
User manual
6
CLEANING
1. Before using this appliance, please always clean it. After having using it, clean the inner part of the
appliance with a sponge and soapy cold water.
2. Do not use solvents, abrasive creams or tools that can scratch: the warming disc is covered with a
non-stic layer, which could avoid to get damaged.
3. When you wash it, be careful not to wet any electrical component.
4. Do not place the mil frothed into the dishwasher.
NOTE: The Mil Frother or any of its accessories are NOT dishwasher safe.
TROUBLESHOOTING
Issue Reason Solution
Indictor light doesn’t wor /
Jug doesn’t wor
Plug is not inserted properly Re-insert plug
Jug isn’t connected to power base
properly
Remove jug and replace correctly
No power in the jac Chec the electric circuit
Jug doesn’t wor after
operation
Jug temperature is too high Rise cold water inside the jug to
reduce temperature
Jug is damaged with immersion water
Repair or replace
Motor doesn’t wor Jug not cleaned in good time after
use, mil loc s the mechanism
Clean and move the shaft sleeve
of motor by hand to loosen it.
Charring Dosage of mil either too little or too
much
Ensure the mil is between min
and maxi level
Jug was reused without cleaning
/Rinsing
Always clean after each use.
Actual Voltage is much lower than
specified voltage
Ensure you use the appropriate
voltage