Matsing MS-8H60 User manual

TABLE OF CONTENTS:
BEAMS & CONNECTORS:
Plan View Resultant Beam And Connector Layout
Connector Details
Connector Ports Table
BEAM PATTERN
Horizontal Beam Pattern
Top Row Beam 1 - 4
Bottom Row Beam 5 - 8
Vertical Beam Pattern
TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
Installation using a crane
Lifting the Antenna
Antenna Installation
Antenna Leveling
Digital Level Gauge Calibration
Adjustment Requirement
Revision History:
[email protected] www.matsing.com 1 / 6
1.20
1.30
2.00
2.11
2.12
3.00
3.20
3.30
3.31
00
INSTRUCTION MANUAL MS-8H60
MS-8H60
Instruction Manual
Date
Prepared by
Approved by
Document nos
Revision
11 Jun 2021
Ray Ling
Pavel
MS-8H60-IM-001
1.00
1.10
2.10
2.20
3.10
3.41
3.43
3.40
3.42
Date
Description
Revised by
Revision
nos.
email:
website:
Page

BEAMS & CONNECTORS:
Plan View Resultant Beam And Connector Layout
Connector Details
Connector Ports Table
2 / 6
1.00
1.10
Page
1.20
1.30

BEAM PATTERN
Horizontal Beam Pattern
Top Row Beam 1 - 4
Bottom Row Beam 5 - 8
Vertical Beam Pattern
3 / 6
2.12
2.00
2.10
2.11
2.20
Page

TRANSPORTATION / INSTALLATION
Transportation (From Point to Point)
Bracket Mounting
4 / 6
3.10
Strictly comply to the local authority and regulatory on Workplace Safety and Health Control and
Measure when moving and transporting of large or heavy equipment.
Appropriate material handling machine should be used. (Risk Assessment applies for Forklift or
Pallet Truck Lifting)
180 (cm) Lens
6
M14 x 16cm
12
3.20
Lens Size (Model)
Bracket
Qty (pc)
Bolt & Nuts
Size
Bolts Set
(pc)
45, 60,90,120 (cm) Lens
4
M12 x 16cm
8
Page
3.00
Important Notes:
End User is required to CUSTOM-MAKE the additional supporting bracket and tighten it
Tighten to the
pole with Bolt

Installation using a crane
Lifting the Antenna
5 / 6
The antenna has 2 hook points installed on the top frame (located slightly behind the center
of the sphere). These hooks are designed at the center of gravity point of the antenna. A
cable, rope can be securely fastened to the hooks and the antenna can be lifted using a crane
as pictured below.
3.30
Strictly comply to the local authority and regulatory on Workplace Safety and Health Control and
Measure when performing lifting of large or heavy equipment, appropriate material handling
machine should be used and only certified personnel should perform the task. (Risk
Assessment requirement applies for both Up-Lifting and Down-Lifting.)
3.31
Page

Antenna Installation
Antenna Leveling
Digital Level Gauge Calibration
Adjustment Requirement
6 / 6
3.41
After the Antenna is mounted to the bracket, it is required to be adjusted to 0˚ (Zero Degree)
with ≤0.2˚ on 3 sides of the frame top level.(Rear, Right & Left=As shown in picture)
3.42
3.43
Page
With reference to Item 3.20 Bracket Mounting, End user is required to Custom-Make the
additional supporting bracket and tighten it to the existing Antenna bracket to meet the
deployment needs.
3.40