Lumi miniPRO User manual

USER MANUAL

We always end up right
where we are supposed
to be, right when we are
meant to be there.
Sometimes we just need
a little time to recover.
#lumitherapy
TRUST THE PROCESS

●Reduce muscle soreness and speed up recovery; prevent injury; improve muscle exibility and
performance.
●Recover from injury: decrease pain and inammation; break down scar tissue; loosen sti joints.
●Find pain relief: loosen knots, trigger points, and tightness in your muscles and fascia; boost
circulation; manage chronic pain caused by tendinitis, bursitis, carpal tunnel, and more.
●Boost immune system: improve sleep; reduce stress; increase serotonin and decrease cortisol.
The LUMI miniPRO is highly portable and the high capacity lithium-ion battery provides an average
of 3-4 hours of use-time per charge at high speed & 8-16 hours of use-time at low speed. 4 massage
speeds allow you to choose the right intensity for all areas of the body.
RELAX & RESTORE ON THE GO
SPEED UP YOUR RECOVERY OR PRE-EXERCISE TO ENHANCE YOUR PERFORMANCE
Great for oce workers suering from tech-neck and everyday people looking for a quick at-home
massage.
Percussion therapy uses targeted pulses of concentrated pressure into your muscle tissue. Therapy can
best be compared to 'soft-tissue massage techniques' used by massage therapists which are consistent,
rapid-thumping movements used to stimulate muscles.
Percussion therapy accelerates and enhances the repair of muscle bre by providing rapid bursts of
pressure in concentrated, short-duration pulses deep into the tissues of the body. This enhances the ow
of blood to dierent critical areas, allowing for pain relief and subsequently improving function and range
of motion.
It also provides a gentle stretch that in turn enhances exibility, performance, and physical response.
HOME OR STUDIO
2

CUSTOMER SUPPORT 24/7
If you have any questions about setting up or using your Lumi product, please visit our website for
further information, faqs, troubleshooting and customer support.
●1 x LUMI miniPRO Vibrating Massage Gun
●1 x USB-C Charging Cable
●4 x Interchangeable Massage Attachments
●1 x Portable Bullet Storage Case
UNPACKING YOUR LUMI miniPRO
1. Read carefully through this user manual before using the miniPRO.
2. Go to our website to register and activate your Lumi warranty.
3. Complete the steps in the QUICK START GUIDE to assemble and charge your LUMI miniPRO.
TAKE A MOMENT TO FIND OUT WHAT’S INCLUDED
Follow this QR Code for our
product guides and videos
YOUR JOURNEY BEGINS!
4

GET TO KNOW YOUR MINIPRO
Massage Attachment
(1 of 4)
Battery/Handle
USB-C Charging Port
Non-Slip
Wrist Strap
Status Indicator LEDs
The 4 LEDs indicate the
vibration speed selected (1-4)
and the current battery level.
Power/Speed Button
Press and hold the button for 2
seconds to power ON the unit.
Once power is on, tap the button to
toggle through the 4 vibration speed
levels. Press and hold the button for 2
seconds to power OFF the unit.
5

1. Make sure the LUMI miniPRO is fully charged and powered OFF.
2. Select the desired massage attachment.
3. Insert the stem of the massage attachment into the nozzle of the unit.
NOTE: Make sure the red line on the attachment is lined up with the corresponding red line on
the nozzle (see illustration).
4. Press the massage attachment in rmly to secure it.
5. See VIBRATION SPEED OPTIONS on the next page.
6
FULLY CHARGE THE BATTERY
1
1. Ensure the LUMI miniPRO is OFF before charging.
2. Connect the USB-C charging cable to the charging port on top of the unit.
3. Plug the USB-C charging cable into a USB power adapter, such as a 5V 1A or 5V 2A phone charger.
4. Charge the battery fully (for up to 3 hours) before using your miniPRO for the rst time.
5. The Status Indicator LEDs will ash in turn during charging. The LEDs will stop ashing and all 4 will
remain lit when the miniPRO is fully charged.
Please read the operating instructions before using the LUMI miniPRO.
INSERT A MASSAGE ATTACHMENT
2
QUICK START GUIDE
4

CHARGING
USING YOUR LUMI miniPRO
1. Press and hold the Power/Speed button on the top of the miniPRO for 2 seconds to power ON
the unit. The Status Indicator LEDs will show the current battery level.
2. Tap (short-press) the Power/Speed button to set the vibration speed to level 1. The Status Indicator
LEDs will show the speed level selected.
a. Tap the button a second time for speed level 2. Tap a third time for level 3. Tap a fourth time
for level 4.
b. Press and hold the Power/Speed button for 2 seconds to power OFF.
3. At the desired speed, oat the head of the massage attachment along a muscle group. Apply
pressure as needed.
4. Always power o the unit after each use.
OPERATING INSTRUCTIONS
1. Ensure the LUMI miniPRO is OFF before charging.
2. Connect the USB-C charging cable to the charging port on top of the unit and then plug the USB-
C charging cable into a USB power adapter, such as a 5V 1A or 5V 2A phone charger.
3. Charge the battery fully (for up to 3 hours) before using your miniPRO for the rst time.
4. The Status Indicator LEDs will ash in turn during charging. The LEDs will stop ashing and all 4
will remain lit when the miniPRO is fully charged.
5. The four Status Indicator LEDs indicate the current battery level:
6. For best results, charge the battery before it reaches 25%.
7. When the battery is very low, the unit will switch o and enter battery protection mode. If this
occurs, power o the unit and fully charge it before using it again.
8. Average run-time is 3-4 hours per charge at high speed and 5-6 hours at low speed.
1 LED lit = <25%
2 LEDs lit = 25-50%
3 LEDs lit = 50-75%
4 LEDs lit = 75-100%
7

REMOVING AND REPLACING A MASSAGE ATTACHMENT
1. Press and hold the Power/Speed button for 2 seconds to power OFF.
2. Grab the inserted attachment and rmly pull out to remove it.
3. Insert the stem of a new massage attachment into the nozzle of the unit.
NOTE: Make sure the red line on the attachment is lined up with the corresponding red line on
the nozzle (see illustration).
4. Press the massage attachment in rmly to secure it.
4
8
TIPS FOR USING YOUR miniPRO
●Move the miniPRO over the desired muscle groups, about 60 seconds per region.
●Apply pressure as needed.
●Use the miniPRO for 15-20 minute sessions, up to 3 times per day.
●Avoid keeping the massage head in one area for more than 3 minutes.
●Prolonged application can traumatize tissues.
Keep this manual for reference.

Speed
Frequency
RPM
1
15Hz
900RPM
2
30Hz
1800RPM
3
45Hz
2600RPM
4
60Hz
3600RPM
Four dierent massage speeds allow you to choose the right intensity for a particular muscle group or
trigger point. Each speed oers a dierent vibration frequency (Hz) and percussions per minute (RPM).
VIBRATION SPEED OPTIONS
MASSAGE GUN HEADS ATTACHMENTS
There are four interchangeable massage attachments included with your LUMI miniPRO. These massage
attachments allow you to target dierent areas of your body and specic massage therapy needs.
BALL
IRON
BULLET
SPINAL
The all over Shiatsu style massage, great for massaging those big areas like the
quads and buttocks.
Iron out those tight muscles in the forearm, chest and neck. This attachment is
designed to give a softer massage to relax the muscles around all the joints.
Designed for a deep more intense massage, nd that deep knot or pressure point
and get that deep release.
The safety spinal attachment is designed to massage either side of the spine without
direct contact to the spine itself, deep and relaxing massage.
10

●Use the LUMI miniPRO only on soft tissues. Do not use the miniPRO on your head, neck or other bony
regions. Do not use near your heart or genitals.
●Bruising can occur regardless of the vibration speed level selected.
●Check the areas you are treating frequently and stop immediately at the rst sign of pain or discomfort.
●Use only on dry, clean clothing or skin. We recommend using the LUMI miniPRO over clothing (e.g. form-tting
athletic wear, leggings, etc.).
●Keep hair, ngers, and other body parts away from the stem of the massage attachment as pinching may
occur.
IMPORTANT USAGE NOTES
●Consult your doctor before using this product. Do not use if you have an injury.
●For adult use only. Keep away from children and pets.
●Keep away from liquids and heat sources. Keep ventilation ports free from dust and debris.
●Never use or move the miniPRO while it is charging. Unplug the unit after charging and prior to use or
cleaning.
●Never leave the miniPRO unattended while it is running or charging.
●Do not remove screws or attempt to disassemble; the battery is not removable.
●Do not operate continuously for more than 30 minutes. After 30 minutes of use, allow the unit to rest for
5 minutes before re-using.
SAFETY INSTRUCTIONS
●Use a soft towel or cloth to wipe any dirt or moisture from unit. Do not use solvents or other chemicals.
●Store the unit fully-charged, in the carrying case and in a cool, dry place.
●If storing long-term, charge the battery every 6 months; holding a charge prevents the battery from becoming
damaged.
●For travel: secure the unit in the carrying case and protect the unit from rolling, dropping, collision with
other objects, and violent vibrations.
MAINTENANCE, CLEANING & STORAGE
To reduce risk of burns, re, electric shock, injury to persons, or equipment damage please read the
following warnings carefully.
MAINTENANCE, SAFETY & USAGE NOTES
12

PRODUCT SPECIFICATIONS
Made in China
Power: 24V / 70W High Torque Brushless DC Motor
Speed: Up to 3600 Percussions per Minute
Stall Force: 5kg
Weight: 485g
Dimensions (cm): 14 H x 9 L x 4.6 W
Decibel Rating: 45 - 55 dB
USB Type-C Quick Charging port
USB Type-C cable
Voltage: 12V DC
Type: Lithium-ion
Capacity: 2900 mAh
Working Hours: Up to 16hrs (varies by speed)
Charging Time: 3 hours
UNIT SPECS
CHARGING
BATTERY
13

SIZE
MATTERS
15cm

Access our library of free personal training videos
and guides on our website to learn how to get
the most out of your LUMI product and achieve
the results you want.
THERE
ARE NO
LIMITS
lumitherapy.co.uk @lumi.therapy @Lumitherapyuk