Masimo Sleep Manual

1
2
3
Apply Sensor
Apply the sensor to your wrist
and finger and insert the chip.
See instructions on back.
Pair Sensor
Confirm that Bluetooth® is enabled
on mobile device. Follow on-screen
instructions to pair Masimo Sensor.
Once paired, tap Start Sleep Session.
Sleep App
Displays oxygen level, pulse
rate, and respiration rate
(mobile device not included)
page 1 of 2
Set up Sleep App
Confirm mobile device is
connected to the internet.
Download and launch
Masimo Sleep App and
follow instructions.
Warning: Do not self-diagnose or self-medicate on the basis of the
measurements. Always consult your doctor.
© 2020 Masimo. All rights reserved. 301742/10844B-0920
Masimo Sensor
Disposable sensor measures oxygen level, pulse rate
and respiration rate and lasts 7 consecutive nights.*
Compatible with most mobile devices.
Visit masimo.com/sleep to see
full list of supported devices,
purchase additional sensors
and view other resources,
including videos and instructions.
GET TO KNOW YOUR SYSTEM
see back for sensor application
GETTING STARTED
Masimo Chip
Reusable chip snaps
into the sensor and
communicates with
the Sleep App
Replacement Tapes
Additional tapes for
replacement as needed
Warning: CHOKING HAZARD Contains small parts
* Based on 96 hours of sensor battery life. Remove Chip between uses.
Setup Instructions
Masimo ™

HOW TO APPLY AND USE YOUR SENSOR
3. Place sensor on wrist as shown and
carefully thread the tip of the
strap through the open
red loop
4. Wrap the loose end of the
strap around your
wrist and press
1. Remove sensor from pouch 2. Peel off yellow label
to activate battery
1. Insert the chip into the open
compartment on the sensor
1. Remove used tape
from sensor
2. Attach new tape in same
direction as used tape
3. Attach sensor to finger 4. Peel the remaining
tape off backing
2. Press down on the
chip to secure
page 2 of 2
1. Remove part of the plastic film
and place star ( ) on top of
fingernail of ring finger
4. Remove plastic film and
continue to wrap tape
around finger
3. Squeeze top and
bottom of finger
to secure tape
5. Adjust cable to
comfortable length
D. Changing the Replacement Tape
Visit masimo.com/sleep to see full
list of supported devices, purchase
additional sensors and view other
resources, including videos and
instructions.
2. Wrap tape around finger so black
square ( ) is on finger pad directly
across from ( )
A. Sensor Setup
B. Apply Sensor
C. Insert Chip
Listen for click
to confirm
chip placement
Look for light to
confirm chip
connection to sensor