Band Select
Media Source Select
Sound Control
-PUSH :
Power ON/OFF
-Turning Right / Left :
Volume Control
Bluetooth Select
Main Menu
Car Information
-PUSH :
Radio/Media Scan
-Turning Right / Left :
Searching Wavelength/Media Files
* USB, AUX –External Connection

RADIO MODE
①②③
④⑤⑥
⑦
⑧⑨
①BAND SELECT
Select the wavelength (FM or AM) required
by pressing wavelength.
②MENU
Enter the whole system’s setup menu of audio.
③STATION
It shows the station list.
④TP
Receiving RDS Traffic Program ON/OFF.
⑤SETUP
Enter the radio setup menu. Refer to the page 7.
⑥MANUAL
Tuning frequency by manual mode.
⑦SELECT THE PRESET
This operation mode allows you to recall on
demand those stations which already stored.
⑧⑨SEEK UP / DOWN
This mode allows stations to be searched
manually by scanning the selected wavelength.

RADIO MODE
Radio Settings
Display the settings menu by pressing “SETUP”. You can activate or deactivate functions below.
(the setting menu varies depending on the wavelength).
–Scan
–TP (Traffic Program)
–Radio Text
–Seek Mode (Station list / Preset list)
–Station list order (Group / Alphabetical)
–Delete Presets
–Advanced setup (RDS regional setup / Alternative Freguency (AF) )

RADIO MODE
* RDS
Some FM radio stations broadcast text information relating to the program being listened to (the name
of a track, for example).
Note : This information is only available on some radio stations.
* TA (Traffic Announcement)
When this function is activated, your audio system makes it possible to automatically search for and
listen to traffic information when they are broadcast from certain FM radio stations.
Once the function is activated, select the news station then choose if you require another playback
source.
Traffic information is broadcast automatically and has priority over the source being listened to at the
time. The automatic broadcasts will not operate when listening to radio stations on the AM wavelength.
To activate/deactivate this function, refer to information on “Radio settings” in this section.
* Region
The frequency of an FM radio station may change depending on the geographical area.
In order to keep listening to the same radio station when driving, activate the Region function so that
your audio system can automatically retune the frequency.
Note : Not all radio stations offer this possibility. Poor reception can sometimes cause erratic and
annoying changes in frequency. In this case you should deactivate this function.
To activate/deactivate this function, refer to information on “Radio settings” in this section.

MEDIA MODE - CD/MP3/USB/SD/BT AUDIO
①②③
④⑤⑥
①MEDIA
Select the media devices (CD, SD, USB, BT AUDIO)
required by pressing source in connection.
But when listening to the radio, select your
audio source by pressing “MEDIA” Key.
The system starts playing the last audio track
played.
Note : Any change to the audio source which is
made when the system is not active will not be
automatically taken into account.
* In case of playing mp3 file in SD
②MENU
Enter the whole system’s setup menu of audio.
③SELECTION
Show the playlist in media source.
④⑥FOLDER UP/DOWN
Searching the folders in media source.
(In case of MP3 CD, SD, USB, BT AUDIO)
⑤SETUP
Enter the media setup menu. Refer to the page 12.

MEDIA MODE - CD/MP3/USB/SD/BT AUDIO
⑨
⑦⑧
⑦⑧TRACK UP/DOWN, FF/REW
Push Short
This mode allows title to be searched manually
by scanning the selected file or track.
Push Long
Also, Press and hold to fast forward or rewind.
Playback resumes when the button is released.
⑨DISPLAY
Shows the kind of media device (CD,SD,USB,
BT AUDIO) and title’s information in playing.
(In case of CD-DA, it shows track No.)
⑩
⑩REPEAT / PAUSE / SHUFFLE SETTINGS
This function allows you to repeat one
song or all songs.
You can choose by tap “Off”, “Track”, or “All”.
Stop the play until release.
Shuffle allows you to play all songs randomly.
You can choose by tap “On” or “Off”.

MEDIA MODE –EXTERNAL AUX
Connection
Connect the jack of your portable audio player or external device to the AUX jack input.
Use
No indication of the name of the artist or the track is displayed on the system’s screen.
Note : you cannot select a track directly from your audio system.
To select a track, you must do so directly via your portable audio player, when the vehicle
is stationary.

MEDIA MODE
Media Settings
Display the settings menu by pressing “SETUP” in playing media device.
You can activate or deactivate below functions.
(the setting menu varies depending on the media device in playing)
–Scan
–External AUX Device
–Mix/Repeat including subfolders
–Bluetooth audio autoplay
–Bluetooth Setup

MEDIA MODE
* Audio Formats
The media audio source formats include MP3, WMA only.
* Folder & TAG Information
If you connect a USB key, all the folders will be at the same level on the tree structure.
Depending on the type of digital portable audio player, you can refine your selection by using folders
or files or by searching the following criteria :
–Artist,
–Album,
–Genre,
–Playlist,
–All tracks.

SOUND CONTROL
①②③
④⑤⑥
⑦
①EQUALIZER SETTINGS
Tap “+” or “-” to adjust the Bass, Mid or Treble.
After setting Bass, Mid or Treble, tap “BACK”.
If you tap “RESET”, the setting becomes default.
②MENU
Enter the whole system’s setup menu of audio.
③RADIO or MEDIA
Display the currently playing file or radio
channel information.
④MUTE
Muting the sound.
⑤SETUP
Enter the sound setup menu. Refer to the page 15.
⑥RESET
Reset the sound setting to default.
⑦ADJUST THE FADER / BALANCE
Tap ◁or ▷to adjust the sound left/right balance.
Tap △or ▽to adjust the sound front/rear fader.
Tap ◎to adjust the sound in center.
* Equalizer Setting

SOUND CONTROL
Sound Settings
Display the settings menu by pressing “SETUP”. You can control below functions.
–Maximum switch-on volume
–Traffic announcements
–Volume by speed
–Acoustic touchscreen feedback
–AUX volume
–Bluetooth audio

SYSTEM SETTINGS
* To access the system parameters :
Push “MENU” Key -> “Setup” or tap “MENU” -> “Setup” in each media or radio mode.
①Display switched off
You can switch off the screen.
②Screen Setup
Set the display brightness, clock showing or acoustic touchscreen feedback.
③Sound Setup
Refer to the page 15 “Sound Settings”.
④Language
You can choose main launguage between 8 languages
- English (US), English (UK), Deutsch, Cestina, Polski, Portugues, Pyccknn, Svenska

SYSTEM SETTINGS
⑤Bluetooth Setup
Refer to the section of Bluetooth
⑥Factory Setup
This function allows you to initialize various settings to the default settings.
–All : Initializes all the settings to the default settings.
–Phone / Bluetooth : Initializes all the settings related with phone, Bluetooth.
–System : Initializes all the settings related with system.
–Sound/Media/Radio : Initializes all the settings related with Sound/Media/Radio.
⑦System Information
This function allows you to check the version of system (H/W, S/W, BT, MEDIA CODEC).
⑧Copyright
It shows the article about Copyright.

MIB Entry SE370/1 Bluetooth Manual
Searching
Pairing
Connection
Outgoing call
Incoming call
BT audio(A2DP)
Phonebook

Searching
Press hard key ‘PHONE’ and click on ‘Find telephone’
Or press hard key ‘SETUP’ -> Bluetooth setup -> Find devices -> Find
List of searched Bluetooth devices will be listed as shown in the below diagram