Matsing MS-12.6DB180 User manual

TABLE OF CONTENTS:
BEAMS & CONNECTORS:
Plan View Resultant Beam And Connector Layout
HB and LB Connector
Connector Ports Table
PATTERN DIAGRAM
High Band
Low Band
MANUAL TILT ADJUSTMENT
TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
Installation using a crane
Lifting the Antenna
Revision History:
[email protected] www.matsing.com 1 / 6
12 Feb 2019
Ray Ling
Patrick Yeo
MS-12.6-IM-001
0
INSTRUCTION MANUAL MS-12.6DB180
MS-12.6DB180
Instruction Manual
Date
Prepared by
Approved by
Document nos
Revision
1.00
1.10
1.20
1.30
email:
website:
Page
Date
Description
Revised by
Revision
nos.
2.20
2.00
2.10
4.30
4.31
4.00
4.10
4.20
3.00

BEAMS & CONNECTORS:
Plan View Resultant Beam And Connector Layout
HB and LB Connector
2 / 6
1.10
1.20
Page
1.00

Connector Ports Table
PATTERN DIAGRAM
High Band
3 / 6
1.30
Page
2.00
2.10

Low Band
MANUAL TILT ADJUSTMENT
4 / 6
There are 2 ways of adjustment: 1. By Hand turning. 2. Use Screw Driver as shown in pictured
below. When using this method, please be extra careful not to adjust tilt beyond the 0-15° tilt
range, as there is no restrictor on the tilt knob.
2.20
3.00
Tilt can be adjusted up to 15° on the antenna for each 20° sector (combination of 2 high band
beams, 1 low band beam). For example Beam 1,2 HB and Beam 1 LB can be tilted together (as
one sector), Beam 3,4 HB and Beam 2 LB can be tilted together as one sector and so on.
Page

TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
5 / 6
4.00
4.10
MS-6.3DB90
4
M12 x 15cm
8
MS-4.2DB60
4
M12 x 15cm
8
Page
MS-12.6DB180
6
M14 x 15cm
12
MS-8.4DB120
4
M12 x 15cm
8
Strictly comply to the Local authority and regulatory on Workplace Safety and Health Control
and Measure when moving and transportation of large or heavy equipment, appropriate
material handling machine should be use. (Risk Assessment apply for Forklift or Pallet Truck
Lifting)
4.20
Model
Bracket
Qty (pc)
Bolt & Nuts
Size
Bolts Set
(pc)
Important Notes:
End User is require
to
Custom-Make
the additional
supporting bracket
and tighten to the
existing Antenna
bracket to meet
the deployment
needs.
Tighten to the
pole with Bolt
& Nuts Sets

Installation using a crane
Lifting the Antenna
6 / 6
Strictly comply to the Local authority and regulatory on Workplace Safety and Health Control
and Measure when performing lifting of large or heavy equipment, appropriate material
handling machine should be use and only certified personal should perform the task. (Risk
Assessment require to apply for both Up-Lifting and Down-Lifting.)
4.31
The antenna has 2 hook points installed on the top frame (located slightly behind the center of
the sphere). These hooks are designed at the center of gravity point of the antenna. A cable,
rope can be securely fastened to the hooks and the antenna can be lifted using a crane or
forklift as pictured below.
Page
4.30