Lopolight 400-1 Series User manual

P/N 601-323 Rev 2.00
P/N 601-323 Rev 2.00 / 28 Sept. 2020
Deck & Interior lights 400-1XX series
Installation guide
Thank you for purchasing a Lopolight product. Our products are built to ensure a long
lifetime in the most extreme marine conditions.
Mounting:
Go to www.lopolight.com or use the QR code to get to the ‘products’
section where the datasheet, that includes the dimensional drawing, is
found.
Flush mount:
It is intended to be mounted with an adhesive sealant.
We recommend that you use Sikaflex or 3M 5200.
Surface Mount:
You can either use the 3 M4 threaded holes or use the
5mm hole in the center of the light.
We recommend that you use Sikaflex or 3M 5200 to
seal the light.
Connecting power:
Supply Voltage: Any DC voltage between 10 and 32 volts. (12 and 24 Volt systems)
Connections:
Black wire: Negative (-) Common
Red wire: Positive (+) for mode 1
wire: Positive (+) for mode 2
Blue wire: Dimming (10-0 VDC)
Recommended fuse or circuit breaker: Less than 2A (slow).
Grounding: The navigation light housing should not be connected to ground (Earth).
(We recommend that you connect the cable screen to ground (Earth)).
Cabling: Avoid chafe and route it away from sources of heat and large inductive
fields such as electric motors.

P/N 601-323 Rev 2.00
P/N 601-323 Rev 2.00 / 28 Sept. 2020
Deck & Interior lights 400-1XX series
Cleaning your product:
•Wipe off your product with a normal detergent, on a damp cloth.
DO NOT use alcohol or thinner for cleaning your light – this could
damage the lens.
Troubleshooting:
If the light does not function:
•Check that you have a supply Voltage between 10 and 32 Volt DC.
•Check that the polarity is right (you will not damage the Lopolight by
accidentally wiring the polarity wrong).
Warranty:
•This product is covered by our 5-year limited warranty.
•If you want to claim a warranty for your product, please fill in the
form at www.lopolight.com/service
Test:
The light in this package is using components that have been approved to standard:
•IEC 60945
Dimming:
•If the blue wire is present, the light is dimmable.
•In case the dimming wire is not connected the light will work at full intensity.
•We recommend the use of Lopolight P/N 400-126 as dimmer, but any 0-10 Volt
dimmer can be used.