Mastech MS8340B User manual

CAT III
USER'S MANUAL

designed to meet EN 61010-1, EN 61010-2-033,
EN 61010-031 CAT III 1000V over voltage category and
double insulation.The entire outer suiface of the case has
been formed with thermo plastic elastomer, giving the
main body,though downsized,high resistance against
the shock of a drop.
Caution, possibility of electricshock
Both direct and alternating current
Earth (ground) TERMINAL
Caution
Equipment protected throughout by double
insulation or reinforced insulation
Applicable to test and measuring circuits connected to
the distribution part of the building's low-voltage MAINS
installation.
CAT III

Safety Rating: IEC61010-1 CAT III 1000V
ersupply:1.5VBattery(AAType)x4
Dimension(LxWxH)&Weight: Approx.205x102x58mm.
Weight: Approx.390g.
Environmentalcondition:
(1)indooruse;(2)Altitudeupto2000meter
Fuseprotertion:
(μAandmA position) Fuse:FF250mA/1000V
(Aposition)Fuse:FF10A/1000V
o Power–OFF, maybepoweronthemeter
whenanyof

To avoid electric shock, make sure the probes are
disconnected from the measured circuit before removing the
rear cover. Make sure the rear cover is tightly screwed before
using the instrument. Do not mix old and new batteries. Do
not mix alkaline, standard (carbon-zinc), or rechargeable
(ni-cad, ni-mh, etc) batteries.
(F1: F 10A H 1000V, F2: F 250mA H 1000V)
6.If insulation on probe is damaged, replace it.
Use meet EN 61010-031 standard, rated CAT III 1000V, 10A
or better probe.