Lightolier Lightolier E1 Series User manual

E1 Series
6 V, 12 TO 25 W COMMERCIAL EMERGENCY LIGHTING
Page 1 of 2
Job Information Type:
Job Name:
Cat. No.:
Notes:
Features
Illumination: Illumination
is provided by two high
performance lamp reflector
systems integral to the housing.
Each lamp reflector system
can be adjusted 180° vertically,
and 180° horizontally. A high-
impact polycarbonate diffuser
utilizes linear frosted sections
to control sight-line glare, and
maximize reflector efficiency.
Lamp wattages range from 6
to 9 W.
Housing: Constructed
of impact-resistant, UL 94
V-0, 5 VA thermoplastic.
Thermoplastic backplate
is provided with matching
knockouts for easy installation
to standard junction boxes.
Installation is further
simplified by the use of a
snap-together backplate and
housing. A modular plug-
in wiring harness will allow
line voltage connections in
either the junction box or
product housing. Utility supply
connection is completed by
snapping the housing and
backplate together forming
a secure mechanical and
electrical connection.
Operating Temperature
Range: Standard Location
65°F (19°C) to 85°F (30°C)
Diagnostics: 120/277 VAC
dual voltage input with surge-
protected, solid-state fully-
automatic, voltage regulated
charger. Charging system is
complete with low voltage
Disconnect, AC lockout,
brownout protection, AC
indicator lamp and test switch.
Electrical Specifications:
12 W unit:
0.112 A (120 VAC)
0.062 A (277 VAC)
14-18 W unit:
0.077 A (120 VAC)
0.034 A (277 VAC)
Code Compliance
UL 924 listed. NFPA 101,
NEC, BOCA, OSHA and IBC
illumination standards. Meets
ADA specifications for wall
mounted lighting fixtures.
Warranty
Three year full electronics
warranty. One year full plus
four year prorated lead calcium
battery warranty. Five year full
plus five year prorated nickel
cadmium battery warranty.
E112LT7W
15.5"
(39.4 cm)
3.8"
(9.6 cm)
5.5"
(14.0 cm)

E1 Series
6 V, 12 TO 25 W COMMERCIAL EMERGENCY LIGHTING
Page 2 of 2
Philips Lightolier
e: [email protected]
t: [phone]
w: www.lightolier.com
E1 Series September 12, 2011
Specifications are subject to change without notice.
© Koninklijke Philips Electronics N.V., 2011.All rights reserved.
Job Information Type:
Ordering Information
Series
E1 = 6 V
Thermoplastic
Emergency Unit
Lead Calcium
12L = 12 Watt Unit
18L = 18 Watt Unit
25L = 25 Watt Unit
Nickel Calcium
12N = 12 Watt Unit
14N = 14 Watt Unit
18N = 18 Watt Unit
Battery/Wattage Lamp Type
1
T6 = Tungsten 6 W
T7 = Tungsten 7 W
T9 = Tungsten 9 W
H7 = Halogen 7 W
H12 = Halogen 12 W Note
1) Selected lamp wattage cannot exceed unit output rating.
Accessories (order as a separate item)
SCKTW = White Canopy Kit for Ceiling Mount
SCKTB = Black Canopy Kit for Ceiling Mount
WG5 = Wire Guard
PCS1 = Polycarbonate Vandal Shield
E1
W= White
B= Black
Housing Color
Optics
Wall mounted 7.5' AFF, ‘H7’ 6 Volt 7 Watt Halogen Lamps Represented
1 FC Average
7.5 ft.
25 ft.
6 ft.
Average initial footcandles at floor = 1.33
Maximum initial footcandles at floor = 5.1
Minimum initial footcandles at floor = 0.2
Maximum to minimum ratio = 25.50
* The optics layout shown is intended to be used as reference only. Standard reflectances used were 80/50/20. Lightolier is not responsible for site specific conditions that
may alter the results.
0.2
0.2
0.2
0.7
0.6
0.3
2.6
2.1
0.6
4.5
3.3
0.9
2.7
1.9
0.6
1.0
0.8
0.5
0.9
0.7
0.5
2.3
1.5
0.6
4.5
3.3
0.9
3.2
2.8
0.9
0.9
0.9
0.5
0.3
0.3
0.3
0.2
0.2
0.2
0.4
0.4
0.3
1.4
1.2
0.5
4.0
3.1
0.5
4.0
2.9
0.8
1.6
1.1
0.5
0.9
0.7
0.5
1.3
0.9
0.5
3.6
2.5
0.7
4.4
3.9
0.9
1.9
1.7
0.6
0.4
0.5
0.3
0.2
0.2
0.2