Malouf Structures POWER-FLEX 4 User manual

POWER-FLEXTM

OWNER’S MANUAL
POWER-FLEXTM

OWNER’S MANUAL
POWER-FLEXTM
• This product is for use on a standard
• Always use a electrical surge protection device with this This product should
be plugged directly into the surge protection device and the surge protection device should be
plugged directly into a wall
• Only connect this product to a properly grounded
• Always unplug this bed from the electrical outlet before cleaning or
• Never operate with a damaged cord or Keep the cord away from this product’s moving
• Keep the cord away from heated
• Do not use this product
• Carefully remove Take care not to damage the bed frame or any included
• Carefully read and follow the set up and installation instructions included with the
i
WARNINGS
ELECTRICAL
• Immediately dispose of all packing materials that may pose a suffocation risk.
• Do not allow children or pets to play on or under the bed. Children should not operate this product
without adult supervision.

ii
PACEMAKERS
SOUND
• Some pacemakers may detect motion by this product as a false sense of movement or exercise. This may or may not affect
your pacemaker. Talk to a physician to address any concerns.
•
•
• The massage function will emit an audible tone during The volume of this tone is directly related to the location
and For a bed placed on wooden flooring may increase the audible tone of the massage
where a bed placed on carpet may emit a
• This product is designed solely for in-home use and not as a hospital bed. The product has not been tested to
meet hospital standards. Do not use with oxygen or other flammable gasses.
Power-Flex 4

iii
PRODUCT
RATINGS
• Power-Flex 4
con an Excee shorten
life
• This product is designed to have no maintenance requirements by the Please do not open
any motor alter the modify the or change the product in any way as
it will void the
•
•
OWNER’S MANUAL
POWER-FLEXTM

iv
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
• Operates on GHz frequency
• To comply with the FCC RF exposure requirements, no change to the antenna or the device is permitted. Any change
to the antenna or the device could result in the device exceeding the RF exposure requirement and void user’s right
to operate the device.
For any questions or concerns regarding this product please contact ®

v
CONTENTS
Electrical Components and Backup Battery
Overview
Assembly
Massage
Synchronizing Two Bases
Test All Functions / Additional Help
Warranty Information
Remote Control
OWNER’S MANUAL
POWER-FLEXTM

vi

1
OVERVIEW
Power-Flex 4
OWNER’S MANUAL
POWER-FLEXTM

2
Control Box
Retainer Bar
Head Motor
Head Tilt Motor
USB Ports
Foot Motor
Wireless Remote Control
( ) -Inch Legs
(6) End Caps
() -Inch Legs
( ) Leg Sets Included
with King Size
Underbed
LED Light
Underbed
LED Light
Back Massage
Foot Massage
Power Supply Box
Power Cord
Sync Cable
(included with Split sizes only)

3
ASSEMBLY
Place the box in the room the bed will be used with the bottom of the box facing
Carefully remove the binding straps and packaging taking care not to puncture the
box with any sharp
Remove the bed base from the box and set mattress side down on the floor
Remove all plastic and zip All components and parts are located in the underside of
the Remove attached parts and set aside in preparation for assembly
Check to make sure all parts have been included and are not damaged
A minimum of two people are required to assemble this adjustable
Open box on the floor in the flat bottom facing to avoid
OWNER’S MANUAL
POWER-FLEXTM

4
A
B
King Size Only

5
ASSEMBLY
Hand tighten all six legs for King into the bed frame until Note
that there are two location options for each an outside placement or an inside
Tighten the legs in the location of your maintaining a consistent
inside or outside location Take care not to over tighten
To reach a height from floor to top of deck one should use a
leg
Install the power cord by connecting the cord jack to the receptacle on the bed
motor Be sure the cord is connected completely and
OWNER’S MANUAL
POWER-FLEXTM

6
Foot
Head
Leg Positions
AB
C
Middle Leg on King Size Only

7
ASSEMBLY
With two to four the bed by the metal frame and turn it over so the
mattress side is facing up Take caution not to the bed with the
or to use the legs as pivot points causing angled pressure as this may cause
Move the bed to the desired
OWNER’S MANUAL
POWER-FLEXTM

8
A

9
ASSEMBLY
To install the mattress retainer insert one end of the retainer bar in its respective
slot until it slides fully into place Flex retainer bar to insert the other
end on the other
Plug the power cord into the wall outlet and run the test on pages of this
You may want to familiarize yourself with the remote control functions
prior to running the
OWNER’S MANUAL
POWER-FLEXTM

10
A

11
REMOTE
CONTROL Overview
Power-Flex 4
OWNER’S MANUAL
POWER-FLEXTM

12
B
A
Remote Lock/Unlock
Timer Setting &Massage Off
Back Massage On/Intensity
Massage Off/Recall Last Setting
Head Up/Down
*Head/Foot Up
*Head/Foot Down
Foot Massage On/Intensity
Massage Type
massage
Programmable Positions
Foot Up/Down
Preset Flat Position
Underbed Lights
*Head Tilt Up
*Head Tilt Down
Preset Anti Snore Position
Preset Lounge Position
Preset Zero Gravity Position
Preset TV/Read Position