LOWE'S MLW 3940 User manual

Alto: 50,7 cm
Ancho: 40 cm
Fondo: 37,3 cm
Height: 19,9 in
Width: 15,7 in
Depth: 14,7 in
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLE
NIGHTSTAND
Mesa de noche
IF ANY PARTS ARE BROKEN OR MISSING
PLEASE CONTACT US, OUR CUSTOMER
SERVICE TEAM WILL PROVIDE YOU HELP TO
RESOLVEANY ISSUES IMMEDIATELY

!
WARNING
!
IMPORTANT
RECOMMENDATIONS RECOMENDACIONES IMPORTANTES
No pintar el mueble.
El mueble debe ser usado únicamente en interiores,
no exponer al sol directo.
Limpiar los herrajes metálicos con un paño seco.
NO sobrecargar el mueble (ver las cargas sugeridas).
No golpear ni martillar el mueble (solo cuando se
indique).
Limpiar con un paño ligeramente húmedo,
usar jabones suaves.
No arrastre el mueble, levántelo entre dos personas.
Evite el contacto directo con el agua, el fuego o la
exposición a fuentes de calor.
Never allow children to climb or manipulate
the cabinet, furniture tip over can cause
serious injuries or death.
ADVERTENCIA
!
Nunca permita que los niños escalen o
manipulen el mueble, la caída de este
puede provocar lesiones graves o la muerte.
Do not paint the cabinet.
The cabinet MUST be used exclusively indoors,
do not expose to direct sun.
Clean metallic hardware with a dry cloth.
Do not hit or hammer the cabinet (just when
indicated).
Clean with a slightly damp cloth, use gentle soaps.
Do not drag, lift and move between two people.
Avoid direct contact with water, fire or exposure
to heat sources.
Do NOT overload the cabinet (see suggested loads).
Page 2

REQUIRED TOOLS* HERRAMIENTAS NECESARIAS*
Page 3
*Not included, and not shown actual size. *No incluidas y no se muestran en tamaño real.
INDEX ÍNDICE
Assembly Hardware
Assembly Parts
Suggested Loads
Assembly Recommendations
Assembly Steps
Warranty
4
5
6
6
7-15
16
Herrajes para Armado
Piezas de Armado
Cargas Sugeridas
Recomendaciones de Ensamble
Pasos de Armado
Garantía
4
5
6
6
7-15
16

x16
Minifix Cams
Minifix
Spreading Bolt
Perno Minifix
x16 x24
Wood Dowel
Tarugo
x1
Glue
Pegante
Cover Caps
Tapa Adhesiva
Minifix
Flat Head Screw
Tornillo Lámina
x16
x16
x8
Nail-on Glide
Deslizador Puntilla
x8
Drywall Screw
Tornillo de Ensamble
x12
Nail
Puntilla
x2
Handle
Manija Acero
x4
Handle Screw
Tornillo Manija
x2
Drawer Slides
Rieles
ASSEMBLY HARDWARE HERRAJES PARA ARMADO
Page 4
Please check that the hardware content is correct.
If any item is missing, please call to our customer
service line.
Hardware items are NOT shown actual size. Los herrajes no se muestran en el tamaño real.
Compruebe que el contenido de los herrajes sea
el correcto. En caso de que falte alguna pieza, por
favor llame a nuestra línea de atención al cliente.

ASSEMBLY PARTS PIEZAS DE ARMADO
A - x1
B - x1
C - x1
D - x1
E - x2
F - x1
G - x2
H - x2
I - x2
J - x2
K - x2
L - x1
Page 5
A
B
C
D
E
E
F
G
G
H
H
I
I
J
J
K
K
L

MAX SUGGESTED LOADS CARGAS MÁXIMAS SUGERIDAS
ASSEMBLY
RECOMMENDATIONS RECOMENDACIONES DE ENSAMBLE
Page 6
Two people are recommended to assemble
the product.
Assemble the cabinet on a flat, smooth
surface, preferably on a carpeted floor
or the carton box of the product.
Carefully read the assembly instructions
and identify every wood and hardware
part before start assemblying the cabinet.
Ensamble el mueble entre dos personas.
Ensamble el mueble sobre una superficie
plana y lisa, preferiblemente sobre un
tapete o el cartón de la caja
Lea cuidadosamente las instrucciones e
identifique todas las piezas y herrajes
antes de empezar a armar el mueble.
44lb
44lb
33lb
33lb
20Kg
20Kg
15Kg
15Kg

1
2
x2
A
B
E X 2
x2
x5
x4
1
2
!
Do NOT tighten the
cams in this step.
NO apriete las cajas
minifix en este paso.
Page 7
x2

3
4
Page 8
C
D
Frente/Front
!
Do NOT tighten the
cams in these steps.
NO apriete las cajas
minifix en estos pasos.
x2
x2
x2
Frente/Front
x2

Page 9
5
6
F
G X 2
G X 2
x2
x4
x2
Turn Over
Voltear
!
Do NOT tighten the
cams in these steps.
NO apriete las cajas
minifix en estos pasos.

Page 10
7
8
B
E
E
I X 2
H X 2
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
Gently hit the pieces
with a rubber hammer
to adjust the joint.
Golpee suavemente la
pieza con un martillo
de goma para ajustar
el ensamble.
x2

Page 11
9
10
B
E
E
F
C
D
C
FB
EE
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
Gently hit to adjust.
Golpee suavemente
para ajustar.

Page 12
11
12
A
B
C
D
E
F
A
B
E
C
D
L
/3mm
3mm
Turn Over
Voltear
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
x2
1,18in
1,18in
Gently hit to adjust.
Golpee suavemente
para ajustar.

Page 13
13
14
JH
I
H
IJ
K
Turn Over
Voltear
x4
Slide.
Deslice.

Page 14
15
16
K
K
G
H
I
J
H
I
G
Turn Over
Voltear
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
x2

Page 15
17
After you finish the adjustment
of the cams, cover them with
the cover caps.
Después de ajustar todas las
cajas minifix, cúbralas con las
tapas adhesivas.
After you finish assembling the
cabinet, take off the adhesive
letters.
Al terminar de armar, desprenda
las letras adhesivas.
A
Slide the drawers
inside the cabinet.
Deslice los cajones
dentro del mueble.
D
C
A
F
B
E
G
G
I
I
HJ
K

Page 16
WARRANTY POLICY
PÓLIZA DE GARANTÍA
coverage in hardware pieces since its manufacturing date, which you can see in the lot
number printed on the product box and the assembly instructions leaflet.
Warranty covers materials and workmanship imperfections which impair the assembly
or correct functioning of the cabinet.
This warranty is not valid if the defects or imperfections are caused by the incorrect
following of the assembly instructions, warnings and recommendations, misuse,
intentional damage, fire or flood, or after modifications or any kind of alteration, or
months after the date of purchase. These defects MUST be reported before the warranty
coverage period ends. Once the product has been assembled, the company will not be
responsible for defective and/or damaged parts.
This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the
product has been resold, rented, etc.
to or by the product (This may not apply in your state).
To make this warranty valid you must write to our customer service email describing the
product defect, lot number and submitting your sales reciept or proof of purchase, or
contact us at our customer service line. Replaced parts will be under the product´s
original warranty coverage period. Damaged parts will become property of the
company.
There are no other warranties applicable to this product.
IF ANY PARTS ARE BROKEN OR MISSING
TEAM WILL PROVIDE YOU HELP TO RESOLVE
ANY ISSUES INMEDIATLY
PLEASE CONTACT US FIRST
OUR CUSTOMER SERVICE
We have a 3 year warranty coverage in wooden parts and 1 year warranty
repaired by someone not authorized by us, when it´s been assembled 3
We will take no liability for incidental or consequential damages caused