Masimo rainbow Series User manual

© 2016 Masimo Corporation
rainbow® Series Patient Cables
For Pulse Oximeters with rainbow Technology
Images 2
en English 3-5

24523G-eIFU-0516
rainbow® Series Patient Cables
For Pulse Oximeters with rainbow Technology
Fig. 3
1
2
1
Fig. 4
Fig. 5 Fig. 6
2
1
2
3
1
3
Fig. 1 Fig. 2

34523G-eIFU-0516
en
rainbow® Series Patient Cables
For Pulse Oximeters with rainbow Technology
DIRECTIONS FOR USE
Reusable
LATEX
PCX-2108A
02/13
Not made with natural rubber latex Non-Sterile
INDICATIONS
The rainbow® Series Patient Cable Series have the same indications for use as the applicable sensors. Please see the
compatible sensor’s directions for use for indications for use and prescribed information.
DESCRIPTION
The rainbow Series Patient Cables are used with Masimo® rainbow and M-LNCS™ Sensors.rainbow Series Patient Cables
are for use only with devices containing Masimo rainbow SET™ technology Version 7.1 or higher or licensed to use
rainbow compatible sensors. Consult individual oximetry system manufacturers for compatibility of particular sensor
and device models. Each device manufacturer is responsible for determining whether their devices are compatible with
each sensor model.
rainbow Series Patient Cables were veried using Masimo rainbow SET technology.
WARNING: Masimo sensors and cables are designed for use with devices containing Masimo SET® or Masimo rainbow
SET oximetry or licensed to use Masimo sensors.
WARNINGS, CAUTIONS, AND NOTES
• Always refer to the oximeter module operator’s manual for complete instructions or additional instructions.
• Ensure the cable is physically intact, with no broken or frayed wires or damaged parts. Visually inspect the cable
and discard if cracks or discoloration are found.
• All sensors and cables are designed for use with specific monitors. Verify the compatibility of the monitor, cable
and sensor before use, otherwise degraded performance and/or patient injury can result.
• Carefully route patient cable to reduce the possibility of patient entanglement or strangulation.
• Failure to properly connect the sensor or the oximeter module to the cable will result in intermittent readings,
inaccurate results, or no reading.
• To avoid damage to the cable, always hold it by the connector rather than the cable when connecting or
disconnecting either end.
• To prevent damage, do not soak or immerse the sensor or cable in any liquid solution. Do not attempt to sterilize
the cable or sensor.
• Do not attempt to reprocess, recondition or recycle Masimo sensors or patient cables as these processes may
damage the electrical components, potentially leading to patient harm.
• Caution: Replace the patient cable when a Replace cable or a persistent low SIQ message is displayed when the
patient monitoring time is exhausted.
• Note: The patient cable is provided with X-Cal™ technology to minimize the risk of inaccurate readings and
unanticipated loss of patient monitoring. The cable will provide 17,520 hours of patient monitoring time. Replace
the cable when the patient monitoring time is exhausted.
CABLE AND SENSOR SELECTION
NOTE: The maximum length for the sensor, cable and extension cable combination is 15 feet.
Refer to the table below for correct examples:
Cable Sensor
Length 18 inches 3 feet 6 feet
1 ft Yes Yes Yes
4 ft Yes Yes No
12 ft No No No

44523G-eIFU-0516
INSTRUCTIONS
A. Connect the rainbow patient cable to the Device
1. Connect the device connector of the patient cable to the mating connector of the device.
2. Ensure the patient cable connector is fully engaged with the device. A tactile or audible click of connection should be
heard.
B. Connect the rainbow patient cable to the Sensors
Connect the rainbow patient cable to an M-LNCS disposable sensor:
1. Refer to Fig. 1. Orient the sensor connector to the patient cable connector as shown.
2. Refer to Fig. 2. Insert the sensor connector completely into the patient cable connector until it locks in place as shown.
Connect the rainbow patient cable to a rainbow disposable sensor:
1. Refer to Fig. 3. Orient the sensor connector (1) to patient cable connector (2) as shown.
2. Refer to Fig. 4. Insert the sensor connector (1) completely into the patient cable connector (2) until it locks in place as
shown.
Connect the rainbow patient cable to a reusable M-LNCS or a reusable rainbow sensor:
1. Refer to Fig. 5. Orient sensor connector (1) to patient cable connector (2) as shown.
2. Refer to Fig. 6. Insert the sensor connector (1) completely into the patient cable connector (2) until it locks in place..
C. Disconnecting the rainbow patient cable from the Sensors
NOTE: Pull on the connectors only, do not pull the cables.
Disconnect the M-LNCS disposable sensor:
1. Refer to Fig. 2. Pull firmly on the sensor connector to remove it from the patient cable.
Disconnect the rainbow disposable sensor:
1. Refer to Fig. 4. While holding the sides of cable connector, place thumb on latch (1) and press to disconnect sensor
connector from patient cable connector.
Disconnect the reusable M-LNCS or reusable rainbow sensor:
2. Refer to Fig. 5. While holding the sides of patient cable connector (2), lift sensor connector cover (3) from patient cable
connector (2). Disconnect sensor connector (1) from patient cable connector (2).
CLEANING
1. Remove the sensor from the patient and disconnect it from the patient cable.
2. Clean the surface of the cable by wiping it with a 70% isopropyl alcohol pad.
3. Wipe all surfaces of the cable.
4. Saturate another cloth or gauze pad with sterile or distilled water and wipe all surfaces of the cable.
5. Dry the cable by wiping all surfaces with a clean cloth or dry gauze pad.
CAUTION:
• Do not immerse the connectors on the cable in any liquid solution.
• Do not sterilize by irradiation, steam, autoclave, or ethylene oxide.
• Do not clean with chemicals not approved above.
ENVIRONMENTALS
Operating Temperature 41°F to 104°F (5°C to 40°C)
Storage Temperature -40°F to 158°F (-40°C to 70°C)
Relative Humidity 0% to 95% non-condensing
COMPATIBILITY
rainbow series patient cables are intended for use only with devices containing Masimo SET or Masimo rainbow SET
technology and with compatible sensors. Consult individual oximetry system manufacturers for compatibility of
particular devices and sensor models. Each device manufacturer is responsible for determining whether their
devices are compatible with each sensor and cable model. Use of this cable with other devices may result in no or
improper performance.
For Compatibility Information Reference: www.Masimo.com
WARRANTY
Masimo warrants to the initial buyer only that this product, when used in accordance with the directions provided with the
Products by Masimo, will be free of defects in materials and workmanship for a period of six (6) months. Single use products
are warranted for single patient use only.
THE FOREGOING IS THE SOLE AND EXCLUSIVE WARRANTY APPLICABLE TO THE PRODUCTS SOLD BY MASIMO TO BUYER.
MASIMO EXPRESSLY DISCLAIMS ALL OTHER ORAL, EXPRESS OR IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION
ANY WARRANTIES OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSE. MASIMO’S SOLE OBLIGATION AND BUYER’S
EXCLUSIVE REMEDY FOR BREACH OF ANYWARRANTY SHALL BE, AT MASIMO’S OPTION, TO REPAIR OR REPLACETHE PRODUCT.

54523G-eIFU-0516
WARRANTY EXCLUSIONS
This warranty does not extend to any product that has been used in violation of the operating instructions supplied with
the product, or has been subject to misuse, neglect, accident or externally created damage. This warranty does not extend
to any product that has been connected to any unintended device or system, has been modied, or has been disassembled
or reassembled. This warranty does not extend to sensors or patient cables that have been reprocessed, reconditioned or
recycled.
IN NO EVENT SHALL MASIMO BE LIABLE TO BUYER OR ANY OTHER PERSON FOR ANY INCIDENTAL, INDIRECT, SPECIAL OR
CONSEQUENTIAL DAMAGES (INCLUDING WITHOUT LIMITATION LOST PROFITS), EVEN IF ADVISED OF THE POSSIBILITY
THEREOF. IN NO EVENT SHALL MASIMO’S LIABILITY ARISING FROM ANY PRODUCTS SOLD TO BUYER UNDER A CONTRACT,
WARRANTY, TORT OR OTHER CLAIM EXCEED THE AMOUNT PAID BY BUYER FOR THE LOT OF PRODUCTS INVOLVED IN
SUCH CLAIM. IN NO EVENT SHALL MASIMO BE LIABLE FOR ANY DAMAGES ASSOCIATEDWITH A PRODUCT THAT HAS BEEN
REPROCESSED, RECONDITIONED OR RECYCLED. THE LIMITATIONS IN THIS SECTION SHALL NOT BE DEEMED TO PRECLUDE
ANY LIABILITY THAT, UNDER APPLICABLE PRODUCTS LIABILITY LAW, CANNOT LEGALLY BE PRECLUDED BY CONTRACT.
NO IMPLIED LICENSE
Purchase or possession of this rainbow patient cable does not carry any express or implied license to use this cable with any
device that is not an authorized device or separately authorized to use rainbow patient cables.
CAUTION:
FEDERAL LAW (U.S.A.) RESTRICTS THIS DEVICE TO SALE BY OR ON THE ORDER OF A PHYSICIAN.
For professional use. See instructions for use for full prescribing information, including indications, contraindications,
warnings, precautions and adverse events.
The following symbols may appear on the product or product labeling:
SYMBOL DEFINITION SYMBOL DEFINITION
i
GR-10184A
Consult Instructions for Use Separate collection for electrical and
electronic equipment (WEEE).
GR-10199B
(blue background)
Follow Instructions for Use LOT Lot code
Title: Graphic, Manufacturer Symbol, Masimo
PCX-1986
Revision A
DRO-23934
05/09
Manufacturer REF Catalogue number (model number)
Date of Manufacture Masimo reference number
Use By YYYY-MM-DD Body weight
NON
STERILE
LATEX
Title:Graphics, Sensor/Cable symbols, 03/06
GR-14231
DRO-13914
-40 C
+70 C
+1060 hPa - +500 hPa
795 mmHg - 375 mmHg
5%-95% RH
5%
95%
%
Do not discard >Greater than
Non-Sterile <Less than
LATEX
PCX-2108A
02/13
Not made with natural rubber latex Storage Humidity Range
R
x
Only
Federal law (USA) restricts this device to
sale by or on the order of a physician
+1060 hPa - +500 hPa
795 mmHg - 375 mmHg
Storage Temperature Range/
Storage Altitude Range
Mark of Conformity to European Medical
Device Directive 93/42/EEC Keep Dry
EC REP Authorized representative in the European
community
Atmospheric Pressure Range
Do not use if package is damaged
Instructions/Directions for Use/Manuals
are available in electronic format @
http://www.Masimo.com/TechDocs
Note: eIFU is not available for CE mark
countries.
Patents: http://www.masimo.com/patents.htm
Masimo, SET, , and rainbow are federally registered trademarks of Masimo Corporation.
M-LNCS, rainbow SET and X-Cal are trademarks of Masimo Corporation.

© 2016 Masimo Corporation
Masimo Corporation
40 Parker
Irvine, CA 92618
USA
www.masimo.com
Manufacturer: EU Authorized Representative for Masimo
Corporation:
EC REP
MDSS GmbH
Schigraben 41
D-30175 Hannover, Germany
4523G-eIFU-0516
Table of contents
Other Masimo Cables And Connectors manuals
Popular Cables And Connectors manuals by other brands

Schill
Schill FT 150 Installation and operating instruction

HEATIZON SYSTEMS
HEATIZON SYSTEMS Cozy Heat SR Design & Installation Manual

Parker
Parker Phastite PH-4-PS installation manual

Echogear
Echogear EGAV-CMIWG1 owner's guide

Leviton
Leviton CONTECH LIGHTING LPU2121 installation instructions

Exsys
Exsys EX-2311-2IS manual

Alto
Alto ALTO LINK user manual

AV TOOL
AV TOOL AVT-6114 instruction manual

PCB Piezotronics
PCB Piezotronics 4106-124-01A Installation and operating manual

Wentronic
Wentronic clicktronic 44928 user manual

Leviton
Leviton 47690-04C installation instructions

National Instruments
National Instruments BNC-2090A user manual