Linda Lewis SM-30 User manual
SPARE PARTS DIAGRAM FOR
First Choice Group
Blakeney Way, Kingswood Lakeside
Cannock, Staffs, WS11 8LD
TEL: 01543 577778 FAX: 01543504141
Email: [email protected]
Web: www.firstchoice-cs.co.uk
Mixer
SM-30
Introduction
Thank you for purchasing a Linda Lewis Kitchens Ltd product. In this
booklet you will find instructions for safe operationso please read
carefully and retain for future reference. The planetary mixers have
a stirring hook that rotates. They have three speed settings and use
a combinationtransmissioncomposedof a locking band, triangle
belt and chains.
Warnings and Precautions
The following warnings and precautions are important and must be
observed:
•Never immerse the mixer in water. If the mixer does become
completelywet, it must be dried and checked by a qualified
specialist before it is used again.
•The mixer cannot be used if the protective cover switchis not
functioning.
•Prior to installation, pleaseread the instructions fully.
•Do not put your hand or other items into the bowl when the
machine is in operation.
•Whenever a speed change is made, the main switch must be
turned off beforehand and then the slow or fast button must
be pressed. This ensures a long service life of the mixer.
•Do not leave the mixer unattended when it is in operation.
•Please unplug the electrical cord when the mixer is not in use.
Disclaimer:The manufacturer will accept no liabilityfor any injury
or damage caused by incorrect usage of the mixer.
Technical Data
Specifications:
LLKPM30
Motor Power
1.1kW
Width
550mm
Depth
600mm
Height
1115mm
Weight
107kg
Specifications are subject to change. Please checkthe rating label
on the back of the machine.
2
0161 696 0052
Parts Identification
Please familiariseyourself with the various parts of the mixer before
use.
1. Gear Change Hand Lever
2. Stirring Shaft
3. Mixer
4. Stainless Bowl
5. Power Switch
6. Bowl Lift Lever
7. Safety Guard (with micro-switch)
8. Support
3
0161 696 0052
Operating Instructions
1. The machine must be placed on a dry, level surface to ensure
the mixer is stable.
2. Check the power voltage of the socket matches the mixer’s
required voltage and ensure it is properly earthed before
plugging in the mixer.
3. Slide the guard across and pour the ingredients into the bowl.
4. Close the guard and set the stirring speed.
5. Switch on the mixer using slow speed at first, then switch to
fast speed to ensure uniform dough is produced.
6. If the machine is stopped during the mixing process, be sure
to return to the lowest speed when starting the machine up
again.
Maintenance
Cleaning
Spilled food should be removed immediatelyfrom all exterior
surfaces. Also, it is important to clean the mixer afteruse. To
remove dirt or marks from the mixer, it is best to wipe with a soft
damp cloth. The stainless steel is washable. The mixer must not be
cleaned using a high-pressure jet.
Please note that attachments and machine are not suitable for
cleaning in the dishwasherdue to caustic soda contained within the
chemicals. They should be cleaned with soapy water.
Problems and Solutions
1. The mixer will not start – the power is not properly connected
or the guard is not fitted correctly
2. The guard switch is not operating correctly – open the guard
and check to see if the micro-switch is connected properly.
Check the power supply.
3. The mixer has overheated – this can occur if the mixer is
operated for too long, with excessive load. Overheating can
also come from electricleakage.
4. The mixer is operating with low efficiency – check to see if the
drive system is worn, whether the motor is in good condition,
whether the belt is loose or damaged. Remove the top cover
and the rear ventilating plate, adjust the belt, tighten the
wheel or the chains, thus the belt and the chains can be re-
tightened.
4
0161 696 0052
Ser.
No.
Part No.
Part Name
Ser.
No.
Part No.
Part Name
1
PM30.HOOK
Hook
42
P01.255
Gear
2
PM30.BEATER
Beater
43
P01.248
Clamp Plate
3
PM30.WHISK
Wire Whip
44
P01.246
Bearing 6206
4
P01.267
Safety Guard
45
P01.253
Bushing
5
PM30.BOWL
Bowl
46
P01.231
Oil Seal 40x62x8
6
P01.268
Top Cover
47
P01.269
Body Housing
7
P01.250
Screw
48
P01.218
Bowl Hold Kits
8
P01.202
Spring
49
P01.270
Support
9
P01.266
Pin Shaft
50
P01.249
Clamp Plate 18
10
P01.232
Shifting Yoke
51
P01.271
Nut M8*1.5
11
P01.100
Cam-Gear Shifter
52
P01.272
Base
12
P01.101
Plate-Shifter Index
53
P01.694
Bearing 6203
13
P01.223
Handle-Shifter
54
P01.273
Transmission Shaft
Support
14
P01.222
Handle Set
55
P01.104
Key 5*16
15
P01.081
Turn Set M6
56
P01.105
Circlips for Shaft 17
16
P01.224
Speed Handle
57
P01.238
Gear
17
P01.096
Plug Attachment Hub
58
P01.256
Bushing
18
P01.221
Attachment Hub
59
P01.210
Gear Box
19
P01.226
Spring
60
P01.177
Worm Pole
20
P01.251
Circlips
61
P01.274
Brand
21
P01.259
Gear
62
P01.112
Motor
22
P01.276
Hood Ring
63
P01.002
Back Housing
23
P01.236
Circlips for Shaft 19
64
P01.275
Internal Gear
24
P01.258
Planet Gear
65
P01.257
Tighten Yoke M8x25
25
P01.277
Operating Shelf
66
P01.079
Crank Lever
26
P01.183
Bearing 6205
67
P01.106
Handle-Shifter
27
P01.244
Oil Seal
68
P01.107
Gear
28
P01.225
Pin10x38
69
P01.108
Bushing
29
P01.245
Working Shaft
70
P01.237
Worm Wheel
30
P01.227
Declutch Shaft
71
P01.109
Mid-Gear Wheel Gear
31
P01.161
Plate 10
72
P01.110
Washer
32
P01.234
Main Shaft
73
P01.239
Plug Cover 1
33
P01.156
Nut M10
74
P01.241
Nut M12
34
P01.278
Top Batter Valve Cap
75
P01.111
Spring Washer 12
35
P01.168
Flat Valve Cap
76
P01.236
Bearing 6202
36
P01.247
Bearing 6204
77
P01.280
Gear Wheel
37
P01.240
Main Shaft Plug Cover
78
P01.104
Key 5x15
38
P01.252
Super Machine Parts
79
P01.228
Circlips for Shaft 20
39
P01.254
Gear
80
P01.229
Circlips for Shaft 15
40
P01.197
Bushing
81
P01.240
Plug Cover 2
41
P01.279
Sleeve
82
P01.112
Motor
6
0161 696 0052
P01.009 Microswitch
Pos.
No.
Part No.
Part Name
83
P01.070
Rubber Set
84
P01.044
Green Button
85
P01.045
Red Button
86
P01.079
Crank Lever
87
P01.088
Handle-Shifter
88
P01.235
Connecting Rod
89
P01.212
Clamp Plate 14
90
P01.243
Spring
91
P01.242
Clamp Plate 12
P01.009
Microswitch
7
0161 696 0052
Table of contents
Other Linda Lewis Mixer manuals
