7GB
Safety/Preparing the product for use
To avoid danger to
life from electric shock
Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
CAUTION! A damaged light bulb means your
life is at risk from electric shock. If there is any
damage, repairs to be carried out or other
problems related to the light bulb, please contact
the service centre or a qualified electrician.
In order to prevent hazards, if the outer flexible
cable of this lamp becomes damaged it may
only be replaced by the manufacturer, a service
representative of the manufacturer or a similar
specialist!
Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230–240V∼).
Never let the lamp come into contact with water
or other liquids.
Always unplug the light from the mains prior to
assembly, disassembly, cleaning or if the light
will not be used for extended periods.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric shock.
To avoid danger
of fire and injury
CAUTION! RISK OF INJURY! Check bulbs
for damage immediately after unpacking. Do
not fit defective bulbs into the light. If they are,
contact the service point for a replacement.
CAUTION! RISK OF INJURY FROM
BURNS! Ensure the lamp has been switched
off and allowed to cool before you touch it. In
this way you will avoid the danger of burns.
Bulbs give off a lot of heat around the top of
the lamp.
Do not cover the light or the mains plug with
objects. Excessive heat can result in a fire.
Never leave the lamp operating unattended.
Do not allow the lamp or the packaging materials
to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
ATTENTION!
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
The LED lights cannot be replaced.
Working safely
Install the light so that it is protected from
moisture and dirt.
Prepare carefully before assembly and allow
yourself enough time. Lay out all the individual
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
Preparing the product for use
Assembling the lamp
Note: You will require a second person to help
with the assembly of the product.
Note: Please ensure that you pull the cable during
fitting slowly through the base.
Remove the transport lock 6from the support
tube.
First insert the support tube 14 into the upper
support tube 15 of the torchiere and tighten.
Ensure not to pinch the mains lead running
through the support tube 14 .
Insert the support tube 7for the reading light
into the flexible arm 3and tighten.
Slide the support tube guide 13 over the
support tubes.
Insert the floor lamp with both support tubes 7,
14 into the designated holes in the base 9.
Place the serrated washers 10 over the support
tubes 7, 14 on the underside of the base 9.
