B
• When “B” is pressed in the calendar or blank
display of the TIME/CALENDAR mode, the
time/calendar display is shown while the
display is illuminated.
• The electroluminescent panel loses its
luminance as the battery voltage gets
lowered. Also, its luminance level decreases
gradually with use.
•
When the illuminating light becomes dim,
replace the batteries with new ones. If the light
remains dim after the batteries are replaced,
have the electroluminescent panel replaced
with a new one by the retailer from whom the
watch was purchased. It will be replaced at cost.
•While the illuminating light is used, the watch
gives out a slight noise. However, this is not a
malfunction.
1. Press “B” in any mode to turn the illuminating
light on.
■ILLUMINATING LIGHT (Electroluminescent panel)
●Necessary procedure after battery change
After the batteries are replaced with new ones,
or when an abnormal display (failing digits, etc.)
appears, follow the procedures below to reset the
built-in IC. The watch will resume its normal
operation.
Press and hold buttons A, B, C and D at the same
time for 2 to 3 seconds until the display becomes
blank, then release all the buttons. The watch
returns to its default setting, which is “12:00'00"
a.m., Jan. 1st, 2005, SAT” with “UTC” selected as
"Home City" and contrast level 5. Before start
using the watch, set the time, calendar including
"Home City", and alarm.
■BATTERY CHANGE
indicated on the dial/case back.
•Do not operate the buttons when the
watch is wet.
•If the watch is exposed to salt water, rinse
it in fresh water and then wipe it thoroughly
dry.
•Should you find any water or condensation
inside the watch, immediately have it
checked. Water can corrode electric parts
inside the case.
NO NO NO
YES
YES
YES NO NO
YES YES NO
Condition
of use
Accidental
contact
with water,
such as
splashes
and rain
Swimming
and taking
a shower
Skin
diving Scuba
diving
Indication
on the dial/
case back
No
Indication
NO NO NO
YES
WATER
RESISTANT
WATER
RESISTANT
(50M/5 BAR
)
WATER
RESISTANT
100M/10 BAR
or above
(
NO
(
Caution:
Leather straps are not water resistant except
so indicated, even if the watch head is water
resistant.
•ALLERGIC REACTION
Because the case and band touch the skin
directly, it is important to clean them regularly.
If not, shirt sleeves may be stained and those
with delicate skin may develop a rash. Please
wear the watch with some play to avoid any
possible allergic reaction. If you develop a rash
on your wrist, stop wearing and consult a
physician.
•MAGNETISM/STATIC ELECTRICITY
Your watch will not be affected by magnetism
generated by household electric appliances
but keep your watch away from a place where
the watch is subject to strong electric field and
static electricity.
•SHOCKS AND VIBRATIONS
Your watch may be worn for normal sports
activities, However, be careful not to drop it or
hit it on hard surfaces and avoid any severe
impacts.
•TEMPERATURE
Your watch works with stable accuracy within
a temperature range between 0˚C and 50 ˚C.
Do not expose the watch to a place exceeding
this temperature range.
•CLEANING
Use only a soft cloth and clean water for
cleaning your watch. Never use chemicals,
especially soap.
■SERVICE
When your LORUS watch requires repair or
sevicing, please see the enclosed WARRANTY/
GUARANTEE.
Printed in China
The miniature lithium battery SEIKO SR626SW (for
analogue display) and SEIKO SR41W (for digital
display), which power your watch, should last
approximately 2 years. However, because they
are inserted at the factory, the actual life of the
batteries once in your possession may be less than
2 years.
Be sure to replace the batteries to prevent any
possible malfunction as soon as either of them
runs down. To replace the batteries, we
recommend taking the watch to a local watch
repair shop.
Note:
1. If the alarm is used for longer than 10 seconds
a day and/or the illuminating light is used more
than once for longer than 3 seconds a day,
the battery life may be shorter than the above
specified period.
2. Even if either of the two batteries has run
down, replace both of them with new ones.
3. After the batteries are replaced with new
ones, set the time/calendar and alarm and
adjust the stopwatch hand position.
LORUSNX11 05.9.29, 1:34 PMPage 2 AdobePageMaker6.5J/PPC
