Luminite Alertex NXFOB Safety guide

• Press and hold buttons 1 and 2
simultaneously, red LED is on all the time
• After 3 seconds, the LED ashed red/green
and the alarm message is sent
• To deactivate the alarm, go to a master unit
and reset the system. You cannot reset the
system using this fob
• Allow 7 minutes after reset before the
system can be activated again
• Test the battery at least one a week
• To do this, press and hold button 1, marked with a spot as shown
until the led changes from green to ashing green/red
• This will transmit the battery condition to the system and be
registered on the data base but only if used in conjunction with the
IP management system
• If the IP management system is not tted, then change the battery
every year as a precaution
NXFOB - Mobile Panic Button
Set-up and User Guide
Operation
Maintenance

Specications
Wireless Frequency 434.525 Mhz
Transmission Range 200 metres
Baery 12-volt Type 23A
Baery Life 3 years
Acvaon Press and hold both buons for a minimum of 3 seconds
1. Hold Button 2 constantly during programming
2. Wait 5 seconds after the GREEN LED turns ON
3. Press and hold Button 1 until the GREEN LED ashes (after 4
seconds)
4. Release Button 1
5. Press Button One 7 times to select ‘operation 7’, which sets the
Site/Subnet/Unit
• Wait until ashing starts
• To set Site 1 (for example), press Button 1 once
• Wait until the green LED starts ashing again
• To set Subnet 1 (for example), press Button 1 once
• Wait until the green LED starts ashing again
• To set Unit 5 (for example), press Button 1 ve times
• Wait until the green LED stays on constantly
6. Release Button 2
Programming
020 8368 7887 | [email protected] | www.luminite.co.uk
Luminite Electronics Ltd.
2a Bellevue Road, Friern Barnet,
London, N11 3ER
Designed and Manufactured in the UK