Map KF373 Installation manual

Programming instructions for KF373 & KF374
Key blade requires cutting by your local locksmith.
Key blade must be cut from key blade tip to remote head
Transponder requires programming with scan tool. Please contact your local
Mitsubishi dealer or workshop to program transponder in MAP part no: KF373 &
KF374.
REMOTE PROGRAMMING PROCEDURE:
1. Insert key into the ignition (leave in the Lock position).
2. Insert OBD Programmer in to the vehicles OBD2 port located beneath the dash.
3. Press the hazard lights switch 6 times rapidly.
If performed correctly, the door locks will cycle. You are now in learn mode.
4. Press the Lock button on new remote 4 times. Door locks cycle when accepted.
5. Repeat step 4 for any other remotes including old remotes.
6. Remove OBD Programmer from the vehicles OBD port and remove the key from
the ignition to exit learn mode.
KF373 KF374
Blade
cutting
direction
Blade
cutting
direction

WARNING! This remote contains a button/coin cell battery. If swallowed, a lithium battery can cause severe or fatal
injuries within 2 hours or less. Keep batteries out of reach of children at all times whether they are new or used. If
you think batteries may have been swallowed or placed inside any part of the body, seek medical attention
immediately or contact the Australian Poisons Information Centre on 13 11 26 or New Zealand National Poisons
Centre on 0800 764 766.