Mammut ELEMENT Barryvox User manual

Version 1.0 2012
USER MANUAL
Find the Barryvox Reference Hand ook at:
www.mammut.ch/BarryvoxManual
Head Office:
Mammut Sports Group AG
Birren 5
5703 Seon, Switzerland
Tel. [phone]
[email protected]
North America:
Mammut Sports Group Inc.
135 Northside Drive
US-Shelburne, VT 05482
Tel. [phone]
[email protected]
Your Barryvox®will not protect you against avalanches!
As a winter outdoor enthusiast, you must consider all possible avalanche prevention measures
and plan your trips carefully. Companion rescue – the worst case – must be practiced fre-
quently.
Technical Data Digital device with 3 antennas / Transmit frequency: 457 kHz / Maximum
range: > 60 m / Search strip width: 50 m / W-Link communication channel / Alkaline batteries:
3 x AAA 1,5 Volt / Battery life: typical 250 h SEND, min 200 h in SEND mode followed by 1 h
in SEARCH / Dimensions: 113 x 75 x 27 mm / Weight: 210 g (incl. Batteries).
Type/Model: ELEMENT Barryvox®A10010-10000 (W-Link 868 MHz), A10012-10000 (W-Link
915 MHz), A10013-10000 (W-Link off).
Technical data and specifications are subject to change without notice.
© Copyright by Mammut Sports Group AG and Genswein. All rights reserved.
Barryvox Service Centers, Registration and Additional Resources
For additional information on avalanche rescue, avalanche theory, the registration of your
Barryvox and the official Barryvox Service Centers please visit www.mammut.ch/Barryvox.
The following documents are available for the Barryvox Transceivers at
www.mammut.ch/BarryvoxManual
• Barryvox Legal and Regulatory Guide • Barryvox Reference Handbook
• Barryvox Emergency Plan • Barryvox Application Safety Guide
• Barryvox User Manual
It is absolutely necessary that you read this safety relevant information and familiarize yourself
with the device before you use it in avalanche terrain!

Setup and Carrying Positions
Batteries, Ha dli g a d Mai te a ce
Only use alkaline LR03/AAA batteries. Always replace all 3 batteries and use new batteries of
the same type. Never use rechargea le atteries and always replace all the batteries at the
same time. When not using the transceiver for an extended period of time (summer), remove the
batteries.
Handle your Barryvox with care. Do not drop it on the
ground and avoid mechanical shocks.
Avoid having other electronic devices (e.g. mobile phones,
radios, headlamps, cameras), metal o jects (pocket knives,
magnetic buttons), or other transceivers close to your running
avalanche transceiver.
To ensure the proper performance of the transceiver, it is
highly recommended that you send your device to an official
Barryvox service center once every three years for a func-
tional test. Press the key on the side during shut-down to view the recommended date of the
next check.
Stick the emergency plan on the back of the battery compartment lid.
Carryi g System a d Carryi g Positio s
Regardless of the carrying position, the display should always face your body!
Carrying System (Recommended Carrying Position)
The carrying system has to be put on your innermost layer of clothing prior to beginning the trip
(see illustration on the base plate of the carrying system) and has to be worn on your body for
the duration of the trip. The transceiver shall always remain covered y one layer of cloth-
ing. Using the red hook on the wrist loop the device should always remain anchored to the base
plate of the carrying system.
Carrying the Transceiver in a Pocket
If you carry the Barryvox in a secure pant pocket, the zipper must remain closed for the duration
of the trip. If possible, attach the wrist loop to your pants or secure it around your belt.
1
2
Before a party takes off, the transceivers of all party members
must be checked. The group members switch their trans-
ceivers to SEND.
The group leader switches his device to “group check” by turn-
ing it from OFF into the SEND and presses the lateral key within
the first 5 seconds.
Now, the group leader checks the device of each participant:
The test is successful if you can clearly hear eep sounds
from each participant's transceiver within the range indicated
on the display.
The test distance is 1m, the spacing etween the partic-
ipants is 2m. The indicated test distance must not e
shortened. In case the device discovers that the distances are
too short a distance warning and alarm sound warns the user.
If your ELEMENT Barryvox®detects that the transmit frequency
of the tested device is not within the normative regulations, an
«E6» warning message will be shown. In this case, repeat the
test with 5m distance between the participants to identify the
defective transmitter. Such devices must be checked/repaired
by the manufacturer.
When all devices of the participants have been tested, the
group check is finished. The group leader switches his device
now as well to SEND by pressing the key on the side.
How to solve a pro lem: If no tone is heard within the in-
dicated range, the device may not be used.
1. Check if the device is switched to SEND.
2. Replace the batteries.
3. Have the device checked by the manufacturer.
Mai Switch OFF / SEND / SEARCH
Start-Up / Self- a d Battery Test
Si gle Group Check (GROUP CHEC )
Touring
OFF
OFFSEND SEARCH
OFFSEND SEARCH
OFF -> SEND SEND -> OFF
OFFSEND SEARCH
SEARCH
OFFSEND SEARCH
SEND -> SEARCH SEARCH -> SEND
While starting, the device conducts a selftest. If the self-test fails, an error
message is displayed for 20 seconds along with an acoustic warning. If the
battery power falls below 20% or the battery icon is displayed, the batteries
must be replaced as soon as possible!
Mode SEND
The SEND mode is the normal operating mode outdoors or in all other sit-
uations in which there is a risk of avalanches. Each time the SEND mode
has been activated, this is confirmed by a triple beep sound. Each individ-
ual signal pulse is tested. If the test is successful, this is confirmed by a
blink of the red SEND-Control LED. The LCD display is automatically de-
activated in the SEND mode.
Always make sure that the switch locks into position mechanically to avoid an undesired
change of mode.
Perso al Rescue Equipme t
Avalanche Transceiver + Shovel + Probe
The additional use of a Mammut or Snowpulse Airbag increases the chance to stay on the
surface and therefore considerably reduces the risk of a complete burial.
GROUP
CHECK SEND

310
Mar k
Signal Search Fine Search Pinpointing Marking & Multiple SearchCoarse Search
Multiple Burials
Continue the search for further buried sub-
jects by marking the ones previously found.
Signal Search
• Search avalanche surface systemati-
cally.
• During signal search, the rescuer has
the visual focus on the surface of the
debris in order to be able to see body
parts or objects protruding the snow
surface. The first signal is indicated by
a distinct double beep sound.
Optimization of Range
To optimize the range, rotate the trans-
ceiver slowly around all axes. Hold the
device with the loudspeaker facing your
ear sidewise of your head.
Emergency Plan
The emergency plan (klistermärke på enhetens
baksida) shows the elementary steps for a suc-
cessful companion rescue.
Depending on the situation at hand, the procedure
must be adapted.
1. Obtain an overview
2. Turn OFF all transceivers which are not used
for the search
3. At least one rescuer conducts a transceiver
search, while looking and listening
at the same time
4. Transceiver search finished;
all transceivers to SEND
5. Excavate – First Aid – Call for help
«Large distance to the target»:
Fast search speed, low search precision
«Landing»:
Transceiver on the snow surface,
move slowly,
high search precision.
Coarse Search
• Use the device in a calm and concentrated
manner. Avoid jerky movements.
• Hold the beacon horizontally in front of you.
• Watch the distance and direction information
on the display.
• Move in the direction indicated by the arrow.
• If the distance increases, then you are moving
away from the victim. Continue the search in
the opposite direction.
• The closer you approach the victim, the slo-
wer and more concentrated your movements
should be.
Fine Search
During fine search hold the transceiver directly
above the snow surface! Proceed in a straight line
until you reach the point of the smallest distance
reading and use the shovel to mark this spot as
a visual reference for the probing spiral.
Pinpointing
Exact pinpointing with the avalanche probe. If the buried subject ist hit
with the probe pole, the pole is left in the snow and the buried subject
marked as found by pressing the key.
Do not use the 3-Mark function until the location has been confirmed
by a probe hit and do not hold the device on the snow surface to mark
the buried subject.
LAST SE EN POINT
LAST SE EN POINT
UNKNO WN
LAST SE EN POINT
UNKNOWN
MULTIPLE R ESCUERSSINGL E RESCUER
Search
«Signal» «Fine Search» «Pro e Hit»
RESCUE ORGANIZATION: EVENT DRIVEN, LOUD AND CLEAR COMMUNICATION
Auto-Revert to SEND
Search Suspe sio
Without user interaction
the device will automati-
cally revert from SEARCH
to SEND after 8 minutes.
Prior to reverting, the de-
vice will sound an alarm.
Reverting can be avoided if the key is pressed
within 30 seconds of the alarm.
In case rescuers are buried in a second ava-
lanche, this function allows them to be located
using transceivers.
During the search for mul-
tiple subjects, signals may
overlap making it impossi-
ble to analyze the signal of
a single buried subject.
The rescuer has to interrupt the search process
temporarily to avoid deviating from the optimal
search path. The ELEMENT Barryvox®will indicate
the necessity to suspend the search by displaying
the «Stop» symbol. Stand still, and do not move
until the word «Stop» disappears, at which time
you can continue to search.
The + sym ol indicates that signals are received
from additional buried subjects that cannot be
isolated and entered in the list of buried subjects
yet. Turn off the transceivers of the buried sub-
jects already found as soon as possible to simplify
the isolation of the remaining signals.
«Airport visible»:
Slow down considerably
The transceiver search is compara le
to the landing of an airplane!

Rescue
Excavati g the Buried Subject
Digging must e practiced, as it uses y far the iggest amount of time.
Cut out locks of snow with the shovel.
The V-Shaped Snow Conveyor Belt:
• Position diggers in a «V» formation
• The first two rescuers are in a distance of one shovel
length from each other, all additional rescuers are in a
distance of two shovel lengths from each other.
• Length of «V»:
· Flat terrain: 2x burial depth
· Steep terrain: 1x burial depth
• Amount of rescuers: 1 per 80 cm length of «V»
• Rescuer at the tip of the “ V” digs alongside the probe to
the buried subject
• Diggers rotate frequently (approx. every 4 min) clockwise
on command of the rescuer at the tip of the «V».
• Cut out blocks of snow with the shovel by stepping on
the shovel blade which is held perpendicular to the
surface. Apply a half-moon shaped cutting pattern.
Position yourself facing the open end of the “V”, cut
the first half-moon without pulling back on the shovel
shaft. When cutting the second and subsequent half-
moons, pull the shovel shaft gently backwards after you
have cut the block so that it pops out. To cut the next
half-moon, step backwards toward the probe, like this,
you do not step on the pre-cut blocks.
In multiple urial situations, the transceiver of a rescued
su ject should e turned off as soon as possi le.
90°
80 cm