Magnum Dimensions MP-RFC User manual

MP-RFC Instruction Sheet
Part Number: 64-0076 Rev A 1
Sensata Technologies
2211 West Casino Road
Everett, WA USA 98204
www.Magnum-Dimensions.com
Figure 2, MP Enclosure with Router Attached to MP-RFC
MP-RFC
router front
cover
Introduction
The optional router front cover (MP-RFC) replaces the factory
installed top front cover, and allows the ME-RTR (router) to be
attached to the front of an MP enclosure. This optional front cover is
only available for those versions of the MP enclosure that have the
middle eight truss head screws.
Figure 1 shows the optional router front cover (MP-RFC). Figure 2
shows a router mounted on the front of an MP enclosure using the
optional router front cover.
Figure 1, MP-RFC
Router Front Cover
ME-RTR
(Router)

MP-RFC Instruction Sheet
2 ©2015 Sensata Technologies
Figure 3, MP-RFC Installation
Figure 4, Attaching the Router to the MP-RFC
Step A Step B Step C
MP-RFC
Truss head
screws (x4)
Front cover
screws (x8)
Installation
1. Remove the eight screws that hold the front cover to the MP
enclosure (Step A below).
2. Remove the four truss head screws (Step B below) that secure
the top cover to the front cover.
3. Replace the top cover with the MP-RFC (Step C below), and
re-attach to the front cover with the four truss head screws
removed in Step 2.
4. Attach the router to the MP-RFC (Figure 4) using the four
supplied screws (8-32 x 1/2 Phillips screws).
5. Route any stacking/communication cables from the enclosure
through the existing spaces in the MP-RFC and connect to the
attached router. Note: With some installations, it may be easier
to connect the cables prior to attaching the ME-RTR (router).
6. Using the same eight screws that were removed when detaching
the front cover (Step 1), secure the front cover to the enclosure.
7. Attach the bezel cover to the router.