Lightolier LYTESPOT User manual

/INSTRUCTION SHEET NO.
INSTRUCTIONS FOR AITACHING LYTESPOT” TO
LYTESPAN” TRACK IS:6336
FOR USE WITH LWESPAN” TRACK SYSTEMS ONLY R0490
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTIONS FOR AITACHING LYTESPO~
TO SINGLE CIRCUIT TRACK SYSTEM
1.Align BEAD on LYTESPAN TRACK and GROOVE in FIT-
TiNG before inserting into LYTESPAN TRACK. See Fig.
1. (if BEAD is NOT aligned, apotentiai hazard may
result.)
2. Position LEVER as shown in Fig. 1.
3. To attach FiTTi NG, insert into LYTESPAN TRACK. Turn
LEVER 90° whiie pushing upward on fitting, to make
mechanical and electrical connection. See Fig. 2.
4. To remove or shift fixture location on the LYTESPAN
TRACK, reverse procedure as described in #3 above.
5. To aim fixture, first loosen the KNOB by turning it
counterclockwise. Position to the desired angle, then
tighten KNOB.
NOTE: Lamp manufactures’ bulb sleeve may state “Burn
oniy in porcelain sockets.” in certain fixtures phenoiic,
not porcelain, socket are used. These are of aspeciai
heat resistant type that have been tested by Lightolier
and are listed by Underwriters Laboratories for use with
the recommended lamps.
INSTRUCTIONS FOR CONVERTING LYTESPOT@
Attachment FllTING TO OPERATE ON
2CIRCUIT TRACK
NOTE: To insure proper operation of Lytespots on
Two Circuit Lytespan Track, the BLACK SPACER
(provided) must be used at aii times on the
piug assembiy.
The BLACK SPACER is not used when operating
Lytespots on Singie Circuit Track.
.m.m
GROOVE
m
FllTING –LEVER
&KNoB
FIG. 1
&KNOB
FIG. 2
LOWER
UPPER
CIRCUi~ FIG. 3:
Illustrates contacts in low position with spacer in
place for lower circuit.
CIRCUIT, FiG. 4 and 5:
To convert attachment fitting for upper circuit, raise
BRASS CONTACT to high position (as indicated by
dotted line) by pulling CONTACX as high as stop
permits and slipping on BLACK SPACER as shown
in Fig. 4 and 5.