Luminetic FLP Series User manual

Working Temperature
Working Humidity
-40°C~+40°C
15%~90%RH
Storing Temperature
IP Rating
-40°C~+65°C
IP66
FLP
SERIES
Installation and wiring of luminaire must be in
accordance with all applicable local codes.
Installation, inspection, and maintenance of luminaires
should be performed by a qualified electrician.
DO NOT make or alter any open holes in the luminaire.
DO NOT modify the luminaire.
DO NOT install damaged product.
Make sure electrical power is OFF before and during
installation and maintenance.
Make sure the equipment is properly grounded.
Make sure the supply voltage is same as the rated
fixture voltage.
Only use luminaire in its intended location.
Make sure the luminaire is not covered with material
that will prevent convection or conduction cooling.
It’s suggested to perform visual, electrical, and
mechanical inspections on a regular basis.
Allow luminaire to cool before handling. Do not touch
enclosure or light source.
Installation Manual
Please read and follow all safety instructions. Save this manual for future reference!
WARNING
To avoid electric shock:
To perform maintenance:
Luminaire Parameter
Wiring Diagram

Align the luminaire
with the holes on the
mounting surface.
Fix the luminaire to
the mounting
bracket by screws.
Loosen the screws
on both sides of the
luminaire with allen
wrench and then
adjust the luminaire
to the suitable angle.
1 2 3
Tighten the screws on
both sides of the
luminaire with allen
wrench and connect
the wiring.
Finished.
4 5
FLP
SERIES
Installation
luminetic.com.au
VISIT US ONLINE