Lightolier F7000-11 User manual

Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems F7000-11
1BHFPG '4FSJFT-JHIU51JFSDFE8BMM.PVOU
&
Features for Wall Modules
1. Housing: Single piece of high purity extruded aluminum, a portion from
recycled material.
2. Housing End: Die-cast aluminum, welded in place.
3. End cap: Die-cast aluminum. Encloses the end of the run.
4. Lamps: F28T5 or F54T5HO as specified. By others. Installed fromthe ceiling
side of the luminaire.
5. Ballast: Electronic. Meets ANSI starting, end-of-life protection and sound
rating specifications. Low THD.
6. Shielding: Perforated square-in-square pattern pierced in extruded housing,
regressed and backed by 0.20” (0.51cm) opal acrylic.
Electrical
Connections: Pre-wired with 18 gauge wires and polarized cannon plug con-
nectors for simultaneous
mechanical/electrical connection.
Emergency Battery Pack: 90 minute operation, 700 lumens for 54W and 520
lumens for 28W.
Dimming: Advance Mark X standard (no additional wires required); use compat-
ible dimmer. Dimming ballasts using additional control wires (eg Lutron Hi-Lume
or ECO-10, Osram) can be used; consult factory and use X4 or X5 power feeds
with additional leads, as appropriate. Ballast not to exceed 1.25” (3.18cm) wide by
1.20” (3.05cm) high.
iGEN: F7000 accepts iGEN (DALI) with supplemental 2-wire control technology.
Use with X5 power feed.
Power Tray: Code-gauge, die-formed steel, pre-paint white enamel finish;
secured by quarter-turn fasteners
for easy access to wiring. Holds ballasts, sockets, and wiring. Accepts ballasts
up to 1.25” (3.18cm) wide by 1.20” (3.05cm) high.
Factory installed ballast disconnect allows the ballast to be disconnected fromand
reconnected to incoming power under load without turning the entire circuit off.
Ordering Instructions for Wall Modules
Individual Fixtures:
1. Order one MODULE.
2. Order one END SET.
Continuous Rows:
1. Order the appropriate number of MODULES for the complete run.
2. Order one END SET.
Finish
Powder-coated, baked enamel, white or aluminum, as specified.
Ordering Information
Complete Ordering Instructions below.
FW7
Family Series
2
Type Lamps Color Wattage Voltage Length
2 1
2= Oval 2= Pattern
Pierced
1= 1 LampAL = Aluminum
WH = White
1= 28W
2= 54W
3= 28W Dimming
4= 28W EM
5= 54W Dimming
6= 54W EM
1= 120v
2= 277v
4= 4’ (121.92cm)
8= 8’ (243.84cm)
1.63”
(4.14cm)
4.44” (11.28cm)
3.25”
(8.26cm)
41
54.187”
(10.63cm)
1.750”
(4.45cm)
1.557”
(3.95cm)
6. Shielding Pattern

Job Information Type:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems F7000-11
1BHFPG '4FSJFT-JHIU51JFSDFE8BMM.PVOU
&
Mounting Accessories
Wall Mount End Set
FW7EWH = White
FW7EAL = Aluminum
Fixture Lengths & Mounting Reflected (Plan View)
20'-3" (617.22cm)
16'-3" (495.30cm)
12'-3" (373.38cm)
8'-3" (251.46cm)4'-3" (129.54cm)
2'-8"
(81.28cm)6'-8" (203.20cm)
6'-8" (203.20cm)2'-8"
(81.28cm)
1'-4"
(40.64cm)
6'-8" (203.20cm)1'-4"
(40.64cm)6'-8" (203.20cm)
6'-8" (203.20cm)1'-4"
(40.64cm)6'-8" (203.20cm)2'-8"
(81.28cm)
1'-4"
(40.64cm)
16.00" (40.64cm)
3/4"
(1.91cm)
1-1/2"
(3.81cm)
3/8" (0.95cm)
END OF ROW DETAIL
GAP BETWEEN FIXTURES
JOINING DETAIL
Recommended mounting is a single gang outlet box rotated 90 degrees at the
feed point. Remaining mounting points could be outlet boxes as well, or a couple
of holes per mounting point spaced 3-1/4” (8.26cm) at 1-3/4” (4.45cm) above the
bottomof fixture.
CANDLEPOWER
ZONE 0 22 45 67 90
DEG. CANDELAS
0 217 217 217 217 217
5 216 217 218 216 213
15 211 209 200 195 187
25 193 189 173 164 153
35 164 155 136 126 112
45 127 116 94 81 64
55 84 76 51 45 40
65 39 36 27 28 25
75 12 12 12 15 12
85 45551
90 43210
95 55 56 61 78 38
105 279 287 303 315 184
115 560 567 571 519 355
125 822 815 769 679 519
135 972 960 915 793 663
145 1073 1054 990 876 788
155 1085 1065 1011 935 881
165 1039 1029 1003 965 943
175 983 982 983 977 975
180 971 971 971 971 971
Performance
CANDLEPOWER CURVE
1000
750
500
250
0
10
20
30
40
50
60
70
80
90
100
110
120
130
140
150
160
170
180
REPORT NO.: ITL54692.IES
LAMPS: 1C
LUMENS: 5000 each
EFFICIENCY: 69.4%
CAT. NO.: F7221WH214
DISTRIBUTION
Zone Lumens % Lamp %Luminaire
0 - 90 382 7.6 11.0
90 - 180 3099 61.8 89.0
0 - 180 3481 69.4 100.0
80% 70% 50%
50 30 10 50 30 10 50 30 10
0 686868 6060 60 434343
1 605755 5250 48 383635
2 524845 4643 40 333129
3 464137 4036 33 292725
4 413531 3531 29 262421
5 363027 3128 24 232018
6 322723 2924 21 211816
7 292420 2621 18 191613
8 262117 2319 15 171412
9 241915 2117 14 151210
10 22 17 13 19 15 12 14 11 10
20% FLOOR CAVITY REFLECTANCE
COEFFICIENTS OF UTILIZATION
% EFFECTIVE CEILING CAVITY REFLECTANCE
WALL REFLECTANCE
ROOM CAVITY RATIO