Maclaren mx3 User manual

mx3
toddler seat

1
B
A

2
B
A
C

3
CLICK
CLICK
AA
BB
B
B
B
DD
CC

4
B
D
C
A

Warranty
Your Maclaren product is guaranteed to be free from any
manufacturing defects for a period of 1 year from the date
of purchase under normal use and provided it is used in
compliance with the operating instructions. This warranty
extends only to the original retail purchaser and is only
valid when supplied with proof of purchase. Please retain
proof of purchase with this Limited Warranty.
Should a repair be needed please contact the retailer from
whom the product was purchased, or one of the Maclaren
Authorised Service Agents.
Please note that the warranty will not be applicable if:
A fault is the cause of misuse or poor maintenance.
Please refer to this instruction leaflet for guidance on
how to maintain your product.
Repairs are carried out by a third party.
The product is faulty due to general wear and tear which
is the result of everyday use.
A product is damaged as a result of an accident.
Maclaren are not satisfied that the stated warranty terms
and conditions have been met.
THIS WARRANTY IS GIVEN IN ADDITION TO AND DOES NOT AFFECT
YOUR STATUTORY RIGHTS

2 EN Attendant user guide
Please read this User Guide fully prior to use ensuring reference is made to
the numbered diagrams on the final pages.
Retain this User Guide for future reference
5Operation illustrations
11 Warranty information
Contents

General Information & Safety
WARNING:
• DO NOT LEAVE CHILDREN UNATTENDED
• CHILDREN SHOULD BE PROPERLY HARNESSED IN AT ALL TIMES
• FOLLOW ALL INSTRUCTIONS CAREFULLY INCORRECT USE WILL
CAUSE DAMAGE TO THE STROLLER
• THE HARNESS SHOULD BE CORRECTLY FITTED AND ADJUSTED.
THE HARNESS IS NOT A SUBSTITUTE FOR PROPER ADULT
SUPERVISION.
• DO NOT CARRY EXTRA CHILDREN OR BAGS IN THIS SEAT.
• DO NOT USE THIS SEAT WITH ANY OTHER MODEL OF PRAM OR
STROLLER.
• PUT ON ALL THE BRAKES WHENEVER YOU PARK THE STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF ALL MOVING PARTS IF YOU
ADJUST THE STROLLER, OTHERWISE THEY MAY BE INJURED.
• DO NOT LIFT THE MX3 STROLLER AND CHILDREN USING THE MX3
TODDLER SEAT
CAUTION
• This seat is not recommended for children under 6 months and is not
suitable for children over a height of 96cm and a weight of
15kg.
• The stroller may be unstable if it is over-loaded Do not use acces-
sories or replacement parts other than those approved by Maclaren.
• For a compact fold remove the toddler seat before folding the
stroller.
• This MX3 toddler seat is for use with the Maclaren MX3 stroller
only; it should NOT be used with any other product.
• Ensure that you read the Maclaren MX3 Instruction leaet before
using the toddler seat.
• For extra safety ‘D’ rings are provided for attachment of a separate
harness to BS6684
• Never leave a child in this seat whilst ascending or descending
stairs or escalators or when travelling on other forms of transport.
• Not to be used near to an open re or exposed ame
Cleaning
• Clean frame with a damp cloth and mild detergent and dry
thoroughly. Do not use abrasives.
• The seat and other fabric can be sponge cleaned. Allow the
seat to dry naturally and thoroughly before reuse.
• Do not fold or store the product whilst wet and never store in
a damp environment as this can cause mildew to form.
Maintenance
• Do not leave in direct sunlight for extended periods
• Always check that the mechanical xings and plastic parts are
free from damage and are free to operate correctly
• Replace the seat and harness assembly if ripped or damaged
in any way
Maclaren reserve the right to make design changes to any of
their products as part of their continuous development
programme.
This product, when used with the MX3, is designed and
manufactured to comply with AS/NZS 2088:2000
2
EN

Instructions
IMPORTANT: • READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE.
• YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
3
1. ASSEMBELING/ DESEMBELING THE FRAME
A. Open the frame.
B. Pull the front legs forward and connect them into the
armrest bar until the pop up pins are engaged.
Pull on the legs to ensure that they are properly engaged.
2. ATTATCHING AND DETACHTING THE TODDLER SEAT TO
THE MACLAREN MX3 FRAME
Before attaching the seat to the stroller ensure that the leg
rest is folded down.
A. Place the toddler seat in position, the bottom bar of the
seat should rest on the footplate and the clips should rest
on the stroller frame at either side.
B. Push the side clips onto the frame and secure by closing
the clip around the tube.
C. Secure the side legs of the toddler seat to the stroller using
the straps provided, wrap the strap around the seat legs
and side bars of the stroller and fasten the clip.
D. Pull the strap tight.
CAUTION: The security of the tting should be tested by pulling
up on the toddler seat before putting the child into the seat.
To detach the toddler seat reverse this process.
3. SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: Avoid serious injury from falling or sliding out.
Always use the crotch strap in combination with the waist belt and
shoulder straps.
TO FIT HARNESS:
A. Insert both fasteners securely into clasp.
B. Adjust strap lengths. Belt, crotch strap and harness should
be snug.
C. ‘D’ rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D. Squeeze fastener prongs and pull apart.
4. UNFITTING AND REFITTING THE SEAT
A. Undo the zips on the seat on both sides of the bumper bar.
B. Undo the poppers on the crotch restraint on the front of
the bumper bar.
C. Undo the strap at the back of the seat by sliding it through
the buckles.
D. Undo the remaining straps attaching the seat to the legs
and the side of the bumper bar, slide the straps through
the hole in the ‘D’ ring.
To ret the seat, reverse this process.
EN