Ltech DX8 User manual

0800 952 000 | www.brightlight.co.nz | BRIGHTLIGHT
INSTALLATION GUIDE
DX8 TOUCH PANEL | D SERIES
No wall ush box supplied/required. Units come with a
mounting plate, simply screw it through the wall and cut
out a hole in the centre
Learning ID - Short press the “ID Learning Button” on the R4-5A/R4-CC receiver, the Running Light will
stay on. Then press any zone number on the DX8 touch panel, when you hear a long beep it has been
activated and the receiver accepted zone control.
Cancelled ID - Long press “ID Learning Button” on the R4-5A/R4-CC receiver for 5sec, until you hear a
long beep indicating it has been cancelled.
Attention - Multiple receivers could be synced to each zone.
INPUT VOLTS 100-240V DC
OUTPUT
SIGNAL
RF 2.4GHz + DMX512
RF REMOTE
DISTANCE
30m
CONTROL
MODE
4 Zones Control
DIMENSIONS W86 x L86 x D36mm
OPERATING
TEMP.
-30°C ~ +55°C
WEIGHT 225g
INGRESS
PROTECTION
Indoor use only
WARRANTY 5 years
R4-5A | CV RECEIVER R4-CC | CC RECEIVER
INPUT VOLTS 5-24V DC INPUT VOLTS 12-48V DC
MAX CURRENT
LOAD
5A×4CH Max 20A OUTPUT VOLTS 3-46V DC
MAX OUTPUT
POWER
5V DC - 100W
12V DC - 240W
24V DC - 480W
OUTPUT
CURRENT
CC
350/700/1050mA×4CH
DIMENSIONS W44 x L175 x D30mm MAX OUTPUT
POWER
1.05W~48.3W×4CH
Max 193.2
OPERATING
TEMP.
-30°C ~ +55°C DIMENSIONS W44 x L175 x D30mm
WEIGHT 150g OPERATING TEMP. -30°C ~ +55°C
WEIGHT 165g
CODE
BL-PC-DX8
1. INSTALLATION INSTRUCTIONS 4. OPERATING INSTRUCTIONS FOR RECEIVER
5. THE LEARNING ID METHOD
Install Uninstall
3. KEY FUNCTIONS
4 Zone Selection Keys
On/Off
Brightness
/ Speed
Touch Circle
Brightness Adjust
Key of RGBW
Long press to turn
the tone on/off
On - Short press.
Off - Long press.
Mode Key
86mm 36mm
86mm
The Changing Mode
1. Static Red
2. Static Green
3. Static Blue
4. Static Yellow
5. Static Purple
6. Static Cyan
7. Static White
8. RGB Skipping
9. 7 Colours
Skipping
10. RGB Smooth
11. Full Colour
Smooth
2. TERMINALS
100-240V AC
Power Input Socket DMX Signal Output Socket

0800 952 000 | www.brightlight.co.nz | BRIGHTLIGHT
INSTALLATION GUIDE
6. WIRING DIAGRAM 1 (WIRELESS CONTROL) 7. WIRING DIAGRAM 2 (CONNECT TO DMX DECODER)