LORUS YM92 User manual

6
6
■CHARACTERISTICS
1. Time: Indicated by the hour, minute and
small second hands.
2. Date: Displayed in numerals.
3. Stopwatch: Measures up to 12 hours in
1/20 second increments.
•Split time measurement
Minute hand
■DISPLAY AND CROWN OPERATION
a. Normal position: Free
b. First click : Date setting
c. Second click : •Time setting
•Adjustingthestopwatch
hand position
Crown
Hour hand
Small
second hand
INSTRUCTION MANUAL
CAL. YM92, 7T92 (RF8 SERIES)
NREYM92C 04-2003
■SETTING THE TIME AND ADJUSTING
THE STOPWATCH HAND POSITION
•This watch is so designed that
1) time setting and
2) stopwatch hand position adjustment
are both made with the crown at the second
click position. Once the crown is pulled
out to the second click, be sure to make
the above adjustments at the same time.
Minute handHour hand
1) Time setting
Small
second hand
1. Pull out the crown to the second click
when the small second hand is at the 12
o’clock position.
A
B
a b c
Crown
Date
Stopwatch minute handStopwatch hour hand
Stopwatch
second hand
Stopwatch
1/20-second hand
6
* If the stopwatch is measuring or stopped, it is
automatically reset to “0”.
2. Turn the crown to set the hour and minute
hands.
* It is recommended that the hands be set to
the time a few minutes ahead of the current
time, taking into consideration the time required
to adjust the stopwatch hand position if necessary.
Notes:
1. When setting the hour hand, be sure to
check that AM/PM is correctly set. The
watch is so designed that the date changes
once in 24 hours.
2. When setting the minute hand, first advance
it 4 to 5 minutes ahead of the desired
time and then turn it back to the exact
minute.
2) Stopwatch hand position adjustment
•If the stopwatch hands are not in the “0”
position, follow the procedure below to set
them to the “0” position.
Stopwatch
1/20-second hand
A
B
Stopwatch
second hand
6
1. Press button “A” for 2 seconds to select
the stopwatch hand(s) to be adjusted. The
selection of the hand(s) to be ajusted is
made in the following order by pressing
button “A” for 2 seconds.
Stopwatch
1/20-second
hand
Stopwatch
hour and minute
hands
→
Stopwatch
second
hand
→
↑
* The selected hand(s) turn(s) a full circle.
2. Press button “B” repeatedly to set the
selected stopwatch hand(s) to the “0”
position.
* The hand moves quickly if button “B” is kept
pressed.
3. After all the adjustments are completed,
push the crown back in to the normal position
in accordance with a time signal, checking
that the hour and minute hands for time
display indicate the current time.
■SETTING THE DATE
1. Pull out the crown to the first click.
2. Turn the crown clockwise until the desired
date appears.
3. Push the crown back in to the normal position.
Note: Do not set the date between 9:00
p.m. and 1:00 a.m. Otherwise, the
date may not change properly.
•Before setting the date, be sure to set the
time.
•It is necessary to adjust the date at the end
of February and 30-day months.
Date
B
Stopwatch
hour hand Stopwatch
minute hand
•The stopwatch can measure up to 12 hours
in 1/20 second increments.
•The measured time is indicated by the four
stopwatch hands that move independently
of the hands for time display.
•When the measurement reaches 12 hours,
the stopwatch automatically stops counting.
■STOPWATCH
A: Start /
Stop
B: Split /
Split
release /
Reset
Stopwatch
1/20-second hand Stopwatch second hand
Stopwatch hour hand
Stopwatch
minute hand
[ Ex.: 2 hours, 30 minutes and 10.85 seconds ]

Movement of the stopwatch 1/20-second
hand
•After the stopwatch is started, the stopwatch
1/20-second hand moves for about 10 minutes
and automatically stops at the “0” position.
•When the measurement is stopped or split
time is measured, it moves to indicate the
elapsed 1/20 seconds.
•After the measurement is restarted or split
time is released, the stopwatch 1/20-second
hand moves for about 10 minutes and stops
automatically.
•In the same manner, if the stopwatch is
stopped and restarted repeatedly or split
time is measured and released repeatedly,
the stopwatch 1/20-second hand moves for
about 10 minutes and stops automatically.
Standard measurement
A
Start Stop Reset
AB
Accumulated elapsed time measurement
A
Start Stop Restart Stop Reset
A A B A
*Restart and stop of stopwatch
can be repeated by pressing
button “A”.
Stopwatch operation
✩Before using the stopwatch, be sure to
check that the crown is set at the normal
position and that the stopwatch hands are
reset to the “0” position.
* If the hands do not return to the “0” position,
follow the procedure in “■SETTING THE TIME
AND ADJUSTING THE STOPWATCH HAND
POSITION”.
A
Start Split Split Stop Reset
release
A
Split time measurement
BB B
*Measurement and release of
split time can be repeated by
pressing button “B”.
Measurement of two competitors
A
Start Finish 2nd Finish Reset
time competitor time
of 1st finishes of 2nd
competitor competiror
B
B A B
■LUMIBRITE WATCH
(dial, hands, buttons, case, bezel,
strap, etc.)
✩If your watch is a LORUS LUMIBRITE watch,
it has following features.
LORUS LUMIBRITE watches absorb and store
light energy from natural and artificial light
sources and emit light in the dark. They are
made of environmentally friendly material,
and therefore, are harmless to human beings
and the environment.
• With a full charge, LORUS LUMIBRITE
watches glow in the dark hours longer than
conventional luminous watches of this type.
If exposed to a light of more than 500 lux
(i.e., the brightness of a typical office) for
approximately 10 minutes, or direct sunlight
for 2 minutes, they will glow for hours.
• Since LORUS LUMIBRITE watches emit
the light they store, the brightness will
decrease gradually over time. The length
of time they will glow may also differ slightly
depending on such factors as the brightness
of and distance from the light source used
to charge the watch.
■BATTERY CHANGE
The miniature battery SEIKO SR927SW, Maxell
SR927SW, SONY SR927SW or EVEREADY 395,
whichpowersyourwatchshouldlastapproximately
3 years. However, because it is inserted at
the factory, the actual life of the battery once
in your possession may be less than the specified
period.
Be sure to replace the battery to prevent any
possible malfunction as soon as it runs down.
To replace the battery, we recommend taking
the watch to a local watch repair shop.
Notes:
1. If the stopwatch is used for more than 3
hours a day, the battery life may be less
than the specified period.
2. After the battery is replaced with a new
one, set the time/calendar and adjust
the stopwatch hand position.
Battery life indicator
•When the battery nears its end, the small
second hand moves at two-second intervals
instead of normal one-second intervals. In
that case, have the battery replaced with a
new one as soon as possible.
•The watch remains accurate, however, while
the small second hand is moving at two-
second intervals.
■CARE OF YOUR LORUS WATCH
CAUTION
Do not expose the old battery to
fire or recharge it. Keep it at a
place beyond the reach of chil-
dren. If a child swallows it,
consult a doctor immediately.
• BATTERY
• WATER RESISTANT
Condition
of use
Accidental
contactwith
water, such
as splashes
and rain
Swimm-
ing and
taking a
shower
Skin
diving Scuba diving
Indica-
tion on
the dial/
case back
No
indication
WATER
RESISTANT
WATER
RESISTANT
(50 M/5 BAR)*
WATER
RESISTANT
100 M/
10 BAR or
above
NO NO NO NO
YES YES NO NO
YES NO NO NO
YES YES YES NO
()
*
* If your watch is 200 M/20 BAR, 100 M/10
BAR or 50 M/5 BAR water resistant, it is so
indicated on the dial/case back.
•Do not press the buttons or turn the crown
when the watch is wet.
•If the watch is exposed to salt water, rinse
it in fresh water and then wipe it thoroughly
dry.
Caution:
Leather straps are not water resistant except
so indicated, even if the watch head is water
resistant.
• ALLERGIC REACTION
Because the case and band touch the skin
directly, it is important to clean them
regularly. If not, shirt sleeves may be
stained and those with delicate skin may
develop a rash. Please wear the watch
with some play to avoid any possible allergic
reaction. If you develop a rash on your
wrist, stop wearing and consult a physician.
• MAGNETISM
Your watch will not be affected by mag-
netism generated by household electric
appliances.
• SHOCKS AND VIBRATIONS
Your watch may be worn for normal sports
activities, but be careful not to drop it or
hit it on hard surfaces.
• TEMPERATURE
Your watch is preadjusted so that constant
accuracy may be insured at normal tem-
perature.
■SERVICE
Printed in China
When your LORUS watch requires repair or
servicing, please see the enclosed WARRANTY/
GUARANTEE.