Life Span TR3000i Use and care manual

Firmware Updates
This is for rmware updates for the 2019 touchscreen models of the TR3000i, TR4000i, and TR5500i.
If you are unsure of what treadmill version you have, please give us a call at 801-973-9993 opt. 4.
Step By Step Instructions
Step 3
Make sure the safety key is in place. Turn the treadmill on using the main
power button located at the front end of the treadmill by the power cord.
Step 4
Press the Bluetooth icon located in the upper right-hand corner
of the home screen. Then turn the Bluetooth on the speaker on.

Step By Step Instructions
Step 5
Write down the four digit BT Audio ID displayed on the screen.
You will need this number later. Once you’ve written the number down,
return to the home screen.
Step 6
Turn the treadmill off using the main power button as used in Step 3.
Step 7
Open the small compartment located on the back of the treadmill console.
Step 8
Insert the USB drive into the USB port located in the compartment.

Step By Step Instructions
Step 9
Once again, turn the treadmill back on using the main power button.
In a second or two, you should now see the LifeSpan logo on the console
screen followed by an upload screen. This screen will be black with
white text. You should see the progress change from 0% to 100% over
the course of roughly ve minutes.
Step 10
Once the upload is complete and the display shows the standby screen,
go to the treadmill’s Engineering Mode by pressing the bright dot again in
the bottom left-hand corner of the console screen for three seconds.
Step 11
Once you see the engineering screen, press the “UpdateMCU” button
located near the center of the screen. You should screen the Status
screen go from Status to Please Reboot Console. Proceed to Step 11
prior to rebooting.
Step 12
Re-enter the four digit BT Audio ID number you wrote down earlier in
Step 5. This is done by tapping the square box till you have reached the
desired number. Note: If you have misplaced this number, you can
relocate it by using your smartphone to scan Bluetooth devices.

Step By Step Instructions
Step 13
Verify that the correct treadmill model number is highlighted in red and
press the Reboot button in the upper left-hand corner of the screen.
Step 14
Once you see a black screen that reads “Please shut down the device
and restart”, restart the treadmill by turning off and on the main power
switch once more.
Step 15
Woohoo! Your rmware is now updated. It’s time to start working out.