Markwort C-FLAP Quick Mount User manual

For use with the C-Flap and batting helmets
Boombah DEFCON®, Boombah DEFCON® Sleek & Rawlings®
Coolflo® (RCFH)*
Disclaimers and Notes:
Assembly Instruction and the C-Flap® Quick Mount are designed for
use with the C-Flap Cheek & Jaw Protector and approved batting
helmets only. Please visit markwort.com for more information.
*Rawlings Coolflo® requires removal of the snap-on feature located
on the lowest pre-drilled hole by drilling it on the side on which the
C-Flap® will be assembled. Then, the ear flap foam must be carefully
peeled, not completely, only to remove the insert (nut) located inside
the lowest pre-drilled hole. A tee nut, included with the C-Flap® must
then be placed inside this pre-drilled hole, allowing it to be used for
fastening the system.
Front side of C-Flap® Quick Mount
with hole indications
Left side of Boombah/Rawlings®
helmet with hole indications
Extruded view of helmet, Quick Mount, and
C-Flap® protective system assembly
Patent Pending
Designed and Manufactured by Titon Corp., S. A. in Guatemala.
Distributed by Markwort Sporting Goods Company Saint Louis, Missouri 63132.
Please visit markwort.com for more C-Flap® and Quick Mount content.
3
2
1
6
5
4
A
B
C

Place tee nuts on holes 4 & 6. Flanges
must be located on the back side of the
C-Flap® Quick Mount.
Align holes A-2 &C-5. Place a screw on hole 5 and drive it clockwise.
Do not overtighten the screws as this might pre-stress
the C-Flap® Quick Mount, affecting its performance.
Place longer screw on hole 2 and place shorter screws on the tee nuts
and drive themclockwise to clamp the C-Flap® to the C-Flap® Quick
Mount. Do not overtighten screwsas this might pre-stress the parts
affecting their performance.
Align C-Flap® openings with holes 2, 4 & 6.
Holes 4 & 6 contain tee nuts.
1/5 2/5 3/5
4/5 5/5
Copyright June 2019