
14
32
B
AC
D
D
B
C
B
CA D
A
B1. When the seat is unlocked, the raptor is in attack mode and can strike at any time!
A. Push forward to unlock the seat.
NOTE: Vehicle will stop after the raptor attacks. Reset the seat to resume normal operation. If the seat
remains unlocked, push the vehicle forward until the seat becomes lockable.
Reset the seat after the attack.
B. Place the figures inside the vehicle. C. Attach the raptor.A. Push back to lock the seat.
Fits most figures. One figure
included, additional figure
sold separately, subject to
availability.
BATTERY SAFETY INFORMATION
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
FOR PRODUCT SOLD IN USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
Protect the environment by not disposing of this product or any batteries with household waste. This symbol
indicates that this product shall not be treated as household waste. Check your local authority for recycling
advice and facilities.
LICENSED PRODUCT
3
1
2
0
I
FNH12_0970
1100259558_DOM
SET UP
TO PLAY (BASIC CONTROLS)
BATTERY INSTALLATION
Requires 6 AA (LR6) alkaline batteries for the vehicle and 2 AA (LR6) alkaline batteries for the remote control. Replace batteries in the vehicle
or remote control if the vehicle begins to run slowly or does not respond. For longer life, use alkaline batteries. Dispose of batteries safely.
A. Unscrew the battery cover with a Phillips head screwdriver (not
included).
B. Install 6 AA (LR6) alkaline batteries (not included) with polarity (+/-) as
shown inside the battery compartment.
C. Replace battery cover and tighten screw.
VEHICLE REMOTE CONTROL
A. Unscrew the battery cover with a Phillips head screwdriver (not included).
B. Install 2 AA (LR6) alkaline batteries (not included) with polarity (+/-) as
shown inside the battery compartment.
C. Replace battery cover and tighten screw.
NOTE: Once batteries are installed, the remote control will always be “ON”
and will work the moment you use it.
(A) FORWARD
(B) REVERSE
(C) LEFT
(D) RIGHT
(1) ON (I) / OFF (0)
(2) BATTERY COVER
(3) STEERING ADJUSTER -
Adjust, if necessary, to keep
the vehicle running straight.
Jeep, the Jeep grille and related logos, vehicle model names and trade dresses are trademarks of FCA US LLC and used under license by Mattel, Inc.
© 2017 FCA. US LLC.
BFGoodrich® Tires Trademarks are used under license from Michelin.
FEATURES
2:
FORWARD REVERSE
FORWARD LEFT FORWARD RIGHT
A
REVERSE LEFT REVERSE RIGHT
B
B2. To escape the attack, drive toward an obstacle to knock off the raptor!
(1) When your vehicle starts to lose power, it may lose functionality
or performance. This means it's time for fresh batteries. Your vehicle’s running
time may change depending upon your driving style and driving environment.
(2) Radio interference can affect your vehicle's performance. Interference can be
caused by other RC vehicles running on the same frequency, electrical wires,
large buildings, or CB radios. Try to stay away from these!
(3) Point your remote control up and not down toward your vehicle. If your vehicle
gets too far away, it won’t work properly.
(4) Don’t store your vehicle near heat or in direct sunlight. Always turn switches
OFF and remove all batteries for storage.
(5) Don't drive your vehicle in sand or through water or snow. Do not immerse in
water. If your vehicle or remote control does get wet, wipe it with a towel, remove
batteries, and allow to dry completely overnight. Replace with fresh batteries before
next use.
(6) When exposed to an electrostatic source, the product may malfunction. To resume
normal operation, remove and re-install the batteries. This should reset your vehicle
and let you resume normal operation.
• NEVER drive your vehicle on streets! Streets are for real cars!
• DO NOT pick up the vehicle while it is in motion.
• Keep fingers, hair, and loose clothing away from the wheels while the vehicle is switched ON.
• Adult supervision is recommended while this toy is being operated.
• When not in use, turn OFF the vehicle. To avoid accidental operation, remove all batteries.
NOTE TO ADULTS: To ensure that your child’s play is both safe and fun, please review all operating instructions and safety rules together.
Please keep these instructions for future reference as they contain important information.
JEEP® WRANGLER RAPTOR ATTACK RC
INSTRUCTIONS
CONTENTS
REQUIRES 8 AA (LR6) ALKALINE BATTERIES, NOT INCLUDED. DISPOSE OF BATTERIES SAFELY.
CAUTION:
To prevent entanglement, keep all hair
away from the wheels.
1:
QUICK TIPS
6:
3:
4:
NOTE: If the vehicle goes into sleep mode after sitting idle, slide the power switch to OFF then ON again to wake up the vehicle and resume normal play.
TO PLAY (RAPTOR ATTACK MODE)
5:
©2017 Mattel. ® and ™ designate U.S. trademarks of Mattel, except as noted. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Services 1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park,
Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty., Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. Mattel South Africa (PTY) LTD, Office 102 I3, 30 Melrose Boulevard, Johannesburg
2196. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre, Harbour City, Tsimshatsui, HK, China. Tel.: (852) 3185-6500. Diimport & Diedarkan Oleh: Mattel Southeast Asia Pte. Ltd. , No 19-1, Tower 3 Avenue
7, Bangsar South City, No 8, Jalan Kerinchi, 59200 Kuala Lumpur, Malaysia. Tel: 03-33419052.
2.4
GHz
Jurassic World is a trademark and copyright of Universal Studios and Amblin Entertainment, Inc. Licensed by Universal Studios. All Rights Reserved.
6+
INSTRUCTION SHEET
SPECIFICATIONS
Toy:
Toy No.:
Part No.:
Trim Size:
Folded Size:
Type of Fold:
# colors:
Colors:
Paper Stock:
Paper Weight:
EDM No.:
FNH12
0970
A3
A4
Black
White Offset
70 lb.